During a recent OSPF election among three routers, RTA was elected the DR and RTB was elected the BDR, as seen in the graphic. Assume that RTA fails, and that RTB takes the place ofthe DR whi le RTC becomes the new BDR. What will happen when RTA comes back online?()

A. A new election will take place establishing an all new DR and BDR based on configured priority levels and MAC addresses.
B. RTA will take the place of DR immediately upon esta blishing its adjacencies.
C. RTA will take the place of DR only if RTB fails.
D. RTA will take the place of DR only if both RTB and RTC fail.
第1题:

A. RTA will not establish an OSPF adjacency w ith RTB
B. RTA will send OSPF hello packets, but will not send OSPF updates
C. RTA will not accept OSPF hello packets from RTB
D. RTA will send OSPF updates, but will not establish an adjacency with RTB
第2题:
Refer to the exhibit. Router RTA is the hub router for routers RTB and RTC. The Frame Relay network is configured with EIGRP, and the entire network is in autonomous system 1. However,router RTB a nd RTC are not receiving each other‘s routes. What is the solution?()

A.Check and change the access lists on router RTA
B.Configure the auto summary command under router eigrp 1 on router RTA
C.Configure subinterfaces on the spoke routers and assig n different IP address subnets for each subinterface
D.Issue the no ip split horizon command on router RTA
E.Issue the no ip split horizon eigrp 1 command on router RTA
F.Configure a distribute list on router RTA that allows it to advertise all r outes to the spoke routers
第3题:
A.RTB到RTA没有单播路由
B.RTA路由器学习不到RP信息
C.RTA和RTB没有组播路由
D.RTA学习到的RP不是RTB
第4题:
RTA和RTB运行OSPF路由协议,RTA和RTB通过Broadcast链路互连并建立了邻接关系,则RTATA和RTB在建立邻接关系的过程中会经过的状态机类型有()。
第5题:
在组播网络中,RTA 为主BSR 与主RP,RTB 为备BSR 与备RP,那么RTA、RTB 的C-BSR、C-RP 的优先级应该如何设置()
第6题:
两台MSR路由器RTA和RTB通过192.168.1.0/20网段互联,现在对两台路由器执行如下命令: [RTA]ospf1 [RTA-ospf-1]area 0 [RTA-ospf-1-area-0.0.0.0]network 192.168.1.0 0.0.0.255 [RTB]ospf 100 [RTB-ospf-100]area 1 [RTB-ospf-100-area-0.0.0.1]network 192.168.1.0 0.0.0.255 从以上配置可以判断()。
第7题:
某运行OSPF路由协议的网络,Area1包含内部路由器RTA和区域边界路由器RTB,RTA和RTB直接相连;RTB已经可以正确地同其他区域的路由器建立邻接关系,但RTA始终无法学习到其他区域内的路由,则可能的原因有()。
第8题:
RTA和RTB属于同一AS的不同OSPF区域,而且RTA和RTB均不是ABR,RTA引入一条到达1.1.1.1/32的外部路由,则在RTB计算到1.1.1.1/32网段的路由的过程中,一定会用到的LSA有()。
第9题:
What is the purpose of the OSPF router ID in a OR/BOR election?()
第10题:
An etwork administrator has enabled OSPF across an NBMA network and has issued the command ip ospf network nonbroadcast. Given those facts, which two statements are true?()
第11题:
FULL
DOWN
TWO WAY
ATTEMP
第12题:
RTB到RTA没有单播路由
RTA路由器学习不到RP信息
RTA和RTB没有组播路由
RTA学习到的RP不是RTB
第13题:

A. Dev - 1 is the DR because it has a lower OSPF router ID
B. Dev - 3 is the DR because it has a higher OSPF router priority
C. Both Dev - 1 and Dev - 3 are using the def ault OSPF router priority
D. Dev - 3 is the DR because it has a lower OSPF router ID
E. Dev - 1 is the DR because it has a higher OSPF router priority
第14题:
The internetwork infrastructure of company XYZ consists of a single OSPF area as shown in the graphic. There is concern that a lack of router resources is impeding internetwork performance. As part of examining the router resources, the OSPF DRs need to be known. All the router OSPF priorities are at the default and the router IDs are shown with each router. Which routers are likely to have been elected as DR?()

A.Corp-1
B.Corp-2
C.Corp-3
D.Corp-4
E.Branch-1
F.Branch-2
第15题:
第16题:
RTA的Ethernet0/0和RTB的Ethernet0/0接到同一个局域网中并开启VRRP,同时创建一个虚拟路由器,ID为1,虚拟IP地址为10.1.1.254。RTA的Priority为200,RTB的Priority为缺省值。在RTB上用命令display vrrp interfaceEthernet0/0,看到:?Preempt:YESDelay:5?下面关于上述信息描述正确的是:()
第17题:
RTA与RTB运行OSPF路由协议,且都属于骨干区域。采用如下哪些方法能够将RTA的直连路由192.168.1.0/24发布到OSPF路由域中?()
第18题:
RTA和RTB属于同一OSPF区域,RTA引入一条到达1.1.1.1/32的外部路由,则在RTB计算到1.1.1.1/32网段的路由的过程中,一定会用到的LSA有()。
第19题:
两台路由器RTA、RTB的串口S0用一条链路连接,链路协议位PPP,两各接口的网络类型均为point-to-point,此时接口与链路均为UP,配置该网段: RTA(config-if-serial0)#ipaddress 10.10.10.1 255.255.0.0; RTA(config-router-ospf)#network 10.10.10.10.0.0.0area 1; RTB(config-if-serial0)#ipaddress 10.10.10.2 255.255.255.0; RTB(config-router-ospf)#network 10.10.10.20.0.0.0area 1; RTA(config)#showipospfneighbour RTA邻居状态机最终状态()
第20题:
What are three characteristics of the OSPF routing protocol?()
第21题:
路由器A的配置如下:[RTA]aaa[RTA-aaa]_local-userhuaweipasswordcipherhello_[RTA-aaa]_local-userhuaweiservice-typeppp[RTA]interfaceSerial0[RTA-Serial0]link-protocolppp[RTA-Serial0]_pppauthentication-modepap[RTA-Serial0]ipaddress10.1.1.130路由器B的配置如下:[RTB]interfaceSerial0[RTB-Serial0]link-protocolppp[RTB-Serial0]_pppchapuserhuawei[RTB-Serial0]_pppchappasswordcipherhello[RTB-Serial0]ipaddress10.1.1.230当两台路由器Serial0相连时,两台路由器可以连接到对端。
第22题:
路由器RTA与RTB之间建立了BGP连接并互相学习到了路由RTA与RTB都使用缺省定时器如果路由器间链路拥塞,导致RTA收不到RTB发出的Keepalive消息,则会发生以下哪个后果()
第23题:
point-to-point
Backbone area 0
Broadcast multicast
Non-broadcast multi-access
The DR/BDR process is done for all interface types