R1 is currently advertising prefixes 1.0.0.0/8, 2.0.0.0/8, and 3.0.0.0/8 over its eBGP connection to neighbor 2.2.2.2 (R2). An engineer configures a prefix list (fred) on R1 that permits only 2.0.0.0/8 and then enables the filter with the neighbor R2 prefix- list fred out command. Upon exiting configuration mode, the engineer uses some show commands on R1, but no other commands.Which of the following is true in this case?()
A. The show ip bgp neighbor 2 .2.2.2 received -routes command lists the three original prefixes.
B. The show ip bgp neighbor 2.2.2.2 advertised - routes command lists the three original prefixes.
C. The show ip bgp neighbor 2.2.2.2 routes command lists the three original prefixes.
D. T he show ip bgp neighbor 2.2.2.2 routes command lists only 2.0.0.0/8.
E. The show ip bgp neighbor 2.2.2.2 advertised - routes command lists only 2.0.0.0/8.
第1题:
A. eBGP Multipath
B. eBGP Multihop
C. BGP Synchronization
D. Public AS numbers
第2题:

A. permits only the 10.0.0.0/8 prefix to be advertised to the 10.1.1.1 neighbor
B. marks all prefixes received fro m the 10.1.1.1 neighbor with a MED of 200
C. marks the 10.0.0.0/8 prefix advertised to the 10.1.1.1 neighbor with a MED of 200
D. permits only the 10.0.0.0/8 prefix to be received from the 10.1.1.1 neighbor
E. marks all prefixes advertised to the 10.1.1 .1 neighbor with a MED of 200
F. marks the 10.0.0.0/8 prefix received from the 10.1.1.1 neighbor with a MED of 200
第3题:
两个电阻R1=4Ω,R2=8Ω,其并联的总电阻值是()。
第4题:
执行ARM指令MOV R0,R1,LSL#3后,R0的值为()。
第5题:
Which BGP option i s required when load sharing over multiple equal - bandwidth parallel links from a single CE router to a single ISP router over eBGP?()
第6题:
已知R1=8,R0=9,执行指令MOV R0,R1,LSR#3后,R0的值为()。
第7题:
Which of these best identifies the types of prefixes a router running BGP will advertise to an EBGP peer?()
第8题:
Router R1 exists in an Enterprise that uses EIGRP as its routing protocol. The show ip route command output on router R1 lists the following phrase: "Gateway of last resort is 1.1.1.1 to network 2.0.0.0". Whic h of the following is most likely to have caused this output to occur on R1?()
第9题:
2345:0:0:8::1
2345:0:0:8:0:FF:FE11:1111
FE80::8:0:FF:FE11:1111
FE80:0:0:8::1
第10题:
prefixes received from any other BGP peer and prefixes locally originated via network statements or redistributed to BGP
all prefixes in its IP routing table
only prefixes received from EBGP peers and prefixes locally originated via network statements or redistributed
only prefixes received from EBGP peers and prefixes received from route reflectors
all prefixes in its routing table except the prefixes received from other EBGP peers
all prefixes in its routing table except the prefixes received from other IBGP peers
第11题:
The show ip bgp neighbor 2 .2.2.2 received -routes command lists the three original prefixes.
The show ip bgp neighbor 2.2.2.2 advertised - routes command lists the three original prefixes.
The show ip bgp neighbor 2.2.2.2 routes command lists the three original prefixes.
T he show ip bgp neighbor 2.2.2.2 routes command lists only 2.0.0.0/8.
The show ip bgp neighbor 2.2.2.2 advertised - routes command lists only 2.0.0.0/8.
第12题:
prefixes received from any other BGP peer and prefixes locally originated via network statements or redistributed
all prefixes in its routing table
prefixes received from EBGP peers and prefixes locally originated via network statements or redistributed
prefixes received from EBGP peers and prefixes received from route reflectors
prefixes received from other IBGP peers, prefixes received from EBGP peers, and prefixes redistributed to BGP
prefixes received from other IBGP peers and prefixes received from route reflectors
第13题:

A. Router R2 will be preferred because it has the higher neighbor IP address.
B. Router R2 will be preferr ed because its neighbor has a lower autonomous system number.
C. Router R1 will be preferred because it has a lower local preference.
D. Router R2 will be preferred because it has a higher local preference.
E. Router R1 will be preferred because its nei ghbor has the higher autonomous system number.
F. Router R1 will be preferred because it has the lower neighbor IP address.
第14题:
Routers R1 and R2, currently EIGRP neighbors over their Fa0/0 interfaces (respectively),both use EIGRP authentication. Tuesday at 8 p.m. the neighborship fails.Which of the following wo uld not be useful when investigating whether authenticationhad anything to do with the failure?()
A. debug eigrp packet
B. show key chain
C. show ip eigrp neighbor failure
D. show clock
第15题:
指令解析:STR R0,[R1],#8
第16题:
Which of these best identifies the types of prefixes a router running BGP will advertise to an EBGP peer? ()
第17题:
电阻R1=8Ω,R2=8Ω,两电阻串联之后,等效电阻等于()Ω。
第18题:
Which types of prefixes will a router running BGP most likely advertise to an IBGP peer, assuming it is not configured as a route reflector?()
第19题:
Routers R1 and R2, currently EIGRP neighbors over their Fa0/0 interfaces (respectively),both use EIGRP authentication. Tuesday at 8 p.m. the neighborship fails. Which of the following wo uld not be useful when investigating whether authenticationhad anything to do with the failure?()
第20题:
R1 is currently advertising prefixes 1.0.0.0/8, 2.0.0.0/8, and 3.0.0.0/8 over its eBGP connection to neighbor 2.2.2.2 (R2). An engineer configures a prefix list (fred) on R1 that permits only 2.0.0.0/8 and then enables the filter with the neighbor R2 prefix- list fred out command. Upon exiting configuration mode, the engineer uses some show commands on R1, but no other commands. Which of the following is true in this case?()
第21题:
第22题:
Configure R1 with the network 130.1.16.0 mask 255.255.240.0 command.
Configure R1 with the network 130.1.16 .0 mask 255.255.240.0 summaryonly command.
Redistribute from OSPF into BGP, filtering so that only routes in the 130.1.16.0/20 range are redistributed.
Redistribute from OSPF into BGP, filtering so that only routes in the 130.1.16.0/20 range are redistributed, and create a BGP summary for 130.1.16.0/20.
第23题:
prefixes received from any other BGP peer and prefixes locally originated via networkstatements or redistributed
all prefixes in its routing table
prefixes received from EBGP peers and prefixes locally originated via network statements or redistributed
prefixes received from EBGP peers and prefixes received from route reflectors
prefixes received from other IBGP peers, prefixes received from EBGP peers,and prefixes redistributed to BGP
prefixes received from other IBGP peers and prefixes received from route reflectors
第24题:
R1 has been configured with an ip default- network 2.0.0.0 command.
R1 has been configured with an ip route 0.0.0.0 0.0.0.0 1.1.1.1 command.
R1 has been configured with an ip route 2.0.0.0 255.0.0.0 1.1.1.1 command.
Another router has been configured with an ip default - network 2.0.0.0 command.
Another router has been configured with an ip route 2.0.0.0 255.0.0.0 1.1.1.1 command.