A.::1
B.::
C.2000::/3
D.0::/10
第1题:
A. The IP address of the first Fast Ethernet interface.
B. The IP address of the console management interface.
C. The highest IP address among its active interfaces.
D. The lowest IP address among its active interfaces.
E. There will be no router ID until a loopback interface is configured.
第2题:
A. There are four types of IPv6 addresses: unicast, multicast, anycast, and broadcast.
B. A single interface may be assigned multiple IPv6 addresses of any type.
C. Every IPv6 interface contains at least one loopback address.
D. The first 64 bits represent the dynamically created interface ID.
E. Leading zeros in an IPv6 16 bit hexadecimal field are mandatory.
第3题:
A.::1
B.::
C.2000::/3
D.0::/10
第4题:
On the assumption that every OSPF router in a particular area is configured with there is no loopback interface set?()
第5题:
The network administrator has asked you to check the status of the workstation’s IP stack by pinging the loopback address.Which address would you ping to perform this task?()
第6题:
In JUNOS software, which statement is true regarding the OSPF advertisement of the loopback IP address on the ABR?()
第7题:
The following configura tion exists on a router on one end of an IPv6 tunnel. Which type of tunnel is created by this configuration?() interface loopback 1 ip address 1.1.1.1 255.255.255.255 interface tunnel 2 ipv6 address 2000::1::/64 tunnel source loopback 1 tunnel destina tion 2.2.2.2 tunnel mode ipv6ip ipv6 eigrp 1
第8题:
Which two of these statements are true of IPv6 address representation?()
第9题:
In a cluster using /etc/hosts for name resolution, which of the following describes the minimum requirementsfor the /etc/hosts file?()
第10题:
Which two statements are true about the primary address on an interface? ()
第11题:
It is the address used by default as the local address for broadcast and multicast packets sourced locally and sent out of the interface.
You use the primary address when you have multiple IP addresses belonging to the same subnet on the same interface.
It can be useful for selecting the local address used for packets sent out of unnumbered interfaces when multiple non-127 addresses are configured on the loopback interface.
By default, the primary address on an interface is selected as the numerically highest local address configured on the interface.
第12题:
In a 6to4 tunnel, the first two bytes of the IPv6 address will be 0x2002 and the next four byteswill be the hexadecimal equivalent of the IPv4 address
In a 6to4 tunnel, the IPv4 address 192.168.99.1 would be converted to the2002:1315:4463:1::/64 IPv6 address
In a 6to4 tunnel, the IPv4 address 192.168.99.1 would be converted to the 2002:c0a8:6301::/48IPv6 address
In a 6to4 tunnel, the first two bytes of the IPv6 address will be locally derived and the next twobytes will be the hexadecimal equivalent of the IPv4 address
In a 6to4 tunnel, the IPv4 address 192.168.99.1 would be converted to the 2002:c0a8:6301::/16IPv6 address
第13题:
A.10.1.1.1
B.127.0.0.1
C.192.168.0.1
D.239.1.1.1
第14题:
A. Global addresses start with 2000::/3.
B. Link-local addresses start with FE00:/12.
C. Link-local addresses start with FF00::/10.
D. There is only one loopback address and it is ::1.
E. If a global address is assigned to an interface, then that is the only allowable address for the interface.
第15题:
A.There are four types of IPv6 addresses: unicast, multicast, anycast, and broadcast.
B.A single interface may be assigned multiple IPv6 addresses of any type.
C.Every IPv6 interface contains at least one loopback address.
D.The first 64 bits represent the dynamically created interface ID.
E.Leading zeros in an IPv6 16 bit hexadecimal field are mandatory.
第16题:
Which IPv6 address is the equivalent of the IPv4 interface loopback address 127.0.0.1?()
第17题:
A Company is using 6to4 tunnels in their IPv6 network. Which two statements are true about thesetunnels?()
第18题:
Which two steps are needed when configuring multiple RPs using MSDP within a single PIM domain? ()
第19题:
Which two statements describe characteristics of IPv6 unicast addressing?()
第20题:
Which of the following is the IPv6 loopback address?()
第21题:
Which two statements are true about the primary address on an interface?()
第22题:
::1
1.1.1.1
127.0.0.1
255.255.255.254
第23题:
::1
::
2000::/3
0::/10