The pressure of the hose is too low.()
第1题:
Which action is routinely performed at the annual servicing and inspection of a dry-chemical cartridge-operated portable fire extinguisher?
A.Test the pressure gauge for correct reading
B.Weigh the cartridge
C.Replace the dry chemical
D.Pressure test the discharge hose
第2题:
Each hose used for transferring vapors must ______.
A.have a design burst pressure of at least 25 psig
B.be capable of withstanding at least 2.0 psi vacuum without collapsing or constricting
C.be electrically continuous with a maximum resistance of ten thousand ohms
D.All of the above
第3题:
Test the pressure gauge for correct reading
Weigh the cartridge
Replace the dry chemical
Pressure test the discharge hose
第4题:
This is to be carried out at a maximum distance of 1,5m with a hose pressure not less than 2,0 kgf/cm2. The nozzle diameter is not to be less than 12mm.
This is to be carried out at a maximum distance of 1,5m with a hose pressure not less than 3,5 kgf/cm2. The nozzle diameter is not to be less than 5mm.
This is to be carried out at a maximum distance of 1,5m with a hose pressure not less than 4,0 kgf/cm2. The nozzle diameter is not to be less than 8mm.
This is to be carried out at a maximum distance of 2,0m with a hose pressure not less than 2,0 kgf/cm2. The nozzle diameter is not to be less than 12mm.
第5题:
the compressor suction pressure is not too high
all air is purged from the pump and charging fittings
the high pressure cutout switch is held open to prevent accidental starting
the condenser is completely shutdown first
第6题:
Fold the hose so that the male coupling is about 4 feet from the female coupling,then roll it up
Roll the hose starting at the female end
Roll the hose starting at the male end
Fold the hose into lengths about 6 feet long and then lash the folds together
第7题:
压载水压力太低。
水龙压力太低。
水龙压力太高。
压载水压力太高。
第8题:
add to
attend to
contribute to
apply to
第9题:
cylinder compression pressure may not be high enough
cylinder compression temperature may be too high
fuel oil injection pressure may not be high enough
scavenge and purge process is incomplete
第10题:
tend to twist about its long axis
expand in length and in diameter
contract in length and expand in diameter
flex at right angles to the applied pressure
第11题:
fuel droplets will burn as they leave the fuel injector
fuel will not be properly atomized in the cylinder
maximum expansion of the burned fuel cannot take place in the cylinder
compression pressure will be too low to cause fuel ignition
第12题:
have a design burst pressure of at least 25 psig
be capable of withstanding at least 2.0 psi vacuum without collapsing or constricting
be electrically continuous with a maximum resistance of ten thousand ohms
All of the above
第13题:
Which statement about stowing spare hose is TRUE ________.
A.Fold the hose so that the male coupling is about 4 feet from the female coupling,then roll it up
B.Roll the hose starting at the female end
C.Roll the hose starting at the male end
D.Fold the hose into lengths about 6 feet long and then lash the folds together
第14题:
Reid vapor pressure is ______.
A.exerted by liquid cargo on the sides of a tank
B.exerted by liquid cargo on a cargo hose body
C.the lowest temperature and pressure that will cause a flammable liquid to give off vapors
D.a measurement of the amount of flammable vapors given off by a liquid at a certain temperature
第15题:
viscosity is too low
temperature is too low
pump discharge pressure is higher than the systems pressure
pump capacity is greater than the systems needs
第16题:
attribute to
attend to
distribute to
contribute to
第17题:
starting air pressure too high
correct timing of starting air valves
three of the six starting valves stuck
the turning gear disengaged
第18题:
air charge density becoming too high
piston crown surfaces becoming too cold
formation of excessive quantities of condensate
compression pressure being greatly reduced
第19题:
escape
suggest
avoid
relieve
第20题:
the relief valve should open before the high-pressure cutout
the relief valve should open and let excess refrigerant go to receiver
the high-pressure cutout switch should operate before the relief valve opens
close in on the suction valve
第21题:
too much superheat
insufficient superheat
suction pressure too low
excessive refrigerant returning to the compressor
第22题:
escape
suggest
avoid
relax
第23题:
5 times the maximum working pressure on the hose during cargo transfer
one half the designed working pressure
4 times the pressure of the cargo pump used for transferring
5 times the minimum working pressure on the hose during cargo transfer