A. Only router can split boundaries(horizons)between concentric networks.
B. All distance vector protocols require fall routes that may cause momentary loops as the topology changes.
C. Networks can only remain fully converged if all information about routes is sent out all active interfaces.
D. Information about a route should not be sent back in the direction from which the original update came.
E. Each AS must keep routing tables converged to prevent dead routes from being advertised across the AS boundary.
第1题:
how to disable OPSF split-horizon?
第2题:
Which statement describes VRRP object tracking?()
第3题:
Which two statements are true about the role of split horizon?()
第4题:
Which two steps below should you perform on the hub router while configuring EIGRP routing over DMVPN (mGRE tunnel)? ()
第5题:
Within a BGP confederation, how are routing loops avoided?()
第6题:
什么是RIP协议的水平分割(split horizon)?
第7题:
Only routers can split boundaries (horizons) between networks in separate AS numbers.
Each AS must keep routing tables converged to prevent dead routes from being advertised across boundaries.
Once a route is received on an interface, advertise that route as unreachable back out the same interface.
Information about a route should never be sent back in the direction from which the original update came.
第8题:
The NAT action of off is only supported for destination NAT rule-sets.
The NAT action of off is only supported for source NAT rule-sets.
The NAT action of off is useful for detailed control of NAT
The NAT action of off is useful for disabling NAT when a pool is exhausted.
第9题:
It is a function used by routing protocols to install routes into routing table
It is a function that prevents the advertising of routes over an interface that the router is usingto reach a route
Its function is to help avoid routing loops.
It is a redistribution technique used by routing protocols
第10题:
There is a full mesh of pseudowires.
There is a partial mesh of pseudowires.
Only L2TPv3 can be used for pseudowire establishment.
There is split-horizon to avoid loops.
第11题:
第12题:
Needs to use Inverse ARP.
Maps a single IP subnet per DLCI.
Maps a single IP subnet across multiple DLCIs.
Resolves NBMA (non broadcast multi access) split horizon issues.
Requires use of the frame-relay map command.
None of the above
第13题:
Which of the following statements correctly describes the characteristics of a Frame Relay point-to-point subinterface?()
第14题:
Which statement describes the process ID that is used to run OSPF on a router ?()
第15题:
Which one of the following statements best explains the split horizon rule used in distance vector routing protocols?()
第16题:
Which two statements about VPLS are true? ()
第17题:
Which statement is true about a NAT rule action of off?()
第18题:
第19题:
Joined horizons
Packet forwarding loops
cisco Express Forwarding load-balancing inconsistency
Asymmetric routing throughout the network
第20题:
Both vessels must be power-driven
They must be meeting on reciprocal or nearly reciprocal courses
The situation must involve risk of collision
All of the above
第21题:
Acquire locks on table queried
Generate redo for statement
Fetch data from disk into memory
Write changes to disk
第22题:
The NAT action of off is only supported for destination NAT rule-sets.
The NAT action of off is only supported for source NAT rule-sets.
The NAT action of off is useful for detailed control of NAT.
The NAT action of off is useful for disabling NAT when a pool is exhausted
第23题:
Only routers can split boundaries (horizons) between concentric networks.
All distance vector protocols require fall back routers that may cause momentary loops as the topology changes.
Networks can only remain fully converged if all information about routers is sent out all active interfaces.
Information about a route should not be sent back in the direction from which the original update come.
Each AS must keep routing tables converged to prevent dead routes from being advertised across the AS boundary.
第24题:
The BGP split - horizon rule specifies that routes learned via EBGP are never propagated to other IBGP peers.
The BGP split horizon rule specifies that routes learned via IBGP are never propagated to other IBGP peers.
A full - mesh IBGP requires that neighbor relationships be established between a ll BGP enabled routers in the autonomous system.
IBGP neighbors must be in different autonomous systems.
An EGP or static routing is required between IBGP neighbors.