A. Dual stack
B. NAT
C. Flow label
D. Mobile IP
E. 6to4 tunneling
F. Anycast
G. MBGP
第1题:
A. statically map IPV4 address to IPV6 addresses
B. configuration IPv4 tunnels between IPV6 islands
C. use DHCPv6 to map IPV4 addresses to IPV6 addresses
D. use proxying and translation to translate IPV6 packets into IPV4 packets
E. configure IPV6 directly
F. enable dual-stack routing
第2题:
Which two statements are true about using IPv4 and IPv6 simultaneously on a network segment? ()
第3题:
A Company is using 6to4 tunnels in their IPv6 network. Which two statements are true about thesetunnels?()
第4题:
the network administrator has been asked to give reasons for moving from ipv4 to ipv6. what are two valid reasons for adopting ipv6 over ipv4?()
第5题:
Company network is implemting IPv6 into their existing IPv4 netwrok. Which statement is trueabout incorporating IPv6 into an already existing IPv4 network?()
第6题:
Your company plans on migrating their network from IPv4 to IPv6 in the near future. Which three techniques can be used to transition from IPv4 to IPv6?()
第7题:
IPv6 allows a host to create its own IPv6 address that will allow it to communicate to other devices on a network configured via DHCP. IPv4 does not provide a similar capability for hosts.
IPv6 provides for more host IP addresses but IPv4 provides for more network addresses.
Hosts can be configured to receive both IPv4 and IPv6 addresses via DHCP.
Host configuration options for IPv4 can be either statically assigned or assigned via DHCP.Host configuration options for IPv6 can be statically assigned only.
IPv4 and IPv6 addresses c an be simultaneously assigned to a host but not to a router interface.
第8题:
Only OSPF version 3 can be utilized for routing IPv4 and IPv6
IPv4 and IPv6 networks can be routed simultaneously
IPv6 can be routed using the same routing protocol versions as IPv4
A router routing for IPv6 and IPv4 must convert IPv4 packets to IPv6 packets to route them
None of the other alternatives apply
第9题:
telnet access does not require a password
nat
no broadcast
chanage of destination address in the ipv6 header
chanage of source address in the ipv6 header
autoconfiguration
第10题:
Tunnel IPv6 over IPv4 to connect far-end IPv6 networks.
Explain why configuring IPv4 and IPv6 at the same time over the same LAN interface is not possible.
Explain why configuring IPv4 and IPv6 at the same time over the same LAN interface is possible.
What is the meaning of EUI-64 and how does it work?
Tunnel IPv4 over IPv6 to connect far-end IPv4 networks.
第11题:
Dual stack
NAT
Flow label
Mobile IP
6to4 tunneling
Anycast
MBGP
第12题:
Create an IPv4 tunnel and assign the tunnel IPv6 addresses
Create IPv4 interfaces on both ends of the network, and use either static routes or a routingprocess to direct IPv6 packets through those interfaces
IPv6 packets cannot be encapsulated with IPv4 headers because the addresses are notcompatible
Create IFV6 interfaces on both ends of the network, and use static routes to point the IPv4address to those interfaces
Use an IPv6 routing protocol like OSPFv3 and assign IPv4 packets to that process
Create an IPv4 tunnel and use the tunnel mode ipv6ip command
第13题:
IPv6 is short for "Internet Protocol Version 6". IPv6 is the "next generation" protocol designed by the IETF to(71) the current version Internet Protocol, IP version 4("IPv4").
Most of today's internet uses IPv4, which is now more than twenty years old. IPv4 has been(72) resilient in spite of its age, but it is beginning to have problems. Most importantly, there is a growing(73) of IPv4 addresses, which are needed by all new machines added to the Internet. IPv6 fixes a number of problems in IPv4, such as the(74) number of available IPv4 addresses. It also adds many improvements to IPv4 in areas such as routing and network autoconfiguration. IPv6 is expected to gradually replace IPv4, with the two coexisting for a number of years during a transition(75) .
A.substitution
B.swap
C.switchover
D.replace
第14题:
Which statement describes the difference between a manually configured IPv6 in IPv4 tunnel versus an automatic 6to4 tunnel?()
第15题:
Which of the following solutions will encapsulate IPv6 packets with IPv4 headers?()
第16题:
Your company is researching a new application that runs over IPv6, but part of it must still have IPv4 support. Your company uses a traditional IPv4 network. Your plan is not to run IPv6 over the whole network, but to segment parts of the network or even to operate simultaneously with IPv6 and IPv4. You must make a brief presentation about IPv6 technology to the board of technical directors. Which three of these items could be part of your presentation? ()
第17题:
Which three approaches can be used while migrating from an IPV4 addressing scheme to an IPV6 scheme?()
第18题:
Tunnel IPv6 over IPv4 to connect far-end IPv6 networks
Explain why configuring IPv4 and IPv6 at the same time over the same LAN interface is not possible
Explain why configuring IPv4 and IPv6 at the same time over the same LAN interface is possible
What is the meaning of EUI-64 and how does it work?
Tunnel IPv4 over IPv6 to connect far-end IPv4 networks.
第19题:
Native IPv6
Point - to -point tunnels
Multipoint tunnels
NAT - PT
第20题:
Overlay tunnels can only be configured between border routers capable of supporting IPv4 and IPv6.
An manual overlay tunnel supports point - to - multipo int tunnels capable of carrying IPv6 and Connectionless Network Service (CLNS) packets.
Overlay tunneling encapsulates IPv6 packets in IPv4 packets for delivery across an IPv4 infrastructure.
Overlay tunnels can be configured between border route rs or between a border router and a host capable of supporting IPv4 and IPv6.
Cisco IOS supports manual, generic routing encapsulation (GRE), IPv4 - compatible, 6to4, and Intra - Site Automatic Tunnel Addressing Protocol (ISATAP) overlay tunneling mechan isms.
Cisco IOS supports manual, generic routing encapsulation (GRE), IPv6 - compatible, 4to6, and Multiprotocol Label Switching (MPLS) overlay tunneling mechanisms.
第21题:
statically map IPV4 address to IPV6 addresses
configuration IPv4 tunnels between IPV6 islands
use DHCPv6 to map IPV4 addresses to IPV6 addresses
use proxying and translation to translate IPV6 packets into IPV4 packets
configure IPV6 directly
enable dual-stack routing
第22题:
6to4
6over4
ISATAP
GRE
第23题:
full mesh
peer-to-peer
partial mesh
hub and spoke