Refer to the exhibit. When deploying an MSFC and an FWSM, which statement is correct?()A. Proper placement depends on the VLAN assignment.B. Place it outside the firewall.C. Place it inside the firewall to make design and management easier.D. Place it ins

题目
Refer to the exhibit. When deploying an MSFC and an FWSM, which statement is correct?()

A. Proper placement depends on the VLAN assignment.

B. Place it outside the firewall.

C. Place it inside the firewall to make design and management easier.

D. Place it inside the firewall with multiple context modes connecting to all configured contexts.

相似考题

1.Which statement is correct about logical units on Juniper Router interfaces?()A.Logical units are used only when a Layer 2 identifier is present such as a VLANB.A logical unit of 0 is required when using a frame-relay DLCIC.A logical unit is always requiredD.Logical units are not required unless ATM or 802.1Q VLAN tagging is configured.

2.Refer to the exhibit. ROUTE.com is planning to implement a secure OSPF network to support traffic between clients on the 172.16.10.0/24 network and the file server on the 172.16.20./24 network. You have been asked to review the implementation and verification plans for this OSPF project. Which statement about the plan is true? （）A. It is complete as writtenB. It should include a task that verifie s that the interarea routes are using the proper MEDC. It should include a task that verifies that load sharing is active on R1 and R4D. It should include a task that verifies that all redundant links will become active when the primary links are sh ut down

3.Refer to the exhibit. A new TAC engineer came to you for advice. A GRE over IPsec tunnel was configured, but the tunnel is not coming up. W hat did the TAC engineer configure incorrectly?()A. The crypto isakmp configuration is not correct.B. The crypto map configuration is not correct.C. The interface tunnel configuration is not correct.D. The network configuration is not correct; netw ork 172.16.1.0 is missing.

4.Refer to the exhibit. Which command would verify if PBR reacts to packets sourced from 172.16.0.0／16?()A. show ip routeB. show policy - mapC. show access - listsD. show route - map

更多“Refer to the exhibit. When deploying an MSFC and an FWSM, which statement is correct?() ”相关问题

  • 第1题：

    Refer to the exhibit. The partial configuration for an OSPF ASBR and an Area 0 ABR is shown. Assume the OSPF configurations throughout the network are operable. Which statement about these configurations is true? （）

    A. The ASBR route - maps are basically useless, because there are no deny prefix - lists.

    B. LSA Type 5s wil l not be received by the ABR from the ASBR.

    C. The OSPF backbone will not learn any RFC 1918 addresses.

    D. The matched prefix - list addresses will be given a metric of 255, which is essentially unreachable.


    参考答案：C

  • 第2题：

    Refer to the exhibit. By default, when RTB passes BGP advertisements from RTA about network 192.168.2.0 to RTC, what address will be listed as the next － hop address? ()

    A. 10.1.1.2

    B. 192.168.1.49

    C. 10.1.1.1

    D. 192.168.1.50


    参考答案：D

  • 第3题：

    Refer to the exhibit. Which statement is true about the configuration? ()

    A. RTA will not establish an OSPF adjacency w ith RTB

    B. RTA will send OSPF hello packets, but will not send OSPF updates

    C. RTA will not accept OSPF hello packets from RTB

    D. RTA will send OSPF updates, but will not establish an adjacency with RTB


    参考答案：A

  • 第4题：

    Refer to the exhibit. Which two of these are characteristics of a firewall running in transparent mode?()

    A. FWSM routes traffic between the VLANs.

    B. FWSM switches traffic between the VLANs.

    C. Transparent mode is often called bump-in-the-wire mode.

    D. Transparent mode firewall deployments are used most often in current designs.

    E. Traffic routed between VLANs is subject to state tracking and other firewall configurable options.


    参考答案：B, C

  • 第5题：

    Refer to the exhibit. Which statement is true?()

    A.The Fa0/11 role confirms that SwitchA is the root bridge for VLAN 20.

    B.VLAN 20 is running the Per VLAN Spanning Tree Protocol.

    C.The MAC address of the root bridge is 0017.596d.1580.

    D.SwitchA is not the root bridge, because not all of the interface roles are designated.


    参考答案：D

  • 第6题：

    Refer to the exhibit. Which statement is correct based on the show login command output shown？（）

    • A、When the router goes into quiet mode， any host is permitted to access the router via Telnet，SSH， and HTTP，since the quiet-mode access list has not been configured.
    • B、The login block-for command is configured to block login hosts for 93 seconds.
    • C、All logins from any sources are blocked for another 193 seconds.
    • D、Three or more login requests have failed within the last 100 seconds.

    正确答案:D

  • 第7题：

    Which statement is correct about logical units on Juniper Router interfaces?（）

    • A、Logical units are used only when a Layer 2 identifier is present such as a VLAN
    • B、A logical unit of 0 is required when using a frame-relay DLCI
    • C、A logical unit is always required
    • D、Logical units are not required unless ATM or 802.1Q VLAN tagging is configured.

    正确答案:C

  • 第8题：

    单选题
    Refer to the exhibit. Available public Internet sites are sometimes used for estimating performance. Which statement regarding their use for estimating VPN performance is correct?（）
    A

    Throughput results are valid as a value from the Teleworker's home to the corporate site, regardless of the location of the public test server. 

    B

    Throughput results may not be valid due to the public server's location on the Internet and fluctuations based on the use of the public server. 

    C

    Throughput values are not affected by the choice of split tunneling or Internet access through the VPN. 

    D

    Throughput results are unrelated to the Teleworker PC configuration or current PC use.


    正确答案： A
    解析： 暂无解析

  • 第9题：

    单选题
    Given the following code：     public class Person{ static int arr[] = new int[10]；  public static void main（String a[]） {     System.out.println（arr[1]；）     }     }  Which statement is correct？（）
    A

     When compilation some error will occur.

    B

     It is correct when compilation but will cause error when running.

    C

     The output is zero.

    D

     The output is null.


    正确答案： C
    解析：  int型数组是类对象，它在类被加载时完成初始化，在前面题目中已经有叙述，由于是原始数据类型int，其初始值为0。

  • 第10题：

    单选题
    Refer to the exhibit. Which statement is true about a voice VLAN？（）
    A

     Physically the voice network and the data network are separate.

    B

     The voice traffic will normally be on a different IP subnet than will the data traffic.

    C

     End user intervention is necessary to place the phone into the proper VLAN.

    D

     The same security policy should be implemented for both voice and data traffic.

    E

     The data VLAN must be configured as the native VLAN.


    正确答案： C
    解析： 暂无解析

  • 第11题：

    单选题
    Refer to the exhibit. Which statement is true about a voice VLAN？（）
    A

    Physically the voice network and the data network are separate

    B

    The voice traffic will normally be on a different IP subnet than will the data traffic

    C

    End user intervention is necessary to place the phone into the proper VLAN

    D

    The same security policy should be implemented for both voice and data traffic

    E

    The data VLAN must be configured as the native VLAN


    正确答案： D
    解析： 暂无解析

  • 第12题：

    单选题
    Refer to the exhibit. When a profile is configured in the Aironet Desktop Utility， which security option  permits the configuration of host-based Extensible Authentication Protocol （EAP）？（）
    A

     WPA/WPA2/CCKM

    B

     WPA/WPA2 Passphrase

    C

     802.1x

    D

     Pre-Shared Key （Static WEP）


    正确答案： D
    解析： 暂无解析

  • 第13题：

    Refer to the exhibit. Which statement is true? ()

    A. Only traffic with a destination from 10.10.0.0/19 will be permitted.

    B. Router RAR1 will accept only route 10.10.0.0/19 from its BGP neighbor.

    C. Only traffic going to 10.10.0.0/19 will be permitted.

    D. Router RAR1 will send only route 10.10.0.0/19 to its BGP neighbor.


    参考答案：B

  • 第14题：

    Refer to the exhibit. Which two statement s are correct?()

    A. All the routes were redistributed into BGP from an IGP

    B. All the routes were originated by BGP with the network command

    C. All six routes will be installed in the routing table

    D. Four routes will be installed in the routing ta ble

    E. Two routes will be installed in the routing table


    参考答案：A, D

  • 第15题：

    Refer to the exhibit. Which two statements about the topologies shown are correct?()

    A. Design 1 is a looped triangle design.

    B. Design 2 is a looped triangle design.

    C. Design 2 achieves quick convergence using RSTP.

    D. Both designs supportstateful services at the aggregation layer.

    E. Design 2 is the most widely deployed in enterprise data centers.


    参考答案：A, D

  • 第16题：

    Refer to the exhibit. Which subnet mask will place all hosts on Network B in the same subnet with the least amount of wasted addresses?()

    A.255.255.255.0

    B.255.255.254.0

    C.255.255.252.0

    D.255.255.248.0


    参考答案：B

  • 第17题：

    Refer to the exhibit. Which value will be configured for Default Gateway of the Local Area Connection?()

    A.10.0.0.0

    B.10.0.0.254

    C.192.223.129.0

    D.192.223.129.254


    参考答案：B

  • 第18题：

    Given the following code：     public class Person{     int arr[] = new int[10]；  public static void main（String a[]） {     System.out.println（arr[1]）；     }     }  Which statement is correct？（） 

    • A、 When compilation some error will occur.
    • B、 It is correct when compilation but will cause error when running.
    • C、 The output is zero.
    • D、 The output is null.

    正确答案:A

  • 第19题：

    多选题
    Refer to the exhibit. Which two statements are correct？ （Choose two.）（）
    A

    All six routes will be installed in the routing table.

    B

    Two routes will be installed in the routing table.

    C

    Four routes will be installed in the routing table.

    D

    All the routes were redistributed into BGP from an IGP.

    E

    All the routes were originated by BGP with the network command.


    正确答案： C,B
    解析： 暂无解析

  • 第20题：

    单选题
    Refer to the exhibit. Which statement is correct based on the show login command output shown？（）
    A

    When the router goes into quiet mode， any host is permitted to access the router via Telnet，SSH， and HTTP，since the quiet-mode access list has not been configured.

    B

    The login block-for command is configured to block login hosts for 93 seconds.

    C

    All logins from any sources are blocked for another 193 seconds.

    D

    Three or more login requests have failed within the last 100 seconds.


    正确答案： B
    解析： 暂无解析

  • 第21题：

    多选题
    Refer to the exhibit. Which two statements are correct？（）
    A

    All six routes will be installed in the routing table

    B

    Two routes will be installed in the routing table

    C

    Four routes will be installed in the routing table

    D

    All the routes were redistributed into BGP from an IGP

    E

    All the routes were originated by BGP with the network command


    正确答案： A,B
    解析： 暂无解析

  • 第22题：

    单选题
    Which statement is correct about logical units on Juniper Router interfaces?（）
    A

    Logical units are used only when a Layer 2 identifier is present such as a VLAN

    B

    A logical unit of 0 is required when using a frame-relay DLCI

    C

    A logical unit is always required

    D

    Logical units are not required unless ATM or 802.1Q VLAN tagging is configured.


    正确答案： D
    解析： 暂无解析

  • 第23题：

    单选题
    Given the following code：     public class Person{     int arr[] = new int[10]；  public static void main（String a[]） {     System.out.println（arr[1]）；     }     }  Which statement is correct？（）
    A

     When compilation some error will occur.

    B

     It is correct when compilation but will cause error when running.

    C

     The output is zero.

    D

     The output is null.


    正确答案： B
    解析： 实例变量在类的一个实例构造时完成初始化，而且在类的静态方法中不能直接访问类的非静态成员而只能访问类成员（像上题中一样），类的普通方法可以访问类的所有成员和方法，而静态方法只能访问类的静态成员和方法，因为静态方法属于类，而普通方法及成员变量属于类的实例，类方法（静态方法）不能使用属于某个不确定的类的实例的方法和变量，在静态方法里面没有隐含的this，而普通方法有。

相关内容