A.alternate
B.backup
C.designated
D.disabled
E.root
第1题:
A.The switch will not forward unicast frames.
B.The switch will forward the frame to a specific port.
C.The switch will return a copy of the frame out the source port.
D.The switch will remove the destination MAC from the switch table.
E.The switch will forward the frame to all ports except the port on which it was received.
第2题:
What are three methods that may be use d to allow a switch to determine which ports to forward IP multicast messages to?()
第3题:
Which switch port error is an indication of duplex mismatches on 10/100/1000 IEEE 802.3u Gigabit Ethernet ports?()
第4题:
What will an Ethernet switch do if it receives a unicast frame with a destination MAC that is listed in the switch table?()
第5题:
Which of the following specification will allow you to: associate VLAN groups to STP instances so you can provide multiple forwarding paths for data traffic and enable load balancing? ()
第6题:
An administrator replaced a router with a switch. End users are able to access network shares butare not able to access the Internet. Which of the following is the BEST explanation why the usersare unable to access the Internet?()
第7题:
When the voice VLAN feature is enabled, all untagged traffic is sent according to the default CoS priority of the port.
Enabling voice VLANs enables the switch to create multiple queues for traffic that is entering a port.
When voice VLANs are configured on a trunk link, UplinkFast must also be enabled.
Voice VLANs are configured to enable the switch to forward frames marked with the proper CoS values over separate physical links.
Enabling voice VLANs enables the switch to forward frames with a specific 802.1P marking.
第8题:
IEEE 802.1d (STP)
IEEE 802.1s (MST)
IEEE 802.1Q (CST)
IEEE 802.1w (RSTP)
第9题:
The switch will not forward unicast frames.
The switch will forward the frame to a specific port.
The switch will return a copy of the frame out the source port.
The switch will remove the destination MAC from the switch table.
The switch will forward the frame to all ports except the port on which it was received.
第10题:
IGMP
IGMP snooping
PIM
CGMP
static assignment
CDP
第11题:
alternate
backup
designated
disabled
root
第12题:
instances can control a selection of VLANs
load balancing
fast transition to forwarding state
backbone,uplink,and portfast (or equivalent)
root,loop,and BPDU guard (or equivalent)
第13题:
Switch ports operating in which two roles will forward traffic according to the IEEE 802.1w standard?()
第14题:
Which two are natively included by the IEEE 802.1w standard?()
第15题:
A project requires a new server to be set up with the ability to automatically fail over its Ethernet connection to a second connection if a network failure occurs. Which of the following provides greatest resiliency?()
第16题:
For the following ports, which port is on every bridge in a Spanning Tree Protocol IEEE 802.1w network except the root bridge?()
第17题:
Which two of the following steps are necessary to configure inter-VLAN routing between multilayer switches?()
第18题:
A project requires a new server to be set up with the ability to automatically fail over its Ethernet connection to a second connection if a network failure occurs. Which of the following provides greatest resiliency?()
第19题:
Two switch ports will be needed on a switch,two Ethernet cables will be needed for theserver each connecting to two different Ethernet cards,and one IP address will be needed
Two switch ports will be needed on two different switches two Ethernet cables will beneeded for the server each connecting to two different Ethernet cards,and one IP address will be needed
Two switch ports will be needed on two different switches,two Ethernet cables will be needed for the server each connecting to two different Ethernet cards,two different IP addresses will be needed
One switch port will be needed on one switch,a splitter will be needed to split the connection,two Ethernet cables will be needed for the server each connecting to two different Ethernet cards,and two different IP addresses will be needed
第20题:
Set each end of the trunk line to IEEE 802.1Q encapsulation.
Set the same VTP management domain name on both switches.
Set all ports on the two switched as access ports.
Configure one of the two switches as a VTP server.
Connect the two switches using a rollover cable.
Use a router to forward VTP traffic between the VLANs.
第21题:
Each end of the trunk line must be set to IEEE 802.1E encapsulation.
The VTP management domain name of both switches must be set the same.
All ports on both the switches must be set as access ports.
One of the two switches must be configured as a VTP server.
A rollover cable is required to connect the two switches together.
A router must be used to forward VTP traffic between VLANs.
第22题:
root port,designated port,alternate port,backup port,and disabled
standby port,alternate port,root port,and disabled
standby port,designated port,backup port,and disabled
root port,designated port,alternate port,and standby port
第23题:
All traffic is tagged with a specific VLAN ID from the VLAN of the attacker and is now viewable
Clients will forward packets to the attacking device, which will in turn send them to the desireddestination but not before recording the traffic patterns
All traffic is redirected to the VLAN that the attacker used to flood the CAM table
All traffic is flooded out all ports and an attacker is able to capture all data
None of the other alternatives apply