Refer to the exhibit. Give this output for SwitchC, what should the network administrator‘s next action be?()A.Check the trunk encapsulation mode for SwitchC‘s fa0/1 port.B.Check the duplex mode for SwitchC‘s fa0/1 port.C.Check the duplex mode for SwitchA

题目
Refer to the exhibit. Give this output for SwitchC, what should the network administrator‘s next action be?()

A.Check the trunk encapsulation mode for SwitchC‘s fa0/1 port.

B.Check the duplex mode for SwitchC‘s fa0/1 port.

C.Check the duplex mode for SwitchA‘s fa0/2 port.

D.Check the trunk encapsulation mode for SwitchA‘s fa0/2 port.


相似考题
参考答案和解析
参考答案:C
更多“Refer to the exhibit. Give this output for SwitchC, what should the network administrator‘s next action be?() ”相关问题
  • 第1题:

    Refer to the exhibit. Routing updates for the 192.168.1.0 network are being received from all three neighbors. Which statement is correct regarding the result of the con figuration shown? ()

    A. The router will prefer the next hop of 172.16.1.1 for packets destined for the 192.168.1.0 network.

    B. The router will prefer the next hop of 172.26.1.1 for packets destined for the 192.168.1.0 network.

    C. The router will adve rtise the 192.168.1.0 network only to 172.30.1.1.

    D. The router will advertise the 192.168.1.0 network only to 172.26.1.1.

    E. The router will prefer the next hop of 172.26.1.1 for packets except those destined for the 192.168.1.0 network.


    参考答案:B

  • 第2题:

    Refer to the exhibit. By default, when RTB passes BGP advertisements from RTA about network 192.168.2.0 to RTC, what address will be listed as the next - hop address? ()

    A. 10.1.1.2

    B. 192.168.1.49

    C. 10.1.1.1

    D. 192.168.1.50


    参考答案:D

  • 第3题:

    Refer to the exhibit. A network technician is asked to design a small network with redundancy. The exhibit represents this design, with all hosts configured in the same VLAN. What conclusions can be made about this design?()

    A.The design will function as intended

    B.Spanning-tree will need to be used.

    C.The router will not accept the addressing scheme.

    D.The connection between switches should be a trunk.

    E.The router interfaces must be encapsulated with the 802.1Q protocol.


    参考答案:C

  • 第4题:

    Refer to the exhibit. What does the (*) represent in the output?()

    A.Packet is destined for a local interface to the router.

    B.Packet was translated, but no response was received from the distant device.

    C.Packet was not translated, because no additional ports are available.

    D.Packet was translated and fast switched to the destination.


    参考答案:D

  • 第5题:

    Refer to the exhibit.   What are three of the basic components of a VoIP network?()

    • A、software voice applications
    • B、multipoint control unit (MCU)  
    • C、gatekeeper  
    • D、call agent
    • E、interactive voice response (IVR) systems  
    • F、softphones

    正确答案:B,C,D

  • 第6题:

    The Company network administrator needs to enable VTP pruning within the Company network. What action should a network administrator take to enable VTP pruning on an entire management  domain?()

    • A、Enable VTP pruning on any switch in the management domain
    • B、Enable VTP pruning on any client switch in the domain
    • C、Enable VTP pruning on a VTP server in the management domain
    • D、Enable VTP pruning on every switch in the domain
    • E、None of the other alternatives apply

    正确答案:C

  • 第7题:

    An administrator replaces the network card in a web server. After replacing the network card some users can access the server but others cannot. Which of the following is the FIRST thing the administrator should check?()

    • A、Default gateway
    • B、The ports on the switch
    • C、Port security on the server's switch port
    • D、Ethernet cable

    正确答案:A

  • 第8题:

    单选题
    Refer to the exhibit. Given the output for this command, if the router ID has not been manually set, what router ID will OSPF use for this RouterD?()
    A

    10.1.1.2

    B

    10.154.154.1

    C

    172.16.5.1

    D

    192.168.5.3


    正确答案: B
    解析: 暂无解析

  • 第9题:

    单选题
    Refer to the exhibit. A network technician is asked to design a small network with redundancy. The exhibit represents this design, with all hosts configured in the same VLAN. What conclusions can be made about this design?()
    A

    The design will function as intended

    B

    Spanning-tree will need to be used.

    C

    The router will not accept the addressing scheme.

    D

    The connection between switches should be a trunk.

    E

    The router interfaces must be encapsulated with the 802.1Q protocol.


    正确答案: C
    解析: 暂无解析

  • 第10题:

    单选题
    Refer to the exhibit. What switch proves the spanning-tree designated port role for the network segment that services the printers?()
    A

    Switch1

    B

    Switch2

    C

    Switch3

    D

    Switch4


    正确答案: A
    解析: 暂无解析

  • 第11题:

    单选题
    The Company network administrator needs to enable VTP pruning within the Company network. What action should a network administrator take to enable VTP pruning on an entire management  domain?()
    A

    Enable VTP pruning on any switch in the management domain

    B

    Enable VTP pruning on any client switch in the domain

    C

    Enable VTP pruning on a VTP server in the management domain

    D

    Enable VTP pruning on every switch in the domain

    E

    None of the other alternatives apply


    正确答案: C
    解析: 暂无解析

  • 第12题:

    单选题
    Refer to the exhibit. A network administrator configures a new router and enters the copy startup-config running-config on the router. The network administrator powers down the router and sets it up at a remote location. When the router starts, it enter the system configuration dialog as shown. What is the caust of the problem?()
    A

    The network administrator faled to save the configuration.

    B

    The configuration register is set to 0x2100.

    C

    The boot system flash command is missing from the configuration.

    D

    The configuraiton register is set to 0x2102.

    E

    The router is configured with the boot system startup command.


    正确答案: A
    解析: 暂无解析

  • 第13题:

    Refer to the exhibit. Routers RTA and RTB are running BGP but the session is active. What command needs to be added to esta blish the BGP session? ()

    A. ip route 10.10.10.1 255.255.255.255 s0/0 ip route 10.10.10.1 255.255.255.255 s0/1

    B. network 10.10.10.0

    C. no synchronization

    D. neighbor 10.10.10.1 next - hop - self


    参考答案:A

  • 第14题:

    Refer to the exhibit. An administrator pings the default gateway at 10.10.10.1 and sees the output as shown. At which OSI layer is the problem?()

    A.data link layer

    B.application layer

    C.access layer

    D.session layer

    E.network layer


    参考答案:E

  • 第15题:

    Refer to the exhibit. What is the meaning of the output MTU 1500 bytes?()

    A.Themaximumnumberofbytesthatcantraversethisinterfacepersecondis1500.

    B.Theminimumsegmentsizethatcantraversethisinterfaceis1500bytes.

    C.Theminimumpacketsizethatcantraversethisinterfaceis1500bytes.

    D.Themaximumpacketsizethatcantraversethisinterfaceis1500bytes.

    E.Themaximumframesizethatcantraversethisinterfaceis1500bytes.


    参考答案:D

  • 第16题:

    What are the two reasons for the appearance of 0.0.0.0 as the next hop for a network in the show ip bgp command output?()

    • A、The network was originated via redistribution of an interior gateway protocol into BGP
    • B、The network was defined by a static route
    • C、The network was originated via a network or aggregate command
    • D、The network was learned via EBGP
    • E、The network was learned via IBGP

    正确答案:A,C

  • 第17题:

    A client is having problems connecting remotely after replacing a router. An administrator has just created an action plan. Which of the following is the NEXT step the administrator should perform to resolve this issue?()

    • A、Implement and test the solution.
    • B、Determine if escalation is necessary.
    • C、Identify the affected areas of the network.
    • D、Identify the results and effects of the solution

    正确答案:A

  • 第18题:

    An administrator replaces the network card in a web server. After replacing the network card some users can access the server but others cannot.  Which of the following is the FIRST thing the administrator should check?()

    • A、 Default gateway
    • B、 The ports on the switch
    • C、 Port security on the servers switch port
    • D、 Ethernet cable

    正确答案:A

  • 第19题:

    单选题
    Refer to the exhibit. What is the meaning of the output MTU 1500 bytes?()
    A

    Themaximumnumberofbytesthatcantraversethisinterfacepersecondis1500.

    B

    Theminimumsegmentsizethatcantraversethisinterfaceis1500bytes.

    C

    Theminimumpacketsizethatcantraversethisinterfaceis1500bytes.

    D

    Themaximumpacketsizethatcantraversethisinterfaceis1500bytes.

    E

    Themaximumframesizethatcantraversethisinterfaceis1500bytes.


    正确答案: B
    解析: 暂无解析

  • 第20题:

    单选题
    Refer to the exhibit. An administrator pings the default gateway at 10.10.10.1 and sees the output as shown. At which OSI layer is the problem?()
    A

    data link layer

    B

    application layer

    C

    access layer

    D

    session layer

    E

    network layer


    正确答案: E
    解析: 暂无解析

  • 第21题:

    单选题
    Two vessels are approaching each other near head on. What action should be taken to avoid collision?().
    A

    The first vessel to sight the other should give way

    B

    The vessel making the slower speed should give way

    C

    Both vessels should alter course to starboard

    D

    Both vessels should alter course to port


    正确答案: D
    解析: 暂无解析

  • 第22题:

    单选题
    An administrator replaces the network card in a web server. After replacing the network card some users can access the server but others cannot.  Which of the following is the FIRST thing the administrator should check?()
    A

     Default gateway

    B

     The ports on the switch

    C

     Port security on the servers switch port

    D

     Ethernet cable


    正确答案: D
    解析: 暂无解析

  • 第23题:

    多选题
    Refer to the exhibit.   What are three of the basic components of a VoIP network?()
    A

    software voice applications

    B

    multipoint control unit (MCU)

    C

    gatekeeper

    D

    call agent

    E

    interactive voice response (IVR) systems

    F

    softphones


    正确答案: A,F
    解析: 暂无解析