a router with subinterfaces configured on the physical interface that is connected to the switch
a router with an IP address on the physical interface connected to the switch
a switch with an access link that is configured between the switches
a switch with a trunk link that is configured between the switches
第1题:
A group of hosts are physically connected to the same switch. The hosts are used by employees of different departments and therefore do not need to directly exchange data on a regular basis.Which technology can a network administrator deploy to reduce unnecessary broadcast traffic between these hosts?()
A. Micro segmentation
B. Transparent switching
C. peer-to-peer networking
D. port security
E. store-and-forward switching
F. virtual local area networks
第2题:

A.The subnet mask in use is 255.255.255.192.
B.The subnet mask in use is 255.255.255.128.
C.The IP address 172.16.1.25 can be assigned to hosts in VLAN1
D.The IP address 172.16.1.205 can be assigned to hosts in VLAN1
E.The LAN interface of the router is configured with one IP address.
F.The LAN interface of the router is configured with multiple IP addresses.
第3题:
When one connection to a host fails in a full mesh network, which of the following is true?()
第4题:
An administrator needs a network that can support up to 800 hosts on the same subnet. Which of the following is the MINIMUM subnet mask that should be used?()
第5题:
On corporate network, hosts on the same VLAN can communicate with each other, but they are unable to communicate with hosts on different VLANs. What is needed to allow communication between the VLANs?()
第6题:
After making changes to IP aliasing and rebooting the system, an AIX server is unable to communicate with other hosts. Which command can be run to check ent0 adapter configuration relative to IP address and network mask?()
第7题:
The subnet mask in use is 255.255.255.192.
The subnet mask in use is 255.255.255.128.
The IP address 172.16.1.25 can be assigned to hosts in VLAN1
The IP address 172.16.1.205 can be assigned to hosts in VLAN1
The LAN interface of the router is configured with one IP address.
The LAN interface of the router is configured with multiple IP addresses.
第8题:
The access link needs to be configured in multiple VLANs.
The link between the switches is configured in the wrong VLAN.
The link between the switches needs to be configured as a trunk.
VTP is not configured to carry VLAN information between the switches.
Switch IP addresses must be configured in order for traffic to be forwarded between the switches
第9题:
Micro segmentation
Transparent switching
peer-to-peer networking
port security
store-and-forward switching
virtual local area networks
第10题:
All hosts can communicate.
No hosts can communicate.
Half of the hosts will lose communication.
Only the two hosts between the failed connection will lose communication.
第11题:
a router with subinterfaces configured on the physical interface that is connected to the switch
a router with an IP address on the physical interface connected to the switch
a switch with an access link that is configured between the switches
a switch with a trunk link that is configured between the switches
第12题:
One network with 254 hosts.
254 networks with 254 hosts per network.
65,534 networks with 255 hosts per network.
30 networks with 64 hosts per network.
254 networks with 65,534 per network.
第13题:
Refer to the exhibit. A network technician is asked to design a small network with redundancy. The exhibit represents this design, with all hosts configured in the same VLAN. What conclusions can be made about this design?()

A.The design will function as intended
B.Spanning-tree will need to be used.
C.The router will not accept the addressing scheme.
D.The connection between switches should be a trunk.
E.The router interfaces must be encapsulated with the 802.1Q protocol.
第14题:
Hosts on the same VLAN can communicate with each other but are unable to communicate with hosts on different VLANs. What is needed to allow communication between VLANs()。
第15题:
Which of the following options applies to virtual Ethernet devices()
第16题:
What is the purpose of assigning an IP address to a switch?()
第17题:
A group of hosts are physically connected to the same switch. The hosts are used by employees of different departments and therefore do not need to directly exchange data on a regular basis.Which technology can a network administrator deploy to reduce unnecessary broadcast traffic between these hosts?()
第18题:
What are two routing requirements for a device to communicate with another device?()
第19题:
The design will function as intended
Spanning-tree will need to be used.
The router will not accept the addressing scheme.
The connection between switches should be a trunk.
The router interfaces must be encapsulated with the 802.1Q protocol.
第20题:
a switch with a trunk link that is configured between the switches
a router with an IP address on the physical interface that is connected to the switch
a switch with an access link that is configured between the switches
a router with subinterfaces configured on the physical interface that is connected to the switch
第21题:
A virtual Ethernet adapter can only connect to other partitions within the same system.
A virtual Ethernet adapter needs to be connected to an external VLAN capable switch to be able to communicate with other partitions on the same system.
A partition can support an unlimited number of virtual Ethernet devices.
A virtual Ethernet adapter in the VIO Server that is part of a SEA should not have the trunk flag set
第22题:
RARP request
Show Network Address request
Proxy ARP request
ARP request
Show Hardware Address request
第23题:
IP
ICMP
TCP
UDP
第24题:
255.0.0.0
255.255.0.0
255.255.252.0
255.255.255.0