单选题Which configuration command sets the MPLS interface bandwidth to 15 Mbps?（）A set bandwidth 15B mpls bandwidth 15C set bandwidth 15000D mpls bandwidth 15000

题目
单选题
Which configuration command sets the MPLS interface bandwidth to 15 Mbps?（）
A

set bandwidth 15

B

mpls bandwidth 15

C

set bandwidth 15000

D

mpls bandwidth 15000

相似考题

1.Which configuration command sets the MPLS interface bandwidth to 15 Mbps?()A. set bandwidth 15B. mpls bandwidth 15C. set bandwidth 15000D. mpls bandwidth 15000

2.You are working as an administrator at TestKing, and you need to set the bandwidth of your routers serial port to 56K. Which of the following commands would you use?()A. Bandwidth 56000B. Bandwidth 56000000C. Bandwidth 56D. Bandwidth 56kbps

3.If the bandwidth of an OSPF interface is configured with the "bandwidth 64"command, what would be the calculated cost of the link?()A. 1B. 64C. 1562D. 64000E. 1500

4.Refer to the exhibit. What must be done on router RTA to ensure that EIGRP works effectively in a Frame Relay multipoint environment?()A. Issue the command bandwidth 224 on the physical interface.B. Issue the command bandwidth 56 on the physical interface.C. Issue the command bandwidth 224 on each subinterface.D. Issue the command bandwidth 56 on each subinterface.

更多“单选题Which configuration command sets the MPLS interface bandwidth to 15 Mbps?（）A set bandwidth 15B mpls bandwidth 15C set bandwidth 15000D mpls bandwidth 15000”相关问题

  • 第1题：

    Which parameter or parameters are used to calculate OSPF cost in cisco routers?()

    A. Bandwidth,Delay,and MTU

    B. Bandwidth

    C. Bandwidth and MTU

    D. Bandwidth , MTU,Reliability,Delay,and Load


    参考答案：B

  • 第2题：

    If the bandwidth of an OSPF interface is configured with the "bandwidth 64"command, what would be the calculated cost of the link?（）

    • A、1
    • B、64
    • C、1562
    • D、64000
    • E、1500

    正确答案:C

  • 第3题：

    For defining the QoS policies for each traffic class， which parameters should be identified？ （）

    • A、minimum bandwidth guarantee
    • B、average bandwidth guarantee
    • C、optimum bandwidth guarantee
    • D、maximum bandwidth rate
    • E、IP precedence F priority

    正确答案:A,D,F

  • 第4题：

    What are two steps to define a QoS policy？（）

    • A、set a minimum bandwidth guarantee
    • B、increase bandwidth
    • C、determine a specific transfer rate
    • D、establish timers
    • E、configure CBWFQ for best-effort traffic
    • F、set a maximum bandwidth limit

    正确答案:A,F

  • 第5题：

    Which parameter or parameters are used to calculate OSPF cost in cisco routers？（）

    • A、Bandwidth，Delay，and MTUB
    • B、andwidth
    • C、Bandwidth and MTU
    • D、Bandwidth，MTU，Reliability，Delay，and Load

    正确答案:B

  • 第6题：

    When using WMM Call Admission Control， what are the default bandwidth values for video on802.11a/n（）？

    • A、Max RF bandwidth is 75 percent， reserved roaming bandwidth is 6 percent.
    • B、Max RF bandwidth is 50 percent， reserved roaming bandwidth is 10 percent.
    • C、Max RF bandwidth is 50 percent， reserved roaming bandwidth is 15 percent.
    • D、Max RF bandwidth is 0 percent， reserved roaming bandwidth is 0.

    正确答案:D

  • 第7题：

    A 2-way interleaved DDR configuration and a 4-way interleaved SDRAM configuration will produce which of the following？（）

    • A、They will have the same memory bandwidth.
    • B、2-way will provide higher memory bandwidth than 4-way.
    • C、4-way will provide higher memory bandwidth than 2-way.
    • D、4-way will provide higher memory bandwidth but only on an x445.

    正确答案:A

  • 第8题：

    Which two commands would change the default OSPF metric calculation for interface ge-0/3/0 inJUNOS software?（）

    • A、set interfaces ge-0/3/0 unit 0 metric 10
    • B、set protocols ospf reference-bandwidth 10g
    • C、set interfaces ge-0/3/0 unit 0 bandwidth 10g
    • D、set protocols ospf area 0 interface ge-0/3/0 metric 10
    • E、set protocols ospf area 0 interface ge-0/3/0 bandwidth 10g

    正确答案:B,D

  • 第9题：

    单选题
    What is the command to configure RSVP to reserve up to one-tenth of a Gigabit link，but only allow eachindividual flow to use 1 MB/s？（）
    A

    ip rsvp bandwidth 100000 1000

    B

    ip rsvp bandwidth 100000 1

    C

    ip rsvp bandwidth 10 1

    D

    ip rsvp bandwidth 1000000 1000


    正确答案： B
    解析： 暂无解析

  • 第10题：

    单选题
    You are troubleshooting a problem with a Cisco 7920 wireless IP phone that is causing the phoneto drop calls. The problem appears to be a roaming bandwidth issue. In order to verify what kindof issue it is， you decide to increase the bandwidth reserved for roaming on the WLAN controllerto the maximum. What level do you set the bandwidth to？（）
    A

    25 percent

    B

    15 percent

    C

    5 percent

    D

    35 percent


    正确答案： A
    解析： 暂无解析

  • 第11题：

    单选题
    If the bandwidth of an OSPF interface is configured with the "bandwidth 64"command, what would be the calculated cost of the link?（）
    A

    1

    B

    64

    C

    1562

    D

    64000

    E

    1500


    正确答案： D
    解析： 暂无解析

  • 第12题：

    单选题
    When using WMM Call Admission Control， what are the default bandwidth values for video on802.11a/n（）？
    A

    Max RF bandwidth is 75 percent， reserved roaming bandwidth is 6 percent.

    B

    Max RF bandwidth is 50 percent， reserved roaming bandwidth is 10 percent.

    C

    Max RF bandwidth is 50 percent， reserved roaming bandwidth is 15 percent.

    D

    Max RF bandwidth is 0 percent， reserved roaming bandwidth is 0.


    正确答案： C
    解析： 暂无解析

  • 第13题：

    When Cisco SDM is used to generate QoS policy， various QoS classes will be created and assigned a percentage of the interface bandwidth. Which three statements indicate the default bandwidth values that are assigned by SDM for outgoing traffic on a WAN interface？ （）

    • A、 Voice traffic will be assigned 47% of the interface bandwidth.
    • B、 Voice call signaling will be assigned 33% of the interface bandwidth.
    • C、 Telnet， SSH， and other traffic that is generated to manage the router is assigned 5% of the interface bandwidth.
    • D、 Best-effort traffic will be assigned 38% of the interface bandwidth.
    • E、 Routing protocol traffic will be assigned 5% of the interface bandwidth.
    • F、 Transactional traffic will be assigned 5% of the interface bandwidth.

    正确答案:C,E,F

  • 第14题：

    In Multicast VPN （MVPN） implementations， which two of the following statements are regarding the DefaultMDT Group？（）

    • A、It is used for PIM control traffic
    • B、It is optionally configured for a high bandwidth multicast source to reduce multicast traffic replication to uninterested PE routers
    • C、Within the VPF configuration in the PE router， multiple Default MDT groups are configured so each VPF can support multiple multicast sources
    • D、There is a reduced multicast state in the MPLS core P routers
    • E、When multicast traffic exceeds a certain configured threshold， traffic from the Data MDT is switched to the Default MDT to conserve bandwidth

    正确答案:A,D

  • 第15题：

    When determining a customer’s technical requirements for a Cisco Unified Communications solution， which important tool can be used to determine the bandwidth used by different codecs with various protocols over different media？（）

    • A、Network Codec Aggregator Tool
    • B、Bandwidth Estimator Tool
    • C、Unified Communication Bandwidth Tool
    • D、Voice Bandwidth Calculator
    • E、Voice Codec Bandwidth Calculator

    正确答案:D

  • 第16题：

    For defining the QoS policies for each traffic class， which parameters should be identified？（）

    • A、minimum bandwidth guarantee
    • B、average bandwidth guarantee
    • C、optimum bandwidth guarantee
    • D、maximum bandwidth rate
    • E、IP precedence
    • F、priority

    正确答案:A,D,F

  • 第17题：

    You are working as an administrator at TestKing, and you need to set the bandwidth of your routers serial port to 56K. Which of the following commands would you use?（）

    • A、Bandwidth 56000
    • B、Bandwidth 56000000
    • C、Bandwidth 56
    • D、Bandwidth 56kbps

    正确答案:C

  • 第18题：

    You are troubleshooting a problem with a Cisco 7920 wireless IP phone that is causing the phone to drop calls. The problem appears to be a roaming bandwidth issue. In order to verify what kind ofissue it is， you decide to increase the bandwidth reserved for roaming on the WLAN controller to themaximum. What level do you set the bandwidth to？（）

    • A、5 percent
    • B、15 percent
    • C、25 percent
    • D、35 percent

    正确答案:C

  • 第19题：

    Which configuration command sets the MPLS interface bandwidth to 15 Mbps?（）

    • A、set bandwidth 15
    • B、mpls bandwidth 15
    • C、set bandwidth 15000
    • D、mpls bandwidth 15000

    正确答案:D

  • 第20题：

    多选题
    When Cisco SDM is used to generate QoS policy， various QoS classes will be created and assigned a percentage of the interface bandwidth. Which three statements indicate the default bandwidth values that are assigned by SDM for outgoing traffic on a WAN interface？ （）
    A

    Voice traffic will be assigned 47% of the interface bandwidth.

    B

    Voice call signaling will be assigned 33% of the interface bandwidth.

    C

    Telnet， SSH， and other traffic that is generated to manage the router is assigned 5% of the interface bandwidth.

    D

    Best-effort traffic will be assigned 38% of the interface bandwidth.

    E

    Routing protocol traffic will be assigned 5% of the interface bandwidth.

    F

    Transactional traffic will be assigned 5% of the interface bandwidth.


    正确答案： D,C
    解析： 暂无解析

  • 第21题：

    多选题
    For defining the QoS policies for each traffic class， which parameters should be identified？（）
    A

    minimum bandwidth guarantee

    B

    average bandwidth guarantee

    C

    optimum bandwidth guarantee

    D

    maximum bandwidth rate

    E

    IP precedence

    F

    priority


    正确答案： F,D
    解析： 暂无解析

  • 第22题：

    单选题
    Which configuration command sets the MPLS interface bandwidth to 15 Mbps?（）
    A

    set bandwidth 15

    B

    mpls bandwidth 15

    C

    set bandwidth 15000

    D

    mpls bandwidth 15000


    正确答案： D
    解析： 暂无解析

  • 第23题：

    单选题
    You are troubleshooting a problem with a Cisco 7920 wireless IP phone that is causing the phoneto drop calls. The problem appears to be a roaming bandwidth issue. In order to verify what kind ofissue it is， you decide to increase the bandwidth reserved for roaming on the WLAN controller tothe maximum. What level do you set the bandwidth to？（）
    A

    25 percent

    B

    15 percent

    C

    5 percent

    D

    35 percent


    正确答案： D
    解析： 暂无解析

  • 第24题：

    单选题
    A 2-way interleaved DDR configuration and a 4-way interleaved SDRAM configuration will produce which of the following？（）
    A

    They will have the same memory bandwidth.

    B

    2-way will provide higher memory bandwidth than 4-way.

    C

    4-way will provide higher memory bandwidth than 2-way.

    D

    4-way will provide higher memory bandwidth but only on an x445.


    正确答案： A
    解析： 暂无解析

相关内容