The 192.168.0.0 network is not being propagated throughout the network. Observe the BGP configuration commands from the advertising router.What is the reason the 192.168.0.0 route is not being advertised? ()

A. The network 192.168.0.0 statement is missing mask 255.255.0.0
B. The network 192.168.0.0 statement is missing mask 0.0.255.255.
C. The network 10.0.0.0 statement is missing mask 255 .0.0.0.
D. The network 10.0.0.0 statement is missing mask 0.255.255.255.
E. The auto - summary configuration is missing.
第1题:
You are an administrator of a switched network and your goal is to reduce some of the administrative overhead on your network. You plan on achieving this by configuring a new VLAN for each department in your network. However, you need to share the VLAN information across numerous switches throughout your network. Which of the following would allow you accomplish this?()
第2题:
Which statement is true about TCN propagation?()
第3题:
You have a router running BGP for the MPLS network and OSPF for the local LAN network at the sales office. A route is being learned from the MPLS network that also exists on the OSPF local network. It is important that the router chooses the local LAN route being learned from the downstream switch running OSPF rather than the upstream BGP neighbor. Also, if the local OSPF route goes away, the BGP route needs to be used. What should be configured to make sure that the router will choose the LAN network as the preferred path?()
第4题:
You have a router running BGP for the MPLS network and OSPF for the local LAN network at the sales office. A route is being learned from the MPLS network that also exists on the OSPF local network.It is important that the router chooses the local LAN route being learned from the downstream switch running OSPF rather than the upstream BGP neighbor. Also,if the local OSPF route goes away,the BGP route needs to be used. What should be configured to make sure that the router will choose the LAN network as the preferred path?()
第5题:
Multicast is being deployed in the network, and only ip pim sparse-dense mode has been configured on all interfaces in the network to support a new video streaming application. No other multicast configuration was applied anywhere in the network. Since enabling multicast, the network monitoring tools show periodic spikes in link utilization throughout the network, even in areas where the video application is not being used. What could be a possible cause?()
第6题:
A technician needs to troubleshoot connectivity between two devices located on the same network. Which of the following BEST describes the type of protocol being used?()
第7题:
Clear the BGP session
Change both the inbound and outbound policy related to this route
Use the service-policy command to adjust the QOS policy to allow the route to propagate
Use the release BGP routing command
第8题:
The command establishes a static route.
The command invokes a dynamic routing protocol for 192.168.12.0.
Traffic for network 192.168.12.0 is forwarded to 172.16.12.1.
Traffic for all networks is forwarded to 172.16.12.1.
This route is automatically propagated throughout the entire network.
Trafficfor network 172.16.12.0 is forwarded to the 192.168.12.0 network.
第9题:
static route needs to be added
floating static route needs to be added
bgp backdoor command
ospf backdoor command
第10题:
Reduction of processing in wireless controllers
Distributed approach to authentication, encryption, and policy enforcement
Access point discovery, information exchange, and configuration
Provides security by blocking communication between access points and wireless clients
None of the other alternatives apply.
第11题:
The mls qos global configuration command must be entered before configuring AutoQoS.
CEF must be enabled.
The no auto qos voip command is used to disable Cisco AutoQos and revoke all configurations generated by Cisco AutoQos.
CDP must be enabled.
SNMP must be enabled.
第12题:
origin
router-ID
AS-path
local-preference
next-hop
第13题:
VOIP is being implemented on the Company network. In a properly designed network, what is the maximum amount of time a voice package should spend crossing a network? ()
第14题:
A company has a BGP network and a BGP route of 196.27.125.0/24 that should be propagated toall of the devices. The route is not now in any of the routing tables. The administrator determinesthat an access list is the cause of the problem. The administrator changes the access list to allowthis route, but the route still does not appear in any of the routing tables. What should be done topropagate this route?()
第15题:
LDAP is being utilized throughout the Company Wireless network. Which issue or set of issues does the Lightweight Access Point Protocol (LWAPP) address? ()
第16题:
Router 1 is configured for BGP as dual-homed on the Cisco network. Which three BGP attributes are carried in every BGP update on this router (both IBGP and EBGP)?()
第17题:
As a Network Engineer, you decide to apply Cisco enterprise solution throughout the CIS network. What are the two advantages? ()(Choose two.)
第18题:
The originator of the TCN immediately floods this information through the network.
The TCN propagation is a two step process.
A TCN is generated and sent to the root bridge.
The root bridge must flood this information throughout the network.
第19题:
STP
GVRP
SNMP
VTP
DHCP
第20题:
PPP and ATM
PPP and SDLC
ATM and HDLC
SDLC and HDLC
第21题:
static route needs to be added
floating static route needs to be added
bgp backdoor command
ospf backdoor command
第22题:
90 milliseconds
120 milliseconds
150 milliseconds
240 milliseconds
第23题:
IGP
EIGRP
EGP
BGP