Refer to the exhibit. What will Router1 do when it receives the data frame shown?()A.Router1 will strip off the source MAC address and replace it with the MAC address 0000.0c36.6965.B.Router1 will strip off the source IP address and replace it with the IP

题目
Refer to the exhibit. What will Router1 do when it receives the data frame shown?()

A.Router1 will strip off the source MAC address and replace it with the MAC address 0000.0c36.6965.

B.Router1 will strip off the source IP address and replace it with the IP address 192.168.40.1.

C.Router1 will strip off the destination MAC address and replace it with the MAC address 0000.0c07.4320.

D. Router1 will strip off the destination IP address and replace it with the IP address of 192.168.40.1.

E.Router1 will forward the data packet out interface FastEthernet0/1.

F.Router1 will forward the data packet out interface FastEthernet0/2.

相似考题

1.—() — In most cases, it is the total income received.A. What does taxable income refer to?B. Why do you want to know taxable income?C. When do you start to learn taxable income?

2.Refer to the exhibit. What is required to complete the IPv6 routing configurations shown?()A. Interface authentication must be configuredB. The routing processes must be configured with an area IDC. IP unicast routing must be enabledD. IPv4 ad dresses must be applied to the interfaces

3.Refer to the parti al configurations in the exhibit. What address is utilized for DR and BDR identification on Router1?()A. the serial 1/1 addressB. the serial 2/0 addressC. a randomly generated internal addressD. the configured router - id address

4.A Ezonexam Ethernet switch receives a unicast frame. with a destination MAC that is listed in the switch table. What will this switch do with the frame?A. The switch will forward the frame. to a specific portB. The switch will forward the frame. to all ports except the port on which it was receivedC. The switch will return a copy of the frame. out the source portD. The switch will not forward unicast framesE. The switch will remove the destination MAC from the switch tableF. None of the above.

更多“Refer to the exhibit. What will Router1 do when it receives the data frame shown?() ”相关问题

  • 第1题：

    Refer to the exhibit. By default, when RTB passes BGP advertisements from RTA about network 192.168.2.0 to RTC, what address will be listed as the next － hop address? ()

    A. 10.1.1.2

    B. 192.168.1.49

    C. 10.1.1.1

    D. 192.168.1.50


    参考答案：D

  • 第2题：

    Refer to the exhibit. When running OSPF, What would cause router A not to form an adjacency with router B?()

    A.The loopback addresses are on different subnets

    B.The value of the dead timers on the router are different

    C.Route summarization is enabled on both routers

    D.The process indentifier on router A is different than the process identifier on router B


    参考答案：B

  • 第3题：

    Refer to the exhibit A frame on vlan 1 on switch s1 is sent to switch s2 when the frame is received on vlan 2,what causes this behavior?()

    A.trunk mode mismatches

    B.vlans that do not correspond to a unique IP subnet

    C.native vlan mismatches

    D.allowing only vlan 2 on the destination.


    参考答案：C

  • 第4题：

    What can MS do when it is standby state?()

    A.Transfer data packets

    B.Receive PS or CS paging

    C.Do nothing

    D.Cell update


    参考答案：B

  • 第5题：

    What can MS do when it is standby state？（）

    • A、Transfer data packets
    • B、Receive PS or CS paging
    • C、Do nothing
    • D、Cell update

    正确答案:B

  • 第6题：

    What will an Ethernet switch do if it receives a unicast frame with a destination MAC that is listed in the switch table?（）

    • A、The switch will not forward unicast frames.
    • B、The switch will forward the frame to a specific port.
    • C、The switch will return a copy of the frame out the source port.
    • D、The switch will remove the destination MAC from the switch table.
    • E、The switch will forward the frame to all ports except the port on which it was received.

    正确答案:B

  • 第7题：

    Overlay Transport Virtualization （OTV） overlay interface is a logical multiaccess and multicast- capable interface that must be explicitly defined by the user and where the entire OTV configuration is applied. Which statements are true about OTV overlay interface？（）

    • A、 When an OTV edge device receives a Layer 2 frame destined for a remote data center site， the frame is logically forwarded to the overlay interface.
    • B、 The OTV edge device performs the dynamic OTV encapsulation on the Layer 2 packet and sends it to the join interface toward the routed domain.
    • C、 When the OTV edge device receives a Layer 2 frame destined for a remote data center site， the frame is logically forwarded to the join interface.
    • D、 The OTV edge device performs the dynamic OTV encapsulation on the Layer 2 packet and sends it to the overlay interface toward the routed domain.

    正确答案:A,B

  • 第8题：

    Refer to the exhibit. For what two reasons has the router loaded its IOS image from the location that is shown? （）

    • A、Router1 has specific boot system command that instruct it to load IOS from TFTP server.
    • B、Router1 is acting as a TFTP server for other routers.
    • C、Router1 cannot locate a valid IOS image in flash memory.
    • D、Router1 defaulted to ROMMON mode and loaded the IOS image from a TFTP server.
    • E、Cisco routers will first attempt to load a image from TFTP for management purposes.

    正确答案:A,C

  • 第9题：

    单选题
    when a user clicks a link in the left frame of the Review application, the linked data displays in the frame on the right. What did Kristin to do allow this to happen?（）
    A

    entered the name of the target frame in hotspot properties

    B

    entered the name of the target in frameset properties

    C

    entered the position of the target frame in frame properties

    D

    entered the position of target frame in hotspot properties. a name other than location


    正确答案： D
    解析： 暂无解析

  • 第10题：

    单选题
    Refer to the exhibit. What is the configuration an example of？（）
    A

    enabling modular QoS over Frame Relay

    B

    enabling Real-Time Transport Protocol （RTP） header compression

    C

    enabling distributed compressed Transmission Control Protocol

    D

    enabling latency and jitter reduction for Transmission Control traffic

    E

    enabling TCP header compression


    正确答案： E
    解析： 暂无解析

  • 第11题：

    单选题
    Refer to the exhibit. What is the meaning of the term dynamic as displayed in the output of the show frame-relay map command shown?（）
    A

    The Serial0/0 interface is passing traffic.

    B

    The DLCI 100 was dynamically allocated by the router

    C

    The Serial0/0 interface acquired the IP address of 172.16.3.1 from a DHCP server

    D

    The DLCI 100 will be dynamically changed as required to adapt to changes in the Frame Relay cloud

    E

    The mapping between DLCI 100 and the end station IP address 172.16.3.1 was learned through Inverse ARP


    正确答案： A
    解析： 暂无解析

  • 第12题：

    单选题
    What can MS do when it is standby state？（）
    A

    Transfer data packets

    B

    Receive PS or CS paging

    C

    Do nothing

    D

    Cell update


    正确答案： A
    解析： 暂无解析

  • 第13题：

    Refer to the exhibit. Which two statements about the topologies shown are correct?()

    A. Design 1 is a looped triangle design.

    B. Design 2 is a looped triangle design.

    C. Design 2 achieves quick convergence using RSTP.

    D. Both designs supportstateful services at the aggregation layer.

    E. Design 2 is the most widely deployed in enterprise data centers.


    参考答案：A, D

  • 第14题：

    Refer to the exhibit. An administrator pings the default gateway at 10.10.10.1 and sees the output as shown. At which OSI layer is the problem?()

    A.data link layer

    B.application layer

    C.access layer

    D.session layer

    E.network layer


    参考答案：E

  • 第15题：

    What will an Ethernet switch do if it receives a unicast frame with a destination MAC that is listed in the switch table()。

    A.The switch will not forward unicast frames.

    B.The switch will forward the frame to a specific port.

    C.The switch will return a copy of the frame out the source port.

    D.The switch will remove the destination MAC from the switch table.

    E.The switch will forward the frame to all ports except the port on which it was received.


    参考答案：B

  • 第16题：

    When referring to the data structures of a packet, what is the proper term to refer to a single unit of TCP data at the transport layer?当提及一个数据包结构时，以下哪项可以表示一个TCP包在传输层的单个数据单元？（）

    • A、TCP segment.TCP段
    • B、TCP packet.TCP包
    • C、TCP frame.TCP帧
    • D、TCP datagram.TCP报文

    正确答案:A

  • 第17题：

    Refer to the exhibit. What is the meaning of the term dynamic as displayed in the output of the show frame-relay map command shown?（）

    • A、The Serial0/0 interface is passing traffic.
    • B、The DLCI 100 was dynamically allocated by the router
    • C、The Serial0/0 interface acquired the IP address of 172.16.3.1 from a DHCP server
    • D、The DLCI 100 will be dynamically changed as required to adapt to changes in the Frame Relay cloud
    • E、The mapping between DLCI 100 and the end station IP address 172.16.3.1 was learned through Inverse ARP

    正确答案:E

  • 第18题：

    Refer to the exhibit A frame on vlan 1on switch s1 is sent to switch s2 when the frame is received on vlan 2,what causes this behavior?（）

    • A、trunk mode mismatches
    • B、vlans that do not correspond to a unique IP subnet
    • C、native vlan mismatches
    • D、allowing only vlan 2 on the destination.

    正确答案:C

  • 第19题：

    Refer to the exhibit. What is the configuration an example of？（）

    • A、enabling modular QoS over Frame Relay
    • B、enabling Real-Time Transport Protocol （RTP） header compression
    • C、enabling distributed compressed Transmission Control Protocol
    • D、enabling latency and jitter reduction for Transmission Control traffic
    • E、enabling TCP header compression

    正确答案:E

  • 第20题：

    单选题
    Refer to the exhibit. An administrator pings the default gateway at 10.10.10.1 and sees the output as shown. At which OSI layer is the problem?（）
    A

    data link layer

    B

    application layer

    C

    access layer

    D

    session layer

    E

    network layer


    正确答案： E
    解析： 暂无解析

  • 第21题：

    单选题
    Refer to the exhibit A frame on vlan 1 on switch s1 is sent to switch s2 when the frame is received on vlan 2,what causes this behavior?（）
    A

    trunk mode mismatches

    B

    vlans that do not correspond to a unique IP subnet

    C

    native vlan mismatches

    D

    allowing only vlan 2 on the destination.


    正确答案： C
    解析： 暂无解析

  • 第22题：

    单选题
    Which statement describes multihop FCoE function when an FCoE switch receives an FCoE frame from the directly connected FCoE host？（）
    A

     The switch receives the FCoE frame and forwards it to another switch over its VE port.

    B

     The switch receives the FCoE frame， deapsulates it， and sends the Fibre Channel frame to the fabric over its Fibre Channel uplink port.

    C

     The switch receives the FCoE frame， deapsulates it， and sends the Fibre Channel frame to the Fibre Channel target over its Fibre Channel port.

    D

     The switch receives the FCoE frame and forwards it to another FCoE device over its VN port.


    正确答案： C
    解析： 暂无解析

  • 第23题：

    单选题
    What will an Ethernet switch do if it receives a unicast frame with a destination MAC that is listed in the switch table（）。
    A

    The switch will not forward unicast frames.

    B

    The switch will forward the frame to a specific port.

    C

    The switch will return a copy of the frame out the source port.

    D

    The switch will remove the destination MAC from the switch table.

    E

    The switch will forward the frame to all ports except the port on which it was received.


    正确答案： E
    解析： 暂无解析

相关内容