Refer to the exhibit. At the end of an RSTP election process, which access layer switch port will assume the discarding role?()A.Switch3, port fa0/1B.Switch3, port fa0/12C.Switch4, port fa0/11D.Switch4, port fa0/2E.Switch3, port Gi0/1F.Switch3, port Gi0/2

题目
Refer to the exhibit. At the end of an RSTP election process, which access layer switch port will assume the discarding role?()

A.Switch3, port fa0/1

B.Switch3, port fa0/12

C.Switch4, port fa0/11

D.Switch4, port fa0/2

E.Switch3, port Gi0/1

F.Switch3, port Gi0/2


相似考题
参考答案和解析
参考答案:C
更多“Refer to the exhibit. At the end of an RSTP election process, which access layer switch port will assume the discarding role?() ”相关问题
  • 第1题:

    Refer to the exhibit. Which of these statements correctly describes the state of the switch once the boot process has been completed?()

    A.As FastEthernet0/12 will be the last to come up, it will not be blocked by STP.

    B.Remote access management of this switch will not be possible without configuration change.

    C.More VLANs will need to be created for this switch.

    D.The switch will need a different IOS code in order to support VLANs and STP.


    参考答案:B

  • 第2题:

    Refer to the exhibit. Given the output shown from this Cisco Catalyst 2950, what is the most likely reason that interface FastEthernet 0/10 is not the root port for VLAN 2?()

    A.This switch has more than one interface connected to the root network segment in VLAN 2.

    B.This switch is running RSTP while the elected designated switch is running 802.1d Spanning Tree.

    C.This switch interface has a higher path cost to the root bridge than another in the topology.

    D.This switch has a lower bridge ID for VLAN 2 than the elected designated switch.


    参考答案:C

  • 第3题:

    Refer to the diagram. Which three statements describe the router port configuration and the switch port configuration as shown in the topology? ()

    A.The Router1 WAN port is configured as a trunking port.

    B.The Router1 port connected to Switch1 is configured using subinterfaces.

    C.The Router1 port connected to Switch1 is configured as 10 Mbps.

    D.The Switch1 port connected to Router1 is configured as a trunking port.

    E.The Switch1 port connected to Host B is configured as an access port.

    F.The Switch1 port connected to Hub1 is configured as full duplex.


    参考答案:B, D, E

  • 第4题:

    When creating a role in a Cisco Nexus 7000 Series Switch, rules are used to define the type of operations that a role will allow the user to perform.  Which two of these parameters cannot be applied as a rule? () 

    • A、 port-profile
    • B、 command
    • C、 access-list
    • D、 feature-group
    • E、 OID

    正确答案:A,C

  • 第5题:

    Which two of the following statements describe a routed switch port on a multilayer switch?()

    • A、Layer 2 switching and Layer 3 routing are mutually supported.
    • B、The port will not be associated with any VLAN.
    • C、The routed switch port supports VLAN subinterfaces.
    • D、The routed switch port is used when a switch has only one port per VLAN or subnet.
    • E、The routed switch port ensures that STP remains in the forwarding state.

    正确答案:B,D

  • 第6题:

    Refer to the exhibit. The output that is shown is generated at a switch. Which three of these statements are true? ()

    • A、All ports will be in a state of discarding, learning, or forwarding.
    • B、Thirty VLANs have been configured on this switch.
    • C、The bridge priority is lower than the default value for spanning tree.
    • D、All interfaces that are shown are on shared media.
    • E、All designated ports are in a forwarding state.
    • F、The switch must be the root bridge for all VLANs on this switch.

    正确答案:A,C,E

  • 第7题:

    Which three statements about RSTP are true?()

    • A、RSTP significantly reduces topology reconverging time after a link failure.
    • B、RSTP expends the STP port roles by adding the alternate and backup roles.
    • C、RSTP port states are blocking,discarding,learing,or forwarding.
    • D、RSTP also uses the STP proprsal-agreement sequence.
    • E、RSTP use the same timer-baseed process as STP on point-to-point links.
    • F、RSTP provides a faster transition to the forwarding state on point-to-point links than STP does.

    正确答案:A,B,F

  • 第8题:

    Which statement is correct about RSTP port roles?()

    • A、The designated port is the switch port on every nonroot bridge that is the chosen path to theroot bridge. There can be only one designated port on every switch. The designated portassumes the forwarding state in a stable active topology. All switches connected to a given segment listen to all BPDUs and determine the switch that will be the root switch for a particular segment.
    • B、The disabled port is an additional switch port on the designated switch with a redundant link to the segment for which the switch is designated. A disabled port has a higher port ID than the disabled port on the designated switch. The disabled port assumes the discarding state in astable active topology.
    • C、The backup port is a switch port that offers an alternate path toward the root bridge. The backup port assumes a discarding state in a stable, active topology. The backup port will be present on nondesignated switches and will make a transition to a designated port if the current designated path fails.
    • D、The root port is the switch port on every nonroot bridge that is the chosen path to the root bridge. There can be only one root port on every switch. The root port assumes the forwarding state in a stable active topology.

    正确答案:D

  • 第9题:

    单选题
    Refer to the exhibit. At the end of an RSTP election process, which access layer switch port will assume the discarding role?()
    A

    Switch3, port fa0/1

    B

    Switch3, port fa0/12

    C

    Switch4, port fa0/11

    D

    Switch4, port fa0/2

    E

    Switch3, port Gi0/1

    F

    Switch3, port Gi0/2


    正确答案: F
    解析: 暂无解析

  • 第10题:

    单选题
    Which statement is correct about RSTP port roles?()
    A

    The designated port is the switch port on every nonroot bridge that is the chosen path to theroot bridge. There can be only one designated port on every switch. The designated portassumes the forwarding state in a stable active topology. All switches connected to a given segment listen to all BPDUs and determine the switch that will be the root switch for a particular segment.

    B

    The disabled port is an additional switch port on the designated switch with a redundant link to the segment for which the switch is designated. A disabled port has a higher port ID than the disabled port on the designated switch. The disabled port assumes the discarding state in astable active topology.

    C

    The backup port is a switch port that offers an alternate path toward the root bridge. The backup port assumes a discarding state in a stable, active topology. The backup port will be present on nondesignated switches and will make a transition to a designated port if the current designated path fails.

    D

    The root port is the switch port on every nonroot bridge that is the chosen path to the root bridge. There can be only one root port on every switch. The root port assumes the forwarding state in a stable active topology.


    正确答案: B
    解析: 暂无解析

  • 第11题:

    多选题
    Refer to the exhibit. The two connected ports on the switch are not turning orange or green. What would be the most effective steps to troubleshoot this physical layer problem?()
    A

    Ensure that the Ethernet encapsulations match on the interconnected router and switch ports.

    B

    Ensure that cables A and B are straight-through cables.

    C

    Ensure cable A is plugged into a trunk port.

    D

    Ensure the switch has power.

    E

    Reboot all of the devices.

    F

    Reseat all cables.


    正确答案: C,F
    解析: 暂无解析

  • 第12题:

    单选题
    Which command alone will disable trunking on a Layer 2 switch port?()
    A

    no switchport trunk native vlan vlan-id

    B

    switchport nonegotiate

    C

    no switchport mode dynamic desirable

    D

    switchport mode access


    正确答案: B
    解析: 暂无解析

  • 第13题:

    Refer to the exhibit. What switch proves the spanning-tree designated port role for the network segment that services the printers?()

    A.Switch1

    B.Switch2

    C.Switch3

    D.Switch4


    参考答案:C

  • 第14题:

    Which set of commands is recommended to prevent the use of a hub in the access layer?()

    A.switch(config-if)#switchport mode trunk switch(config-if)#switchport port-security maximum 1

    B.switch(config-if)#switchport mode trunk switch(config-if)#switchport port-security mac-address 1

    C.switch(config-if)#switchport mode access switch(config-if)#switchport port-security maximum 1

    D.switch(config-if)#switchport mode access switch(config-if)#switchport port-security mac-address 1


    参考答案:C

  • 第15题:

    Which set of commands is recommended to prevent the use of a hub in the access layer?()

    • A、switch(config-if)#switchport mode trunk switch(config-if)#switchport port-security maximum 1
    • B、switch(config-if)#switchport mode trunk switch(config-if)#switchport port-security mac-address 1
    • C、switch(config-if)#switchport mode access switch(config-if)#switchport port-security maximum 1
    • D、switch(config-if)#switchport mode access switch(config-if)#switchport port-security mac-address 1

    正确答案:C

  • 第16题:

    During voice implementation,  which two required items are configured at an access layer switch connected to an IP phone to provide VoIP communication?()

    • A、allowed codecs
    • B、native VLAN
    • C、auxiliary VLAN
    • D、Cisco Unified Communications Manager IP address
    • E、RSTP

    正确答案:B,C

  • 第17题:

    Refer to the exhibit. The two connected ports on the switch are not turning orange or green. What would be the most effective steps to troubleshoot this physical layer problem?()

    • A、Ensure that the Ethernet encapsulations match on the interconnected router and switch ports.
    • B、Ensure that cables A and B are straight-through cables.
    • C、Ensure cable A is plugged into a trunk port.
    • D、Ensure the switch has power.
    • E、Reboot all of the devices.
    • F、Reseat all cables.

    正确答案:B,D,F

  • 第18题:

    Which three statements about RSTP aretrue?()

    • A、RSTP significantly reduces topology reconverging time after a link failure.
    • B、RSTP expends the STP port roles by adding the alternate and backup roles.
    • C、RSTP portatates are blocking,discarding,learing,orforwarding.
    • D、RSTP also uses the STP proprsal-agreement sequence.
    • E、RSTP use the same timer-baseed process as STP on point-to-point links.
    • F、RSTP provides a faster transition to the forwarding state on point-to-point links than STP does.

    正确答案:A,B,F

  • 第19题:

    Which command alone will disable trunking on a Layer 2 switch port?()

    • A、no switchport trunk native vlan vlan-id
    • B、switchport nonegotiate
    • C、no switchport mode dynamic desirable
    • D、switchport mode access

    正确答案:D

  • 第20题:

    单选题
    Refer to the exhibit. An administrator pings the default gateway at 10.10.10.1 and sees the output as shown. At which OSI layer is the problem?()
    A

    data link layer

    B

    application layer

    C

    access layer

    D

    session layer

    E

    network layer


    正确答案: E
    解析: 暂无解析

  • 第21题:

    单选题
    Refer to the exhibit. Which of these statements correctly describes the state of the switch once the boot process has been completed?()
    A

    As FastEthernet0/12 will be the last to come up, it will not be blocked by STP.

    B

    Remote access management of this switch will not be possible without configuration change.

    C

    More VLANs will need to be created for this switch.

    D

    The switch will need a different IOS code in order to support VLANs and STP.


    正确答案: B
    解析: 暂无解析

  • 第22题:

    单选题
    Refer to the exhibit. What switch proves the spanning-tree designated port role for the network segment that services the printers?()
    A

    Switch1

    B

    Switch2

    C

    Switch3

    D

    Switch4


    正确答案: A
    解析: 暂无解析

  • 第23题:

    单选题
    Which set of commands is recommended to prevent the use of a hub in the access layer?()
    A

    switch(config-if)#switchport mode trunk switch(config-if)#switchport port-security maximum 1

    B

    switch(config-if)#switchport mode trunk switch(config-if)#switchport port-security mac-address 1

    C

    switch(config-if)#switchport mode access switch(config-if)#switchport port-security maximum 1

    D

    switch(config-if)#switchport mode access switch(config-if)#switchport port-security mac-address 1


    正确答案: C
    解析: 暂无解析