A. ISDN
B. Frame Relay
C. ATM
D. FDDI
第1题:
A. Transport layer divides a data stream into segments & adds reliability & flow control information
B. Data link layer adds physical source & destination address & an FCS to the segment
C. Packets are created when the network layer encapsulate a frame with source & destination host address& protocol related control information
D. Packets are created when the network layers adds layers 3 address & control information to a segment
E. The presentation layer translated bits into bits into voltages for transmission across the physical link
第2题:
A. HDLC
B. NCP
C. PAP
D. LAPD
E. LAPB
F. None of the above
第3题:
第4题:
WAN data link encapsulation types include which of the following?()
第5题:
Which of the following correctly describe steps in the OSI data encapsulation process?()
第6题:
Which of the following is the correct configuration for a RAID 5 array?()
第7题:
As a frame leaves a Layer 3 device, the Layer 2 encapsulation information is changed from what it was when it entered the devicE.For what two reasons can this happen? ()
第8题:
Which two statements are true regarding the USING and ON clauses in table joins?()
第9题:
Transport layer divides a data stream into segments & adds reliability & flow control information
Data link layer adds physical source & destination address & an FCS to the segment
Packets are created when the network layer encapsulate a frame with source & destination host address& protocol related control information
Packets are created when the network layers adds layers 3 address & control information to a segment
The presentation layer translated bits into bits into voltages for transmission across the physical link
第10题:
HDLC
NCP
PAP
LAPD
LAPB
None of the above
第11题:
The transport layer divides a data stream into segments and may add reliability and flow control information.
The data link layer adds physical source and destination addresses and an FCS to the segment.
Packets are created when the network layer encapsulates a frame with source and destination host addresses and protocol-related control information.
Packets are created when the network layer adds Layer 3 addresses and control information to a segment.
The presentation layer translates bits into voltages for transmission across the physical link.
第12题:
In each data center, deploy one Hub Transport server. Create and configure one Send connector.
In each data center, deploy two Hub Transport servers. Create and configure one Send connector.
In each data center, deploy one Edge Transport server. Create and configure two Send connectors.
In each data center, deploy two Edge Transport servers. Create and configure two Send connectors.
第13题:
A. T1
B. Frame Relay
C. DSL
D. PPP
E. ISDN
F. IPX
第14题:
根据下面的文字资料回答 71~75 题 connected by( 1 )or Hubs,which just move the bits from one network to an identical network. One layer up we find bridgas and swiehes,which operate at data link layer. They can accept ( 2 ) , examine the MAC address, and forward the frames to a different network while doing minor protocol translation in the process. In the network layer,we have touters that can connect two netwoks. If two networks have( 3 )network layer,the router may be able to translate between the packet formats. In the transport layer we find transport gateway, which cart interface between the two transport connections. Finally, in the application layer, application gateways translate message( 4 ). As an example,gateways between Internet e-mail and X.400 e-mail must ( 5 )the e-mail message and change various header fields.
第6题:文中( 1 )处正确的答案是( )。
A.reapers
B.relays
C.connects
D.modems
网络可以用不同的设备互联。在物理层,用中继器或者集线器互联,这些设备只是在相同的网络之间传送比特串。在上面的数据链路层,可以使用网桥或者交换机,这些设备接收数据帧,检查MAC地址,并可以实瑰少量的协议转换,把数据帧转发到不同的网络中。在网络层,使用路由器连接两个网络。如果两个网络的网络层不同,路由器能够对分组格式进行转换。在传输层,使用传输网关,它可以在两个传输连接之间建立接口。最后,在应用层,应用网关实现消息语法之间的翻译。例如,在Internet邮件和X.400邮件之间的网关可以对邮件报文进行语法分析,对报文的各个头字段做出改变。
第15题:
Which two statements are correct about the signaling methods that are utilized for transmitting voice? ()
第16题:
Which WAN service utilizes two different encapsulation types (one for data and one for signaling) on its data link layer?()
第17题:
Which one of the WAN data-link protocols below is used for out-of-band signaling?()
第18题:
Your Service Provider does not support Link Fragmentation and Interleave, but upstream serialization delay on your broadband link is affecting voice quality. Which two mitigation strategies are viable?()
第19题:
Which three Layer 2 encapsulation types would be used on a WAN rather than a LAN? ()
第20题:
Your network contains two data centers named Datacenter1 and Datacenter2. An Active Directory site exists for each data center. The data centers connect to the Internet by using a direct link. The data centers connect to each other by using a high-speed WAN link. You plan to deploy Exchange Server 2010 Mailbox servers in both data centers. You need to plan message routing to meet the following requirements:.Ensure outbound delivery of e-mail messages if a single server fails .Automatically load balance the Hub Transport server in each site .Deploy the minimum number of servers What should you include in the plan?()
第21题:
T1
Frame Relay
DSL
PPP
ISDN
IPX
第22题:
Channel-associated signaling transmits control signals in band and therefore reduces the bandwidth available for the voice data stream.
Channel-associated signaling utilizes a separate TDM channel for transmitting control signals.
Common channel signaling transmits control signals in band and therefore reduces the bandwidth available for the voice data stream.
Common channel signaling uses one of the TDM channels to transmit control information reducing the number of channels available for voice.
ISDN BRIs implement channel-associated signaling.
第23题:
HDLC
Ethernet
Token Ring
PPP
FDDI
Frame Relay