A.Router1 has specific boot system command that instruct it to load IOS from TFTP server.
B.Router1 is acting as a TFTP server for other routers.
C.Router1 cannot locate a valid IOS image in flash memory.
D.Router1 defaulted to ROMMON mode and loaded the IOS image from a TFTP server.
E.Cisco routers will first attempt to load a image from TFTP for management purposes.
第1题:
A. Router RTA is the BDR
B. Router RTA is directly connected to interface 192.168.45.1
C. Neighbor 192.168.45.1 has changed its OSPF priority number
D. Router RTA and neighbor 192.168.45.2 are exchanging OSPF LSAs
第2题:
Refer to the exhibit:The technician wants to upload a new IOS in the router while keeping the existing IOS. What is the maximum size of an IOS file that could be loaded if the original IOS is also kept in flash?()
A.3MB
B.4MB
C.5MB
D.7MB
E.8MB
第3题:
A Cisco router is booting and has just completed the POST process. It is now ready to find and load an IOS image. What function does the router perform next?()
第4题:
What are two requirements to perform a warm Cisco IOS upgrade on a Cisco ISR router? ()(Choose two.)
第5题:
Refer to the exhibit. The DHCP configuration that is shown is configured on a Cisco router. Whichstatement is true?()
第6题:
Refer to the exhibit. For what two reasons has the router loaded its IOS image from the location that is shown? ()
第7题:
3MB
4MB
5MB
7MB
8MB
第8题:
Router1 has specific boot system command that instruct it to load IOS from TFTP server.
Router1 is acting as a TFTP server for other routers.
Router1 cannot locate a valid IOS image in flash memory.
Router1 defaulted to ROMMON mode and loaded the IOS image from a TFTP server.
Cisco routers will first attempt to load a image from TFTP for management purposes.
第9题:
at least one enabled Ethernet interface
Cisco IOS version 12.3(2)T or greater
enough memory to decompress the new Cisco IOS image
internal flash memory equaling two times the space required for the current Cisco IOS image
第10题:
It checks the configuration register
It attempts to boot from a TFTP server
It loads the first image file in flash memory
It inspects the configuration file in NVRAM for boot instructions
第11题:
The new IOS image is too large for the router flash memory.
The TFTP server is unreachable from the router.
The new IOS image is not correct for this router platform.
The IOS image on the TFTP server is corrupt.
There is not enough disk space on the TFTP server for the IOS image.
第12题:
The network administrator faled to save the configuration.
The configuration register is set to 0x2100.
The boot system flash command is missing from the configuration.
The configuraiton register is set to 0x2102.
The router is configured with the boot system startup command.
第13题:
Refer to the exhibit. The two exhibit devices are the only Cisco devices on the network. The serial network between the two devices has a mask of 255.255.255.252. Given the output that is shown, what three statements are true of these devices? ()
A.The Manchester serial address is 10.1.1.1
B.The Manchester serial address is 10.1.1.2
C.这个Manchester路由器串口地址为:10.1.12
D.The London router is a Cisco 2610.
E.The Manchester router is a Cisco 2610.
F.The CDP information was received on port Serial0/0 of the Manchester router.
G.The CDP information was sent by port Serial0/0 of the London Router.
第14题:
When upgrading the IOS image, the network administrator receives the exhibited error message. What could be the cause of this error?()
第15题:
You are upgrading your Cisco router IOS from a TFTP server over the network. The upgrade procedure is stopped and you are prompted to erase the current flash contents before continuing. What is most plausible reason for this? ()
第16题:
A cisco router is booting and has just completed the POST process.It is now ready to find and load an IOS image.what function does the router perform next?()
第17题:
What is the purpose of the secure boot-config global configuration ?()
第18题:
10.1.1.2
10.154.154.1
172.16.5.1
192.168.5.3
第19题:
There is insufficient room for more than one image.
The router has detected a copy of the current software image on the TFTP server.
The file can be relocated and not compressed.
The image to load is a binary executable file.
第20题:
It checks the configuration register.
It attempts to boot from a TFTP server.
It loads the first image file in flash memory.
It inspects the configuration file in NVRAM for boot instructions.
第21题:
The Cisco IOS image file will not be visible in the output from the show flash command.
The show version command will not show the Cisco IOS image file location.
When the router boots up, the Cisco IOS image will be loaded from a secured FTP location.
The running Cisco IOS image will be encrypted and then automatically backed up to a TFTP server.
第22题:
The router will distribute IP addresses from pool 1 until its addresses are exhausted. Then therouter will begin distributing addresses from pool 2
The configuration is invalid because the DHCP options are global configuration commands
The configuration is incomplete until the DHCP pools are bound to the appropriate interface orinterfaces
The router will choose which pool to use based upon the interface the DHCP request wasreceived on
第23题:
The DHCP pool needs to have an import all statement.
The DHCP pool is missing an option 150 ip 10.59.138.1 statement.
The DHCP pool is missing an option 139 ip 10.59.138.1 statement
The DHCP pool is missing a dns-server 10.59.138.1 statement.