c=d
l and k are parallel
m and l are perpendicular
第1题:
Which of the following statements is FALSE,concerning the regulations pertaining to the cylinder room of a fixed CO2 fire extinguishing system ________.
A.The compartment must be properly ventilated
B.The temperature of the room should never exceed 130℉
C.The door must be kept unlocked
D.The compartment shall be clearly marked and identifiable
第2题:
Which of the following statements is TRUE about the primary system dump device?()
第3题:
Which of the following statements is TRUE concerning the po column of the vmstat command?()
第4题:
Which of these statements concerning the collection interfaces are true?()
第5题:
They are particularly suited for pumping high viscosity fluids
They are started with the discharge valve opened
The flow of liquid is developed by imparting energy due to the rotation of an impeller
They are always mounted in a horizontal position
第6题:
A must contain all of the characters defined in B
A must be Unicode
The encoded values in A must match the encoded values in B for all characters defined in B
A must be a multibyte character set
The encoded values in A must match the encoded values in B for all numeric and alphabetic character
第7题:
τ(5) =τ(7)
τ(5) τ(7) =τ(35)
τ(5) + τ(7) =τ(12)
第8题:
The sys is high when po is high.
The po represents the number of page steals.
The low values usually indicate insufficient paging space.
The low values usually indicate sufficient memory for the load.
第9题:
All OSPF networks require the use of multiple areas
Multiple OSPF areas must connect to area 0
Single area OSPF networks must be configured in area 1
Areas can be assigned any number from 0 to 63535
Area 0 is called the backbone area
Each OSPF area need to be configured with a loopback interface
第10题:
A must contain all of the characters defined in B
A must be Unicode
The encoded values in A must match the encoded values in B for all characters defined in B
A must be a multibyte character set
The encoded values in A must match the encoded values in B for all numeric and alphabetic characters in B
第11题:
It is shared.
It must be /dev/hd6.
It must be an internal disk.
It can be an external device.
第12题:
High conductivity of the distillate indicates distillate salinity is excessive
Increasing the absolute pressure of the shell will increase the distillers capacity
Mesh separators are used in evaporators to filter the distillate
Reducing the brine density will reduce the heat lost overboard
第13题:
Which statements concerning the switch construct are true?()
第14题:
Which statement is true regarding the INTERSECT operator?()
第15题:
Which of the following statements is true regarding implementing Live Partition Mobility on two existing POWER6 based systems?()
第16题:
Given two different character sets (A and B), which of the following must be true for A to be considered a strict superset of B?()
第17题:
p + q is even
pq is odd
p2-q2 is even
第18题:
The systems must use internal storage for boot purposes.
All virtualized ethernet adapters must be numbered below 10.
The mobile partition's network and disk access must be virtualized.
Each system must be controlled by a different Hardware Management Console (HMC).
第19题:
an increase in the exhaust temperature of the affected cylinder
the turbocharger may surge
the explosion pressure in all cylinders will rise violently
smoke from the turbocharger air inlet filter will be seen
第20题:
The systems must use internal storage for boot purposes.
All virtualized Ethernet adapters must be numbered below 10.
The mobile partition’s network and disk access must be virtualized.
Each system must be controlled by a different Hardware Management Console (HMC).
第21题:
Henry Ford influenced our lives.
Henry Ford influenced historians.
Henry Ford influenced all manufacturing.
第22题:
NAT provides 1 to manyaddress mapping.
NAT provides 1 to 1 address mapping.
NAT is only useful forTCP/UDP and ICMP traffic.
NAT can be used for all IP traffic.
第23题:
It ignores NULL values
Reversing the order of the intersected tables alters the result
The names of columns in all SELECT statements must be identical
The number of columns and data types must be identical for all SELECT statements in the query