Which commands, when used together, would create an 802.1Q link?()A. Switch(vlan)# mode trunkB. Switch(config)# switchport access mode trunkC. Switch(config-if)# switchport mode trunkD. Switch(config-if)# switchport trunk encapsulation dot1qE. Switch(conf

题目
Which commands, when used together, would create an 802.1Q link?()

A. Switch(vlan)# mode trunk

B. Switch(config)# switchport access mode trunk

C. Switch(config-if)# switchport mode trunk

D. Switch(config-if)# switchport trunk encapsulation dot1q

E. Switch(config)# switchport access mode 1

F. Switch(vlan)# trunk encapsulation dot1q

相似考题

1.You need to configure an 802.1Q link on a Ezonexam switch. Which commands, when used together, would do this? (Select two answer choices)A. Switch(vlan) mode trunkB. Switch(config) switchport access mode trunkC. Switch(config-if) switchport mode trunkD. Switch(config-if) switchport trunk encapsulation dot1qE. Switch(config) switchport access mode 1F. Switch(vlan) trunk encapsulation dot1q

2.Which parameter can be tuned to affect the selection of a static route as a backup.when a dynamic protocol is also being used?()A.link bandwidthB.hop countC.link costD.administrative distanceE.link delay

3.Which statements about 802.1Q trunking in Secure Network Foundation Design Guide for Single Site Deployments are correct？（）A、The Cisco Control VLAN carries only Layer 2 control trafficB、802.1Q trunking is used between the access switch and the routerC、There is no 802.1Q trunking used in these designsD、When 802.1Q trunks are configured， they are also called Native VLANsE、Trunking Ensures that traffic from only one VLAN is carried on that trunk

4.Examine the CREATE DISKGROUP command used to create a disk group:In which situation would you use this method of disk group creation?()A. When two-way disk mirroring is required for the allocation unitsB. When three-way disk mirroring is required for the allocation unitsC. When using hardware mirroring or RAIDD. When disk mirroring is required for the Automatic Storage Management (ASM) disks

更多“Which commands, when used together, would create an 802.1Q link?() ”相关问题

  • 第1题：

    Which commands, when used together, would create an 802.1Q link?（）

    • A、Switch(vlan)# mode trunk
    • B、Switch(config)# switchport access mode trunk
    • C、Switch(config-if)# switchport mode trunk
    • D、Switch(config-if)# switchport trunk encapsulation dot1q
    • E、Switch(config)# switchport access mode 1
    • F、Switch(vlan)# trunk encapsulation dot1q

    正确答案:C,D

  • 第2题：

    Which parameter can be tuned to affect the selection of a static route as a backup.when a dynamic protocol is also being used?（）

    • A、link bandwidth
    • B、hop count
    • C、link cost
    • D、administrative distance
    • E、link delay

    正确答案:D

  • 第3题：

    Which mechanism can you use to achieve sub-second failover for link failure detection when a switched Ethernet media is used and loss of signal is not supported by the link provider？（）

    • A、OSPF standard hellos
    • B、Cisco Discovery Protocol link detection
    • C、Bidirectional Forwarding Detection
    • D、Fast Link Pulse
    • E、autonegotiation

    正确答案:C

  • 第4题：

    Which of the following commands would be used to go from c:/windows to c:/windows/system32?（）

    • A、RD
    • B、MD
    • C、DIR
    • D、CD

    正确答案:D

  • 第5题：

    Which of the following commands would be used to display the IP address on a UNIX/Linux computer?（）

    • A、netstat
    • B、ipconfig
    • C、ifconfig
    • D、dig

    正确答案:C

  • 第6题：

    Which of the following commands are used to create folders in a command prompt？（）

    • A、CD
    • B、RD
    • C、MD
    • D、SD

    正确答案:C

  • 第7题：

    Which of the following commands would be used to display hidden files?（）

    • A、dir /?
    • B、dir /d
    • C、dir /a
    • D、dir /s

    正确答案:C

  • 第8题：

    Because of changes in an application environment， the /etc/inittab file needs to be modified.  Which of the following commands would be used to accomplish this in a supported manner（）

    • A、vi
    • B、chitab
    • C、chssys
    • D、chrsrc

    正确答案:B

  • 第9题：

    单选题
    Examine the CREATE DISKGROUP command used to create a disk group：   SQL> CREATE DISKGROUP misc EXTERNAL REDUNDANCY  DISK ’ORCL： FRA3’ NAME misc1， ’ORCL： FRA4’ NAME misc2；   In which situation would you use this method of disk group creation？（）
    A

     When two-way disk mirroring is required for the allocation units

    B

     When three-way disk mirroring is required for the allocation units

    C

     When using hardware mirroring or RAID

    D

     When disk mirroring is required for the Automatic Storage Management （ASM） disks


    正确答案： C
    解析： 暂无解析

  • 第10题：

    多选题
    Which two commands can be used to verify a trunk link configuration status on a given cisco switch?（）
    A

    show interfaces interface

    B

    show interfaces trunk

    C

    show interfaces switchport

    D

    show ip interface brief

    E

    show interfaces vlan


    正确答案： A,E
    解析： 暂无解析

  • 第11题：

    单选题
    Which of the following commands would create an emergency repair disk for the Windows 2000Professional operating system? （）
    A

    rdisk.exe

    B

    bootdisk.exe

    C

    bootcfg /rebuild

    D

    erd.exe


    正确答案： A
    解析： 暂无解析

  • 第12题：

    单选题
    Which mechanism can you use to achieve sub-second failover for link failure detection when a switched Ethernet media is used and loss of signal is not supported by the link provider？（）
    A

    OSPF standard hellos

    B

    Cisco Discovery Protocol link detection

    C

    Bidirectional Forwarding Detection

    D

    Fast Link Pulse

    E

    autonegotiation


    正确答案： C
    解析： 暂无解析

  • 第13题：

    Which parameter can be tuned to affect the selection of a static route as a backup.when a dynamic protocol is also being used?（）

    • A、link bandwidth
    • B、hop count
    • C、link cost
    • D、administrative distance

    正确答案:D

  • 第14题：

    Which two commands can be used to verify a trunk link configuration status on a given cisco switch?（）

    • A、show interfaces interface
    • B、show interfaces trunk
    • C、show interfaces switchport
    • D、show ip interface brief
    • E、show interfaces vlan

    正确答案:B,C

  • 第15题：

    Which of the following utilities would be used to configure energy saving measures when a laptop switches to battery power?（）

    • A、MSTSC
    • B、ACPI
    • C、GDI
    • D、MSCONFIG

    正确答案:B

  • 第16题：

    Which of the following commands would be used to verify the integrity of critical system files?（）

    • A、verify
    • B、nslookup
    • C、sfc
    • D、chkdsk

    正确答案:C

  • 第17题：

    Which of the following commands would create an emergency repair disk for the Windows 2000Professional operating system? （）

    • A、rdisk.exe
    • B、bootdisk.exe
    • C、bootcfg /rebuild
    • D、erd.exe

    正确答案:A

  • 第18题：

    Which of the following commands would be used to verify and troubleshoot DNS settings of aparticular host on a Windows computer?（）

    • A、TRACERT
    • B、NSLOOKUP
    • C、CHKDSK
    • D、XCOPY

    正确答案:B

  • 第19题：

    Which of the following commands would MOST likely be used to see where a loss of connectivity between two devices on a network is located?（）

    • A、tracert
    • B、netstat
    • C、nslookup
    • D、ping

    正确答案:A

  • 第20题：

    An administrator attempts to create a link of /etc/db_conf to the target directory /db/v9.7/install/config. The following n?command failed toAn administrator attempts to create a link of /etc/db_conf to the target directory /db/v9.7/install/config. The following ?n?command failed to create the link.ln/db/v9.7/install/config /etc/db_conf. Which option should be used when re-running the command to resolve the problem?（）

    • A、-s flag to create a soft link
    • B、-n flag to force create a hard link
    • C、-N flag to force create a hard link
    • D、-S flag to force create a soft link

    正确答案:A

  • 第21题：

    多选题
    Which commands, when used together, would create an 802.1Q link?（）
    A

    Switch(vlan)# mode trunk

    B

    Switch(config)# switchport access mode trunk

    C

    Switch(config-if)# switchport mode trunk

    D

    Switch(config-if)# switchport trunk encapsulation dot1q

    E

    Switch(config)# switchport access mode 1

    F

    Switch(vlan)# trunk encapsulation dot1q


    正确答案： D,F
    解析： 暂无解析

  • 第22题：

    单选题
    An administrator attempts to create a link of /etc/db_conf to the target directory /db/v9.7/install/config. The following n?command failed toAn administrator attempts to create a link of /etc/db_conf to the target directory /db/v9.7/install/config. The following ?n?command failed to create the link.ln/db/v9.7/install/config /etc/db_conf. Which option should be used when re-running the command to resolve the problem?（）
    A

    -s flag to create a soft link

    B

    -n flag to force create a hard link

    C

    -N flag to force create a hard link

    D

    -S flag to force create a soft link


    正确答案： A
    解析： 暂无解析

  • 第23题：

    单选题
    Which RMAN command is used to verify the status of a backup or copy， and also updates the repository when files have been deleted using operating system commands？（）
    A

    CHANGE

    B

    RESYNC

    C

    CATALOG

    D

    CROSSCHECK


    正确答案： B
    解析： 暂无解析

相关内容