low exhaust back pressure
early fuel injection in one of the cylinders
compression pressure in one of the cylinders
plugged injector holes
第1题:
insufficient fuel supply
faulty governor
high exhaust back pressure
all of the above may cause this problem
第2题:
prevent engine back pressure at heavy loads
increase total engine efficiency at low loads
prevent boiler corrosion at low engine loads
improve engine fuel consumption at any load
第3题:
chromium plating piston rings
knurling the piston skirt
extended maximum power operation
applying load to a cold diesel engine
第4题:
burned exhaust valves
excessive spring compression
spring surge
worn valve seats
第5题:
reduce the engine driven fuel pump outlet pressure
retard the fuel injector timing to reduce power
increase the fuel rack setting
reduce the load on the engine
第6题:
bedplate or base
sump or oil pan
cylinder block
frame
第7题:
low exhaust back pressure
early fuel injection in one of the cylinders
compression pressure in one of the cylinders
plugged injector holes
第8题:
when the engine RPM is pulled down by overload
at rated engine RPM
at 95 % of rated engine RPM
at 95 % of a properly adjusted governor RPM with the engine under full load
第9题:
smoky
a little bit dense
visible
almost invisible
第10题:
decrease only
increase only
decrease slightly then returned to original speed
increase slightly then returned to original speed
第11题:
decrease until the engine speed increases
increase as the load increases
decrease as the load
increases remain unchanged
第12题:
reduce load
check your exhaust
adjust cooling water temperature
increase lube oil flow
第13题:
reduce lube oil temperature
raise exhaust temperature reduce
excessive heating of engine room
reduce load on cooling water pump
第14题:
lower the no-load RPMs
provide more air for combine with the fuel
increase the no-load RPMs
provide more fuel combine with the air
第15题:
air quantity aspirated
fuel injection pressure
combustion pressure on the power stroke
compression on the compression stroke
第16题:
adjusts the idle speed control
drain and flushes the governor and replace the oil
adjusts the compensating needle valve
第17题:
Bed plate
Column
Entablature
Tie rod
第18题:
raw water pump discharge
expansion tank outlet
cooling water heat exchanger
outlet engine jacket water outlet
第19题:
decrease in ignition lag
increase in fuel economy
reduction in lube oil viscosity
increase in cylinder misfiring
第20题:
has little or no internal friction
has a lower effective compression ratio
operates with scavenge air under a positive pressure
operates without energy absorbing intake and exhaust strokes
第21题:
a reduction
an increase
an outing
a downwards
第22题:
failing to reach rated speed
knocking under maximum load
hunting or surging under light load
overspeeding and running away
第23题:
reduce the engine load
increase the cooling water flow
increase the lube oil pressure
adjust the fuel rack