Refer to the exhibit. A partial routing configuration is shown. Complete the configuration so that only the default - network is redistributed from EIGRP 190 into EIGRP 212. Which ACL statement completes the configuration correctly? ()A. access - list 100

题目

Refer to the exhibit. A partial routing configuration is shown. Complete the configuration so that only the default - network is redistributed from EIGRP 190 into EIGRP 212. Which ACL statement completes the configuration correctly? ()

A. access - list 100 permit ip 0.0.0.0 0.0.0.0 0.0.0.0 0.0.0 .0

B. access - list 100 permit ip host 0.0.0.0 any

C. access - list 100 permit ip any host 0.0.0.0

D. A default -network cannot be redistributed between routing processes.


相似考题
参考答案和解析
参考答案:C
更多“Refer to the exhibit. A partial routing configuration is shown. Complete the configuration ”相关问题
  • 第1题:

    Refer to the exhibit. Examine the partial configuration and the routing table excerpt. Which routes would be redistributed into OSPF area 1?()

    A. 10.10.10.16/28 only

    B. 10.10.10.16/28 and 10.10.10.64/26

    C. 10.10.10.16/28, 10.10.10.64/26, and 172.16.10.0/24

    D. 10.10.10.64/26 only


    参考答案:D

  • 第2题:

    Refer to the exhibit. The partial configuration for an OSPF ASBR and an Area 0 ABR is shown. Assume the OSPF configurations throughout the network are operable. Which statement about these configurations is true? ()

    A. The ASBR route - maps are basically useless, because there are no deny prefix - lists.

    B. LSA Type 5s wil l not be received by the ABR from the ASBR.

    C. The OSPF backbone will not learn any RFC 1918 addresses.

    D. The matched prefix - list addresses will be given a metric of 255, which is essentially unreachable.


    参考答案:C

  • 第3题:

    Refer to the exhibit. A network administrator wants to reduce the number of OSPF routes advertised from Area 1 into Area 2. As the router configuration specialist, what two things would you do to accomplish this goal?()

    A. Enter the configuration on router B1.

    B. Enter the configuration on router B4.

    C. On the same router, enter the Summary - address 10.10.1.0 255.255.255.128 subcommand.

    D. On the same router, enter the Area 1 range 10.10.1.0 255.255.255.128 subcommand.

    E. On the same ro uter, enter the Area 2 range 10.10.1.0 255.255.255.128 subcommand.


    参考答案:A, D

  • 第4题:

    Refer to the exhibit. What is required to complete the IPv6 routing configurations shown?()

    A. Interface authentication must be configured

    B. The routing processes must be configured with an area ID

    C. IP unicast routing must be enabled

    D. IPv4 ad dresses must be applied to the interfaces


    参考答案:C

  • 第5题:

    Refer to the exhibit. Which statement is true about the router configuration that is shown ?Select the best response.()

    A. Additional DHCP options will be imported from another DHCP server.

    B. The DHCP server pools need to be bound to an interface to operate.

    C. This configuration will provide IP configuration information to two different su bnets.

    D. Additional DCHP option information needs to be imported from another DHCP server.

    E. If the router hands out all the addresses in pool 1, then it will supply addresses from pool 2.


    参考答案:C

  • 第6题:

    Refer to the exhibit. Which two statements are true about the partial configuration that is provided.()

    A. The peer group shortens the EBGP configuration

    B. The peer group shortens the IBGP configuration

    C. All the configured neighbors are in autonomous system 100

    D. Three AS - path filters are applied to each BGP neighbor

    E. Only the outgoing filters are applied to BGP updates


    参考答案:B, C

  • 第7题:

    Refer to the exhibit. EIGRP is configured with the default configuration on all routers. Auto summariz ation is enabled on routers R2 and R3, but it is disabled on router R1.Which two EIGRP routes will be seen in the routing table of router R3?()

    A. 10.0.0.0/8

    B. 172.16.10.0/24

    C. 172.16.0.0/24

    D. 10.10.10.0/24

    E. 172.16.0.0/16

    F. 10.10.0.0/16


    参考答案:D, E

  • 第8题:

    配置协商中有下面哪条消息().

    A.Configuration Request。

    B.Configuration Response

    C.Configuration Ack

    D.Configuration complete


    参考答案:A, B, C, D

  • 第9题:

    配置协商中有下面哪条消息().

    • A、Configuration Request。
    • B、Configuration Response
    • C、Configuration Ack
    • D、Configuration complete

    正确答案:A,B,C,D

  • 第10题:

    Refer to the exhibit. What is the configuration an example of?()

    • A、enabling modular QoS over Frame Relay
    • B、enabling Real-Time Transport Protocol (RTP) header compression
    • C、enabling distributed compressed Transmission Control Protocol
    • D、enabling latency and jitter reduction for Transmission Control traffic
    • E、enabling TCP header compression

    正确答案:E

  • 第11题:

    单选题
    Refer to the exhibit. What is the configuration an example of?()
    A

    enabling modular QoS over Frame Relay

    B

    enabling Real-Time Transport Protocol (RTP) header compression

    C

    enabling distributed compressed Transmission Control Protocol

    D

    enabling latency and jitter reduction for Transmission Control traffic

    E

    enabling TCP header compression


    正确答案: E
    解析: 暂无解析

  • 第12题:

    单选题
    Refer to the exhibit. A network administrator configures a new router and enters the copy startup-config running-config on the router. The network administrator powers down the router and sets it up at a remote location. When the router starts, it enter the system configuration dialog as shown. What is the caust of the problem?()
    A

    The network administrator faled to save the configuration.

    B

    The configuration register is set to 0x2100.

    C

    The boot system flash command is missing from the configuration.

    D

    The configuraiton register is set to 0x2102.

    E

    The router is configured with the boot system startup command.


    正确答案: A
    解析: 暂无解析

  • 第13题:

    Refer to the exhibit. Examine the partial configuration and the routing table excerpt. Which routes would be redistributed into OSPF area 1? ()

    A. 10.10.10.16/28 only

    B. 10.10.10.16/28 and 10.10.10.64/26

    C. 10.10.10.16/28, 10.10.10 .64/26, and 172.16.10.0/24

    D. 10.10.10.64/26 only


    参考答案:D

  • 第14题:

    Refer to the exhibit. Based upon the configuration, you need to understand why the policy routi match counts are not increasing. Which would be the first logical step to take?()

    A. Confirm if there are other problematic route - map statements that precede divert.

    B. Check the access list for log hits.

    C. Check the routing table for 212.50.185.126.

    D. Remove any two of the set clauses. (Multiple set clause entries will cause PBR to use the routing table.)


    参考答案:B

  • 第15题:

    Refer to the exhibit. When you examine the routing table of R1 and R4, you are not able to see the R1 Ethernet subnet on the R4 routing ta ble. You are also not able to see the R4 Ethernet subnet on the R1 routing table.Which configuration change should be made to resolve this issue? Select the routers where the configuration change will be required, and select the required EIGRP configur ation command(s).()

    A. R1 and R4

    B. R2 and R3

    C. ip summary-address eigrp 1 10.1.1.0 255.255.255.0 and ip summary - address eigrp 110.2.2.0 255.255.255.0

    D. variance 2

    E. eigrp stub connected

    F. no auto - summary


    参考答案:B, F

  • 第16题:

    Refer to the exhibit. Based upon the information in the exhibit, which statement is true?()

    A. DHCP requests from the host will be rebroadcasted to R2.

    B. To complete t his configuration, the R1 fa0/0 interface must be configured with the ip helper - addresses command.

    C. To complete this configuration, the R2 fa0/0 interface must be configured with the ip helper -addresses command.

    D. R1 will forward all DHCP requests t o both 192.168.100.1 and 192.168.200.1 as unicast messages.

    E. R1 will forward DHCP requests to 192.168.100.1. If there is no response, R1 will then forward the requests to 192.168.200.1.


    参考答案:D

  • 第17题:

    Refer to the exhibit. What three statements are true about the IS - IS configuration?()

    A.The router is in area 49.0001.0002

    B.The router acts as a Level 1 - 2 router

    C.CLNS routing is enable d for the router

    D.The router has a system ID of 0003.0004

    E.The interfaces have a functional IS - IS configuration

    F.The network service access point selector (NSEL) byte has a value of 0


    参考答案:B, E, F

  • 第18题:

    Refer to the exhibit. Which statement is true about the configuration? ()

    A. RTA will not establish an OSPF adjacency w ith RTB

    B. RTA will send OSPF hello packets, but will not send OSPF updates

    C. RTA will not accept OSPF hello packets from RTB

    D. RTA will send OSPF updates, but will not establish an adjacency with RTB


    参考答案:A

  • 第19题:

    Refer to the exhibit. What can be determined about the router from the console output?()

    A.No configuration file was found in NVRAM.

    B.No configuration file was found in flash.

    C.No configuration file was found in the PCMCIA card.

    D.Configuration file is normal and will load in 15 seconds.


    参考答案:B

  • 第20题:

    Refer to the exhibit. Which two statements are true about the partial configuration that is shown?()

    • A、Hosts connected to the FastEthernet0/1 interface will not receive DHCP replies from the router
    • B、The first DHCP client to connect to the FastEthernet 0/1 interface will receive the IP address10.10.0.1
    • C、The first DHCP client to connect to the FastEthernet 0/0 interface will receive the IP address10.0.0.1
    • D、DHCP requests received on the FastEthernet 0/1 interface will be forwarded to 10.0.0.2
    • E、The first DHCP client to connect to the FastEthernet 0/0 interface will receive the IP address10.0.0.6

    正确答案:A,E

  • 第21题:

    Refer to the exhibit. The DHCP configuration that is shown is configured on a Cisco router. Whichstatement is true?()

    • A、The router will distribute IP addresses from pool 1 until its addresses are exhausted. Then therouter will begin distributing addresses from pool 2
    • B、The configuration is invalid because the DHCP options are global configuration commands
    • C、The configuration is incomplete until the DHCP pools are bound to the appropriate interface orinterfaces
    • D、The router will choose which pool to use based upon the interface the DHCP request wasreceived on

    正确答案:D

  • 第22题:

    单选题
    Refer to the exhibit. An administrator pings the default gateway at 10.10.10.1 and sees the output as shown. At which OSI layer is the problem?()
    A

    data link layer

    B

    application layer

    C

    access layer

    D

    session layer

    E

    network layer


    正确答案: E
    解析: 暂无解析

  • 第23题:

    单选题
    Refer to the exhibit. The DHCP configuration that is shown is configured on a Cisco router. Whichstatement is true?()
    A

    The router will distribute IP addresses from pool 1 until its addresses are exhausted. Then therouter will begin distributing addresses from pool 2

    B

    The configuration is invalid because the DHCP options are global configuration commands

    C

    The configuration is incomplete until the DHCP pools are bound to the appropriate interface orinterfaces

    D

    The router will choose which pool to use based upon the interface the DHCP request wasreceived on


    正确答案: A
    解析: 暂无解析