What is the most likely reason for the dispartly between the actual network numbers at the branches and the routes in the routing table on Gateway－Router?()A. Branch-Router2 is configured to send both RIPv1 and RIPv2 updates.B. Gateway-Router is configure

题目
What is the most likely reason for the dispartly between the actual network numbers at the branches and the routes in the routing table on Gateway－Router?()

A. Branch-Router2 is configured to send both RIPv1 and RIPv2 updates.

B. Gateway-Router is configured to only receive RIPv2 updates.

C. Gateway-router is configured to receive only RIPv1 updates.

D. Branch-Router1 is configured to only send RIPv1 updates

相似考题

1.In what location are EIGRP successor routes stored?()A. In the routing table only.B. In the neighbor table only.C. In the topology table only.D. In the routing table and neighbor table.E. In the routing table and topology table.F. In the topology table and neighbor table.

2.Refer to the exhibit. Which two statement s are correct?()A. All the routes were redistributed into BGP from an IGPB. All the routes were originated by BGP with the network commandC. All six routes will be installed in the routing tableD. Four routes will be installed in the routing ta bleE. Two routes will be installed in the routing table

3.What is the most likely reason that an IBGP route that has been selected as a best route is not entered into the IP routing table?（）A、Route reflectors are not passing updates properly.B、BGP synchronization has been enabled.C、The next-hop address is unreachable.D、No loopback interface has been configured on a router.

4.What are some of the characteristics of the OSPF routing protocol?()A. It confines network instability to a single area of network.B. It increases the routing overhead of the networkC. It supports VLSMD. It routes between Autonomous Systems.E. It allows extensive control of routing updatesF. None of the above

更多“What is the most likely reason for the dispartly between the actual network numbers at the branches and the routes in the routing table on Gateway－Router?() ”相关问题

  • 第1题：

    What are some of the characteristics of the OSPF routing protocol?（）

    • A、It confines network instability to a single area of network.
    • B、It increases the routing overhead of the network
    • C、It supports VLSM
    • D、It routes between Autonomous Systems.
    • E、It allows extensive control of routing updates
    • F、None of the above

    正确答案:A,C,E

  • 第2题：

    What is a reason for implementing MPLS in a network？（）

    • A、MPLS eliminates the need of an IGP in the core.
    • B、MPLS reduces the required number of BGP-enabled devices in the core.
    • C、Reduces routing table lookup since only the MPLS core routers perform routing table lookups.
    • D、MPLS eliminates the need for fully meshed connections between BGP enabled devices.

    正确答案:B

  • 第3题：

    When attempting to view the OSPF routes in the routing table, you issue the command show route table inet.3 but no OSPF routes are displayed. What is the problem?（）

    • A、The OSPF routes are located in the inet4.0 routing table.
    • B、The OSPF routes are located in the inet.0 routing table.
    • C、The OSPF routes are located in the inet.2 routing table.
    • D、The OSPF routes are located in the inet4.3 routing table.

    正确答案:B

  • 第4题：

    What is the most likely reason for the dispartly between the actual network numbers at the branches and the routes in the routing table on Gateway-Router?（）

    • A、Branch-Router2 is configured to send both RIPv1 and RIPv2 updates.
    • B、Gateway-Router is configured to only receive RIPv2 updates.
    • C、Gateway-router is configured to receive only RIPv1 updates.
    • D、Branch-Router1 is configured to only send RIPv1 updates

    正确答案:D

  • 第5题：

    What does a router do if it has no EIGRP feasible successor route to a destination network and the successor route to that destination network is inactive status?（）

    • A、It routes all traffic that is addresses to the destination network to the interface indicates in the routing table.
    • B、It sends a copy of its neighbor table to all adjacent routers.
    • C、It sends a multicast query packet to all adjacent neighbors requesting available routing paths to the destination network.
    • D、It broadcasts Hello packets to all routers in the network to re-establish neighbor adjacencies.

    正确答案:C

  • 第6题：

    What is the role of route preference?（）

    • A、It is used as a tie breaker when the same prefix is available through multiple sources
    • B、It is used to determine which routes to accept into the routing table
    • C、It is used to select the best route between multiple equal-cost paths
    • D、It is used to select which routing table to use for forwarding

    正确答案:A

  • 第7题：

    多选题
    Refer to the exhibit. Which two statements are correct？ （Choose two.）（）
    A

    All six routes will be installed in the routing table.

    B

    Two routes will be installed in the routing table.

    C

    Four routes will be installed in the routing table.

    D

    All the routes were redistributed into BGP from an IGP.

    E

    All the routes were originated by BGP with the network command.


    正确答案： C,B
    解析： 暂无解析

  • 第8题：

    单选题
    In what location are EIGRP successor routes stored?（）
    A

    In the routing table only.

    B

    In the neighbor table only.

    C

    In the topology table only.

    D

    In the routing table and neighbor table.

    E

    In the routing table and topology table.

    F

    In the topology table and neighbor table.


    正确答案： A
    解析： 暂无解析

  • 第9题：

    单选题
    When attempting to view the OSPF routes in the routing table, you issue the command show route table inet.3 but no OSPF routes are displayed. What is the problem?（）
    A

    The OSPF routes are located in the inet4.0 routing table.

    B

    The OSPF routes are located in the inet.0 routing table.

    C

    The OSPF routes are located in the inet.2 routing table.

    D

    The OSPF routes are located in the inet4.3 routing table.


    正确答案： C
    解析： 暂无解析

  • 第10题：

    多选题
    What are some of the characteristics of the OSPF routing protocol?（）
    A

    It confines network instability to a single area of network.

    B

    It increases the routing overhead of the network

    C

    It supports VLSM

    D

    It routes between Autonomous Systems.

    E

    It allows extensive control of routing updates

    F

    None of the above


    正确答案： D,B
    解析： 暂无解析

  • 第11题：

    多选题
    While troubleshooting a routing problem on the company EIGRP network you discover that one ofthe routers is failing to establish adjacencies with its neighbor. What is a likely cause of thisproblem between neighbors？（）
    A

    The K-values do not match

    B

    The hold times do not match

    C

    The hello times do not match

    D

    The AS numbers do not match


    正确答案： A,C
    解析： 暂无解析

  • 第12题：

    单选题
    What is the most likely reason that an IBGP route that has been selected as a best route is not entered into the IP routing table?（）
    A

    Route reflectors are not passing updates properly.

    B

    BGP synchronization has been enabled.

    C

    The next-hop address is unreachable.

    D

    No loopback interface has been configured on a router.


    正确答案： C
    解析： 暂无解析

  • 第13题：

    While troubleshooting a routing problem on the company EIGRP network you discover that one ofthe routers is failing to establish adjacencies with its neighbor. What is a likely cause of thisproblem between neighbors？（）

    • A、The K-values do not match
    • B、The hold times do not match
    • C、The hello times do not match
    • D、The AS numbers do not match

    正确答案:A,D

  • 第14题：

    In what location are EIGRP successor routes stored?（）

    • A、In the routing table only.
    • B、In the neighbor table only.
    • C、In the topology table only.
    • D、In the routing table and neighbor table.
    • E、In the routing table and topology table.
    • F、In the topology table and neighbor table.

    正确答案:E

  • 第15题：

    What is the default import routing policy for OSPF?（）

    • A、Accept all OSPF routes and install them into the inet.3 routing table.
    • B、Accept all OSPF routes and install them into the inet7.0 routing table.
    • C、Accept all OSPF routes and install them into the inet4.0 routing table.
    • D、Accept all OSPF routes and install them into the inet.0 routing table.

    正确答案:D

  • 第16题：

    Which of the following answers is the least likely reason for an engineer to choose to use route redis tribution?（）

    • A、To exchange routes between merged companies
    • B、To give separate control over routing to different parts of one company
    • C、To support multiple router vendors
    • D、To knit together an OSPF area if the area becomes discontiguous

    正确答案:D

  • 第17题：

    What is the role of route preference?（）

    • A、It is used to determine which route should become active.
    • B、It is used to select which routing table to use for forwarding.
    • C、It is used to determine what routes to accept into the routing table.
    • D、It is used to select the best route between multiple equal cost paths.

    正确答案:A

  • 第18题：

    When attepting to view the OSPF routes in the routing table, you issue the command show route table inet but no OSPF routes are displayed. What is the problem?（）

    • A、The OSPF routes are located in the inet 4 routing table
    • B、THe OSPF routes are located in the inet 0 routing table
    • C、The OSPF routes are located in the inet 2 routing table
    • D、The OSPF routes are located in the inet 4.3 routing table

    正确答案:B

  • 第19题：

    单选题
    What is the role of route preference?（）
    A

    It is used to determine which route should become active.

    B

    It is used to select which routing table to use for forwarding.

    C

    It is used to determine what routes to accept into the routing table.

    D

    It is used to select the best route between multiple equal cost paths.


    正确答案： A
    解析： 暂无解析

  • 第20题：

    单选题
    When attepting to view the OSPF routes in the routing table, you issue the command show route table inet but no OSPF routes are displayed. What is the problem?（）
    A

    The OSPF routes are located in the inet 4 routing table

    B

    THe OSPF routes are located in the inet 0 routing table

    C

    The OSPF routes are located in the inet 2 routing table

    D

    The OSPF routes are located in the inet 4.3 routing table


    正确答案： D
    解析： 暂无解析

  • 第21题：

    单选题
    What is the most likely reason for the dispartly between the actual network numbers at the branches and the routes in the routing table on Gateway-Router?（）
    A

    Branch-Router2 is configured to send both RIPv1 and RIPv2 updates.

    B

    Gateway-Router is configured to only receive RIPv2 updates.

    C

    Gateway-router is configured to receive only RIPv1 updates.

    D

    Branch-Router1 is configured to only send RIPv1 updates


    正确答案： D
    解析： 暂无解析

  • 第22题：

    单选题
    What is the default import routing for OSPF?（）
    A

    Accept all OSPF routes and install them into the 3 routing table

    B

    Accept all OSPF routes and install them into the inet7.0 routing table

    C

    Accept all OSPF routes and install them into the inet4.0 routing table

    D

    Accept all OSPF routes and install them into the inet.0 routing table


    正确答案： D
    解析： 暂无解析

  • 第23题：

    多选题
    Half of your network uses RIPv2 and the other half runs OSPF. The networks do not communicate with each other. Which two of these factors describe the impact of activating EIGRP over each separate part？（）
    A

    EIGRP will not be accepted when configured on the actual RIPv2 routers.

    B

    OSPF will no longer be used in the routing table， because you only have EIGRP internal routes running.

    C

    OSPF will no longer be used in the routing table， because you only have EIGRP external routes running.

    D

    RIPv2 will populate its RIP database but not its routing table， because you only have EIGRP external routes running.

    E

    RIPv2 will populate its RIP database but not its routing table， because you only have EIGRP internal routes running.

    F

    OSPF database will have RIPv2 routes.


    正确答案： D,E
    解析： 暂无解析

相关内容