单选题While installing a new PCI card the administrator touched the motherboard. While powering on the server， a series of beeps were emitted and the server did not POST.  Which of the following could be done to prevent this problem？ （）AUse ESD equipment.BVe

题目
单选题
While installing a new PCI card the administrator touched the motherboard. While powering on the server， a series of beeps were emitted and the server did not POST.  Which of the following could be done to prevent this problem？ （）
A

 Use ESD equipment.

B

 Verify correct voltages are being supplied.

C

 Use a system board tester to check for compatibility issues.

D

 Install compatible PCI cards

相似考题

1.An administrator has shut down a server to install additional memory. When the administrator restarts the server after the upgrade, it times out. Which of the following could be the cause of the problem?（）A. Processor failureB. Third party memoryC. Disk drive failureD. ESD during the upgradeE. Backplane failure

2.Memory was recently taken out of a fully functional production server before it wasdecommissioned and added to another server.  Upon booting up the server with the additional memory the server emits a series of beeps and fails to POST.  Which of the following is MOST likely the problem？（）A、Incompatible memoryB、Memory failureC、The memory is not configuredD、The server BIOS was not configured to accept the additional memory

3.An administrator installed new components on a server. After the device installation， two of the components fail.Which of the following is the cause of the problem？（）A、The server was not powered off correctly.B、The proper ESD procedures were not used.C、The devices were installed in the incorrect sequence.D、The devices are incompatible with the system.

4.While installing a new PCI card the administrator touched the motherboard. While powering on the server, a series of beeps were emitted and the server did not POST.Which of the following could be done to prevent this problem?（）A. Use ESD equipment.B. Verify correct voltages are being supplied.C. Use a system board tester to check for compatibility issues.D. Install compatible PCI cards

更多“单选题While installing a new PCI card the administrator touched the motherboard. While powering on the server， a series of beeps were emitted and the server did not POST.  Which of the following could be done to prevent this problem？ （）A  Use ESD equipment.B”相关问题

  • 第1题：

    While installing a new PCI card the administrator touched the motherboard. While powering on the server, a series of beeps were emitted and the server did not POST. Which of the following could be done to prevent this problem?（）

    • A、Use ESD equipment.
    • B、Verify correct voltages are being supplied.
    • C、Use a system board tester to check for compatibility issues.
    • D、Install compatible PCI cards

    正确答案:A

  • 第2题：

    Before installing an operating system on a server， which of the following is the BEST resource for an administrator to review the compatibility of the OS with the video card？（）

    • A、Server manual
    • B、Manufacturer website
    • C、IEEE standards
    • D、HCL

    正确答案:D

  • 第3题：

    A company plans to upgrade a network server. Before proceeding with the upgrade， the HCL （Hardware Compatibility List） and hardware is checked and necessary backups and documentation are made.   The existing 512 MB of SDRAM is replaced with 1024 MB. The 10 Mbps network card is replaced with a 10/100 PCI network card. When the server restarts， beeps sound and the server does not pass the POST.  Which of the following is the MOST likely cause of the problem？（）

    • A、 The memory is not seated correctly.
    • B、 The network card is not configured correctly.
    • C、 The server does not support 1024 MB of memory.
    • D、 Master SDRAM ECC needs to be enabled in the CMOS.

    正确答案:A

  • 第4题：

    A technician is installing new memory in a server. The technician would consult the HCL to ensure which of the following？（）

    • A、Memory and virtual memory compatibility
    • B、Memory and speed compatibility
    • C、Memory and HDD compatibility
    • D、ESD standards were followed

    正确答案:B

  • 第5题：

    An administrator has shut down a server to install additional memory. When the administrator restarts the server after the upgrade, it times out. Which of the following could be the cause of the problem?（）

    • A、Processor failure
    • B、Third party memory
    • C、Disk drive failure
    • D、ESD during the upgrade
    • E、Backplane failure

    正确答案:B,D

  • 第6题：

    A system administrator received the following message while trying to ssh to a server：  connection timed out.The administrator pinged the server and had no response. The administrator then pinged the gateway， and was successful. Which tool could the administrator use next to isolate the problem？（）

    • A、route
    • B、traceroute
    • C、netstat -nr
    • D、broadcast ping

    正确答案:B

  • 第7题：

    单选题
    An administrator is creating a comprehensive backup system to backup a single web server.Which of the following is the BEST way to provide full restore?（）
    A

    Take an image backup nightly while the server is online.

    B

    Take an incremental backup while the server is offline.

    C

    Take a monthly snapshot backup while the server is online.

    D

    Take a differential backup while the server is online.


    正确答案： C
    解析： 暂无解析

  • 第8题：

    单选题
    An administrator is creating a comprehensive backup system to backup a single web server. Which of the following is the BEST way to provide full restore？（）
    A

     Take an image backup nightly while the server is online.

    B

     Take an incremental backup while the server is offline.

    C

     Take a monthly snapshot backup while the server is online.

    D

     Take a differential backup while the server is online.


    正确答案： A
    解析： 暂无解析

  • 第9题：

    单选题
    Memory was recently taken out of a fully functional production server before it wasdecommissioned and added to another server.  Upon booting up the server with the additional memory the server emits a series of beeps and fails to POST.  Which of the following is MOST likely the problem？（）
    A

    Incompatible memory

    B

    Memory failure

    C

    The memory is not configured

    D

    The server BIOS was not configured to accept the additional memory


    正确答案： A
    解析： 暂无解析

  • 第10题：

    单选题
    Before installing an operating system on a server， which of the following is the BEST resource for an administrator to review the compatibility of the OS with the video card？（）
    A

    Server manual

    B

    Manufacturer website

    C

    IEEE standards

    D

    HCL


    正确答案： D
    解析： 暂无解析

  • 第11题：

    单选题
    While reviewing the backup logs a server administrator notices that a backup job for an application server on the same subnet has failed. Which of the following is MOST likely the problem？（）
    A

    The remote agent was not running.

    B

    The management card has failed.

    C

    The proxy server was blocking access.

    D

    The hardware firewall was blocking access.


    正确答案： B
    解析： 暂无解析

  • 第12题：

    单选题
    An administrator has ordered a new server and setup a dedicated RAID 1 array for the application database. While troubleshooting with performance monitoring tools， the administrator is receiving lowerread/write speeds than expected.  Which of the following would be the MOST likely cause for the lower performance？（）
    A

     The BIOS needs to be upgraded.

    B

     The administrator did not add the right amount of memory.

    C

     There is a cooling issue with the server.

    D

     The administrator did not order high enough RPM drives.


    正确答案： C
    解析： 暂无解析

  • 第13题：

    An administrator just installed a new RAID controller card into a server. The firmware is current for the controller card. When the server is powered up the administrator notices that the RAID controller card is not recognized during POST. Which of the following is the cause of the problem？（）

    • A、The hard drives were not plugged into the server correctly.
    • B、The controller driver is outdated and needs to be updated from the OEMs website.
    • C、The firmware for the server is too old and does not support the new RAID controller card.
    • D、The cable from the controller to the hard drive backplane is not connected.

    正确答案:C

  • 第14题：

    While reviewing the backup logs a server administrator notices that a backup job for an application server on the same subnet has failed. Which of the following is MOST likely the problem？（）

    • A、The remote agent was not running.
    • B、The management card has failed.
    • C、The proxy server was blocking access.
    • D、The hardware firewall was blocking access.

    正确答案:A

  • 第15题：

    An administrator has ordered a new server and setup a dedicated RAID 1 array for the application database. While troubleshooting with performance monitoring tools， the administrator is receiving lowerread/write speeds than expected.  Which of the following would be the MOST likely cause for the lower performance？（）

    • A、 The BIOS needs to be upgraded.
    • B、 The administrator did not add the right amount of memory.
    • C、 There is a cooling issue with the server.
    • D、 The administrator did not order high enough RPM drives.

    正确答案:D

  • 第16题：

    After installing a second processor and corresponding heatsink into a server， an administrator notices that the new processor is not showing up during POST.  Which of the following could be the cause of this issue？（）

    • A、 The power supply is not sufficient to power the server.
    • B、 The voltage regulator module （VRM） was not installed.
    • C、 The IRQ setting was not set.
    • D、 The DMA setting was not set.

    正确答案:B

  • 第17题：

    While installing a new PCI card the administrator touched the motherboard. While powering on the server， a series of beeps were emitted and the server did not POST.  Which of the following could be done to prevent this problem？ （）

    • A、 Use ESD equipment.
    • B、 Verify correct voltages are being supplied.
    • C、 Use a system board tester to check for compatibility issues.
    • D、 Install compatible PCI cards

    正确答案:A

  • 第18题：

    单选题
    While installing a new PCI card the administrator touched the motherboard. While powering on the server, a series of beeps were emitted and the server did not POST. Which of the following could be done to prevent this problem?（）
    A

    Use ESD equipment.

    B

    Verify correct voltages are being supplied.

    C

    Use a system board tester to check for compatibility issues.

    D

    Install compatible PCI cards


    正确答案： B
    解析： 暂无解析

  • 第19题：

    单选题
    A system administrator received the following message while trying to ssh to a server：  connection timed out.The administrator pinged the server and had no response. The administrator then pinged the gateway， and was successful. Which tool could the administrator use next to isolate the problem？（）
    A

    route

    B

    traceroute

    C

    netstat -nr

    D

    broadcast ping


    正确答案： C
    解析： 暂无解析

  • 第20题：

    单选题
    After installing a second processor and corresponding heatsink into a server， an administrator notices that the new processor is not showing up during POST.  Which of the following could be the cause of this issue？（）
    A

     The power supply is not sufficient to power the server.

    B

     The voltage regulator module （VRM） was not installed.

    C

     The IRQ setting was not set.

    D

     The DMA setting was not set.


    正确答案： D
    解析： 暂无解析

  • 第21题：

    单选题
    An administrator just installed a new RAID controller card into a server. The firmware is current for the controller card. When the server is powered up the administrator notices that the RAID controller card is not recognized during POST. Which of the following is the cause of the problem？（）
    A

    The hard drives were not plugged into the server correctly.

    B

    The controller driver is outdated and needs to be updated from the OEMs website.

    C

    The firmware for the server is too old and does not support the new RAID controller card.

    D

    The cable from the controller to the hard drive backplane is not connected.


    正确答案： D
    解析： 暂无解析

  • 第22题：

    单选题
    An administrator installed new components on a server. After the device installation， two of the components fail.Which of the following is the cause of the problem？（）
    A

    The server was not powered off correctly.

    B

    The proper ESD procedures were not used.

    C

    The devices were installed in the incorrect sequence.

    D

    The devices are incompatible with the system.


    正确答案： C
    解析： 暂无解析

  • 第23题：

    单选题
    A company plans to upgrade a network server. Before proceeding with the upgrade， the HCL （Hardware Compatibility List） and hardware is checked and necessary backups and documentation are made.   The existing 512 MB of SDRAM is replaced with 1024 MB. The 10 Mbps network card is replaced with a 10/100 PCI network card. When the server restarts， beeps sound and the server does not pass the POST.  Which of the following is the MOST likely cause of the problem？（）
    A

     The memory is not seated correctly.

    B

     The network card is not configured correctly.

    C

     The server does not support 1024 MB of memory.

    D

     Master SDRAM ECC needs to be enabled in the CMOS.


    正确答案： D
    解析： 暂无解析

  • 第24题：

    单选题
    While installing a new PCI card the administrator touched the motherboard. While powering on the server， a series of beeps were emitted and the server did not POST.  Which of the following could be done to prevent this problem？ （）
    A

     Use ESD equipment.

    B

     Verify correct voltages are being supplied.

    C

     Use a system board tester to check for compatibility issues.

    D

     Install compatible PCI cards


    正确答案： D
    解析： 暂无解析

相关内容