当前分类： JN0-311
问题：单选题Which statement is true regarding SMB signing and AppFlow CIFS acceleration?（）A SMB signing is transparent to application performance.B It is possible to perform CIFS acceleration when SMB signing is on.C SMB assigns hash values to the packet, allowing...
查看答案
问题：多选题Which two functions are performed in Quick Setup?（） (Choose two.)Aoperating modeBauto-deploymentCspeed and duplex settingsDregistration server designation...
问题：多选题When defining an application for AppFlow acceleration, which two must be configured on the WX device?（）(Choose two.)ADefine application type.BEnable AppFlow for the application.CEnable monitoring for the application.DDefine source and destination IP ad...
问题：单选题What is one way to escape hardware bypass mode?（）A Reset the cabling.B Power cycle the device.C Bounce the service tunnels.D Unlock the device from the console....
问题：多选题Which two configurations are made using the QoS Setup Wizard? （）(Choose two.)AAssign applications to traffic classes.BUse ToS/DSCP values for traffic classes.CExclude subnets from QoS management.DSelect dedicated vs. over-subscribed circuits....
问题：多选题Which three statistics does the Executive report summarize?（） (Choose three.)Alatency and lossBcompression resultsCtraffic (by application)DCRC and alignment errorsEuser access (by username)...
问题：多选题Which two metrics does the Executive report summarize? （）(Choose two.)AQoS statisticsBWAN performanceCacceleration statisticsDcompression statistics...
问题：单选题Why is SNMPv2 used to monitor the WX platform?（）A SNMPv1 is read-only on WX devices.B SNMPv1 is not supported by WX devices.C SNMPv2 supports both 32- and 64-bit counters.D SNMPv2 does put and get commands to WX devices....
问题：单选题Which statement is true about compression subnets?（）A Compression subnets are turned on by default.B Compression subnets advertise remote routes.C Compression subnets are usually LAN-side subnets.D Compression subnets are usually WAN-side subnets....
问题：多选题Which three ports does a WX device use for control traffic purposes?（） (Choose three.)A3577 UDPB3578 UDPC3678 UDPD3577 TCPE3578 TCP...
问题：多选题What are three key pre-installation/configuration considerations when deploying a WX device?（） (Choose three.)AcablingBcommunity topologyCrequires a license keyDrequires two IP addressesEregistration server designation...
问题：多选题What happens when you enable QoS bandwidth detection? （）(Choose two.)ACircuit speed is reduced by 2% for overhead.BWAN speed can be configured to the LAN speed.CBandwidth is adjusted based on minimum and maximum settingsDWAN bandwidth is detected based...
问题：多选题Exchange acceleration is not working. Which three steps should you use to troubleshoot the problem? （）(Choose three.)ADetermine if CIFS acceleration is enabled.BDetermine if TCP Acceleration (AFP) is enabled.CDetermine if Forward Error Correction is en...
问题：单选题How do you verify connectivity between the default gateway and a WX device?（）A Check the WX device remote interface and verify that the status is up.B From the WX device, ping the default gateway to make sure it is reachable.C In WebView, check the ser...
问题：多选题Which three RIP features are supported on the WX or WXC device? （）(Choose three.)ASHA-1BMD5 authenticationCversion 1 messagesDversion 2 messagesEplain-text authentication...
问题：多选题What are two instances when a WX device route carves? （）(Choose two.)AIt occurs every 29 hours.BPacket interception mode is enabled.CThe host is unreachable on the local subnet.DThe subnet is unreachable using the advertised router....
问题：单选题Click the Exhibit button. When configuring WXC A's local WAN parameters, which QoS network parameter would you choose?（）A over-subscribedB under-subscribedC dedicated circuitsD nondedicated circuits...
问题：多选题Which two CIFS commands are accelerated by AppFlow? （）(Choose two.)AReadXBWrite AndXCTrans2 QueryDTree Disconnect...
问题：多选题Which three types of optimization does the WX 60 device perform when Exchange 2000 and Outlook 2000 are used in the network? （）(Choose three.)AFast Connection SetupBTCP Acceleration (AFP)CNetwork Sequence CachingDAppFlow's MAPI accelerationEMolecular S...
问题：多选题What are two requirements when using AppFlow? （）(Choose two.)AQuality of service must be enabled.BNSC compression must be enabled.CPFA's TCP Acceleration (AFP) must be enabled.DAppFlow must be configured on the client-side device first...
