Which two routing interface parameters are supported in OSPF implementations?()A. retransmit - intervalB. de ad - intervalC. stub areaD. virtual linkE. NSSA area

题目
Which two routing interface parameters are supported in OSPF implementations?()

A. retransmit - interval

B. de ad - interval

C. stub area

D. virtual link

E. NSSA area

相似考题

1.Which two statements are true about hierarchical architecture? ()(Choose two.)A. You can assign a logical interface to multiple zones.B. You cannot assign a logical interface to multiple zones.C. You can assign a logical interface to multiple routing instances.D. You cannot assign a logical interface to multiple routing instances.

2.Which two are NOT characteristics of the OSPF routing protocol?()A. It confines network instability to a single area of network.B. It increases the routing overhead of the networkC. It supports VLSMD. It routes between Autonomous Systems.E. It allows extensive control of routing updates

3.Which of the following data structures exist on a router for the OSPF routing protocol？（）A、OSPF topology tableB、OSPF interface tableC、OSPF routing information baseD、OSPF link-state databaseE、OSPF adjacency tableF、OSPF neighbor table

4.Refer to the exhibit. You have completed an OSPF implementation, and you are verifying OSPF operation. You notice that router A and router B are stuck in the two - way state. From the show ip ospf interface command output, what is the cause of this issue?（）A. All OSPF implementations must have at le ast one interface in area 0.B. You are attempting to run in the broadcast mode over an NBMA interface.C. Both routers are configured to function as a BDR; therefore, there is no DR router.D. Someone has changed the OSPF router ID; therefore you must clear the OSPF process.E. The OSPF priority is set to 0 on both routers; therefore neither can become the DR.

更多“Which two routing interface parameters are supported in OSPF implementations?() ”相关问题

  • 第1题：

    Which two statements are true about IS -IS routing?（）

    • A、Based on the default timers, OSPF d etects a failure faster than IS - IS does.
    • B、OSPF default timers permit more tuning than IS - IS does.
    • C、IS - IS is more efficient than OSPF in the use of CPU resources.
    • D、OSPF is more scalable than IS - IS because of its ability to identify normal, stub, an d NSSA areas.
    • E、IS - IS and OSPF are both Open Standard, link - state routing protocols which support VLSM.

    正确答案:C,E

  • 第2题：

    You are the top of hierarchy and must configure OSPF on inteface so-0/0/0 unit 100. Which two achieve this result?（）

    • A、set protocols   set ospf area 0   set interface so-0/0/0.100
    • B、set protocols ospf area 0 interface so-0/0/0.100
    • C、edit protocols ospf interface so-0/0/0.100
    • D、edit protocols ospf area 0   set interface so-0/0/0.100

    正确答案:B,D

  • 第3题：

    Which two statements are true about the role of split horizon？（）

    • A、It is a function used by routing protocols to install routes into routing table
    • B、It is a function that prevents the advertising of routes over an interface that the router is usingto reach a route
    • C、Its function is to help avoid routing loops.
    • D、It is a redistribution technique used by routing protocols

    正确答案:B,C

  • 第4题：

    Which two statements are correct about Nonstop Forwarding？（）

    • A、It allows the standby RP to take control of the device after a hardware or software fault on the active RP.
    • B、It is a Layer 3 function that works with SSO to minimize the amount of time a network is unavailable tousers following a switchover.
    • C、It is supported by the implementation of EIGRP， OSPF， RIPv2， and BGP protocols.
    • D、It synchronizes startup configuration， startup variables， and running configuration.
    • E、The main objective of NSF is to continue forwarding IP packets following a switchover.
    • F、Layer 2 802.1w or 802.1s must be used， as 802.1d cannot process the Layer 2 changes.
    • G、Routing protocol tuning parameters must be the same as the NSF parameters， or failover will beinconsistent.

    正确答案:B,E

  • 第5题：

    Which three route filtering statements are true?（）

    • A、After the router ospf 10  and passive - interface s0/0 commands have been issued , the s0/0 interface will not send any OSPF updates, but will receive routing updates on that interface
    • B、When you use the passive - interface command with RIPv2, multicasts are sent out the specified interface
    • C、After the router rip and passive -interface s0/0 commands have been issued, the s0/0 interface will not send any RIP updates, but will receive routing updates on that interface
    • D、When you use the passive - interface command with EIGRP, hel lo messages are not sent out the specified interface
    • E、After the router eigrp 10 and passive - interface s0/0 commands have been issued, the s0/0 interface will not send any EIGRP updates, but will receive routing updates on that interface
    • F、When you use the passive - interface command with OSPF, hello messages are not sent out the specified interface

    正确答案:C,D,F

  • 第6题：

    Which two PL/SQL8 features are supported in Oracle Forms?（）

    • A、methods 
    • B、object tables 
    • C、object columns 
    • D、collection types 
    • E、object as stored procedure parameters

    正确答案:B,C

  • 第7题：

    多选题
    Which of the following data structures exist on a router for the OSPF routing protocol？（）
    A

    OSPF topology table

    B

    OSPF interface table

    C

    OSPF routing information base

    D

    OSPF link-state database

    E

    OSPF adjacency table

    F

    OSPF neighbor table


    正确答案： B,D
    解析： 暂无解析

  • 第8题：

    多选题
    Which two PL/SQL8 features are supported in Oracle Forms?（）
    A

    methods

    B

    object tables

    C

    object columns

    D

    collection types

    E

    object as stored procedure parameters


    正确答案： B,A
    解析： 暂无解析

  • 第9题：

    多选题
    Which two of these steps are minimum requirements to configure OSPFv3 under IPv6？（）
    A

    Configure a routing process using the command ipv6 router ospf [process-id].

    B

    Add the network statement for the interfaces on which OSPF will run.

    C

    Configure OSPF on the interface that it will run on.

    D

    Use the passive-interface command on the interfaces on which OSPF should not run.

    E

    Enable routing.


    正确答案： D,A
    解析： 暂无解析

  • 第10题：

    多选题
    Which two Cisco AutoQoS interface statements are true？（）
    A

    AutoQoS is supported on Frame Relay multipoint subinterfaces.

    B

    AutoQoS is supported on low-speed ATM PVCs in point-to-point subinterfaces.

    C

    AutoQoS is supported on serial PPP and HDLC interfaces.

    D

    AutoQoS is supported only on Frame Relay main interfaces and not on any subinterface configuration.


    正确答案： D,B
    解析： 暂无解析

  • 第11题：

    多选题
    You are at the top of the hierarchy and must configure OSPF on interface so-0/0/0 unit 100. Which two achieve this result?（）
    A

    set protocols    set ospf area 0    set interface so-0/0/0.100

    B

    set protocols ospf area 0 interface so-0/0/0.100

    C

    edit protocols ospf interface so-0/0/0.100

    D

    edit protocols ospf area 0 set interface so-0/0/0.100


    正确答案： A,C
    解析： 暂无解析

  • 第12题：

    单选题
    A switch has been configured with two vlans and is connected to a router with a trunk for inter-vlan routing.OSPF has been configured on the router，as the routing protocol for the network.Which statement about thisnetwork is true？（）
    A

    For the two vlans to communicate，a network statement for the trunk interface needs to be added to the  OSPF configuration.

    B

    For the two vlans to communicate， a network statement for each subinterface needs to be  added  to the OSPF configuration.

    C

    Direct inter-vlan communication does not require OSPF

    D

    OSPF cannot be used if router-on-a-stick is configured on the router


    正确答案： B
    解析： 暂无解析

  • 第13题：

    A switch has been configured with two vlans and is connected to a router with a trunk for inter-vlan routing.OSPF has been configured on the router，as the routing protocol for the network.Which statement about thisnetwork is true？（）

    • A、For the two vlans to communicate，a network statement for the trunk interface needs to be added to the  OSPF configuration.
    • B、For the two vlans to communicate， a network statement for each subinterface needs to be  added  to the OSPF configuration.
    • C、Direct inter-vlan communication does not require OSPF
    • D、OSPF cannot be used if router-on-a-stick is configured on the router

    正确答案:C

  • 第14题：

    Which two design recommendations are most appropriate when OSPF is the data center core routing protocol？ （）

    • A、 Never use passive interfaces.
    • B、 Use NSSA areas from the core down.
    • C、 Use totally stub areas to stop type 3 LSAs.
    • D、 Use the lowest Ethernet interface IP address as the router ID.
    • E、 Tune OSPF timers to enable OSPF to achieve quicker convergence

    正确答案:B,E

  • 第15题：

    Which two design recommendations are most appropriate when OSPF is the data center core routing protocol? （）

    • A、Never use passive interfaces.
    • B、Use NSSA areas from the core down.
    • C、Use totally stub areas to stop type 3 LSAs.
    • D、Use the lowest Ethernet interface IP address as the router ID.
    • E、Tune OSPF timers to enable OSPF to achieve quicker convergence.

    正确答案:B,E

  • 第16题：

    Which two are NOT characteristics of the OSPF routing protocol?（）

    • A、It confines network instability to a single area of network.
    • B、It increases the routing overhead of the network
    • C、It supports VLSM
    • D、It routes between Autonomous Systems.
    • E、It allows extensive control of routing updates

    正确答案:B,D

  • 第17题：

    Which two routing interface parameters are supported in OSPF implementations?（）

    • A、retransmit - interval
    • B、de ad - interval
    • C、stub area
    • D、virtual link
    • E、NSSA area

    正确答案:A,B

  • 第18题：

    多选题
    Which two statements are true about hierarchical architecture? （）(Choose two.)
    A

    You can assign a logical interface to multiple zones.

    B

    You cannot assign a logical interface to multiple zones.

    C

    You can assign a logical interface to multiple routing instances.

    D

    You cannot assign a logical interface to multiple routing instances.


    正确答案： B,C
    解析： 暂无解析

  • 第19题：

    多选题
    Which two implementations are standard Virtual Private LAN Service （VPLS） implementations that aresupported by the IETF？（）
    A

    VPLS uses LDP for signaling.

    B

    VPLS uses BGP for autodiscovery and signaling.

    C

    VPLS uses extended IS-IS for signaling

    D

    VPLS uses OSPF version 3 for auto discovery and signaling

    E

    VPLS uses spanning tree for signaling


    正确答案： D,B
    解析： 暂无解析

  • 第20题：

    多选题
    Which two are characteristics of the IS -IS protocol but not OSPF?（）
    A

    forms adjacencies with all neighbors

    B

    supports demand circuit routing

    C

    provides routing support for multiple network layer protocols

    D

    utilizes SPF algorithm

    E

    provides for network scalability by allowing the network to be separated into areas

    F

    three layers of hierarchical routing


    正确答案： D,B
    解析： 暂无解析

  • 第21题：

    多选题
    You are at the top of the hierarchy and must configure OSPF on interface so-0/0/0 unit 100. Which two achieve this result?（）
    A

    set protocols   setospf area 0   set interface so-0/0/0.100

    B

    set protocols ospf area 0 interface so-0/0/0.100

    C

    edit protocols ospf interface so-0/0/0.100

    D

    edit protocols ospf area 0   set interface so-0/0/0.100


    正确答案： B,D
    解析： 暂无解析

  • 第22题：

    多选题
    Which two are NOT characteristics of the OSPF routing protocol?（）
    A

    It confines network instability to a single area of network.

    B

    It increases the routing overhead of the network

    C

    It supports VLSM

    D

    It routes between Autonomous Systems.

    E

    It allows extensive control of routing updates


    正确答案： B,C
    解析： 暂无解析

  • 第23题：

    多选题
    Which two routing interface parameters are supported in OSPF implementations?（）
    A

    retransmit - interval

    B

    de ad - interval

    C

    stub area

    D

    virtual link

    E

    NSSA area


    正确答案： A,E
    解析： 暂无解析

相关内容