A.All ports will be in a state of discarding, learning, or forwarding.
B.Thirty VLANs have been configured on this switch.
C.The bridge priority is lower than the default value for spanning tree.
D.All interfaces that are shown are on shared media.
E.All designated ports are in a forwarding state.
F.The switch must be the root bridge for all VLANs on this switch.
第1题:
A. The peer group shortens the EBGP configuration
B. The peer group shortens the IBGP configuration
C. All the configured neighbors are in autonomous system 100
D. Three AS - path filters are applied to each BGP neighbor
E. Only the outgoing filters are applied to BGP updates
第2题:
A. Design 1 is a looped triangle design.
B. Design 2 is a looped triangle design.
C. Design 2 achieves quick convergence using RSTP.
D. Both designs supportstateful services at the aggregation layer.
E. Design 2 is the most widely deployed in enterprise data centers.
第3题:
A.data link layer
B.application layer
C.access layer
D.session layer
E.network layer
第4题:
A.This switch has more than one interface connected to the root network segment in VLAN 2.
B.This switch is running RSTP while the elected designated switch is running 802.1d Spanning Tree.
C.This switch interface has a higher path cost to the root bridge than another in the topology.
D.This switch has a lower bridge ID for VLAN 2 than the elected designated switch.
第5题:
Which two statements are true about analog to digital conversion of voice signals for use in digital telephony networks?()
第6题:
Refer to the exhibit. Which two statements are true about the partial configuration that is shown?()
第7题:
Refer to the exhibit. The DHCP configuration that is shown is configured on a Cisco router. Whichstatement is true?()
第8题:
data link layer
application layer
access layer
session layer
network layer
第9题:
The three required steps in the analog to digital conversion are sampling,encoding,and compression.
The three required steps in the analog to digital conversion are sampling,quantization,and compression.
The three required steps in the analog to digital conversion are sampling,quantization,and encoding.
The output of the sampling process is a pulse code modulation (PCM) signal.
The output of the sampling process is a pulse amplitude modulation (PAM) signal.
第10题:
All six routes will be installed in the routing table
Two routes will be installed in the routing table
Four routes will be installed in the routing table
All the routes were redistributed into BGP from an IGP
All the routes were originated by BGP with the network command
第11题:
It is a static variable and can be set only at MySQL server startup
It enables and starts the General Query Log
It sets the target location for the binary logs generated by the MySQL sever
It specifies output destinations for the slow and General Query logs
第12题:
The router will distribute IP addresses from pool 1 until its addresses are exhausted. Then therouter will begin distributing addresses from pool 2
The configuration is invalid because the DHCP options are global configuration commands
The configuration is incomplete until the DHCP pools are bound to the appropriate interface orinterfaces
The router will choose which pool to use based upon the interface the DHCP request wasreceived on
第13题:
A. Router RTA is the BDR
B. Router RTA is directly connected to interface 192.168.45.1
C. Neighbor 192.168.45.1 has changed its OSPF priority number
D. Router RTA and neighbor 192.168.45.2 are exchanging OSPF LSAs
第14题:
Refer to the exhibit. Switch port FastEthernet 0/24 on AlSwitch1 will be used to create an IEEE 802.1Q- complaint trunk to another switch. Based on the output shown, What is the reason the trunk does not form, even thought the proper cabling has been attached?()
A.VLANs have not been created yet
B.An IP address must be configured for the port
C.The port is currently configured for access mode
D.The correct encapsulation type has not been configured
E.The no shutdown command has not been entered for the port
第15题:
Refer to the exhibit. The two exhibit devices are the only Cisco devices on the network. The serial network between the two devices has a mask of 255.255.255.252. Given the output that is shown, what three statements are true of these devices? ()
A.The Manchester serial address is 10.1.1.1
B.The Manchester serial address is 10.1.1.2
C.这个Manchester路由器串口地址为:10.1.12
D.The London router is a Cisco 2610.
E.The Manchester router is a Cisco 2610.
F.The CDP information was received on port Serial0/0 of the Manchester router.
G.The CDP information was sent by port Serial0/0 of the London Router.
第16题:
A.There are at least two routers participating in the RIP process.
B.A ping to 192.168.168.2 will be successful.
C.A ping to 10.0.15.2 will be successful.
D.RtrA has three interfaces participating in the RIP process.
第17题:
Refer to the exhibit. Which statement is correct based on the show login command output shown?()
第18题:
Refer to the exhibit. The output that is shown is generated at a switch. Which three of these statements are true? ()
第19题:
Which statement is true about the log-output variable?()
第20题:
A device is trusted if it correctly classifies packets.
A device is trusted if it correctly declassifies packets.
The outermost trusted devices represent the trust boundary.
Classification and marking occur using 802.1ab QoS bits before reaching the trust boundary.
Network trust boundaries are automatically configured in IOS version 12.3 and later.
For scalability, classification should be done as close to the edge as possible.
第21题:
All database operations performed by the impdp command are logged.
Only CREATE INDEX and CREATE TABLE statements generated by the import are logged.
Only CREATE TABLE and ALTER TABLE statements generated by the import are logged.
None of the operations against the master table used by Oracle Data Pump to coordinate its activities are logged.
第22题:
When traffic is sent from the ISP to autonomous system 64512, the traffic will be forwarded toSanJose2 because of the higher MED value of SanJose2
The serial 0/0/1 interface on the ISP router has been configured with the set metric 50command
The output was generated by entering the show ip bgp command on the SanJose1 router
The output was generated by entering the show ip bgp command on the ISP router
The serial 0/0/1 interface on the ISP router has been configured with the set metric 75command
When traffic is sent from the ISP to autonomous system 64512, the traffic will be forwarded toSanJose1 because of the lower MED value of SanJose1
第23题:
Asinglerowsubquerycanretrieveonlyonecolumnandonerow.
Asinglerowsubquerycanretrieveonlyonerowbutmanycolumns.
Amultiplerowsubquerycanretrievemultiplerowsandmultiplecolumns.
Amultiplerowsubquerycanbecomparedusingthe;>;;operator.
AsinglerowsubquerycanusetheINoperator.
Amultiplerowsubquerycanusethe;=;operator.
第24题:
Hosts connected to the FastEthernet0/1 interface will not receive DHCP replies from the router
The first DHCP client to connect to the FastEthernet 0/1 interface will receive the IP address10.10.0.1
The first DHCP client to connect to the FastEthernet 0/0 interface will receive the IP address10.0.0.1
DHCP requests received on the FastEthernet 0/1 interface will be forwarded to 10.0.0.2
The first DHCP client to connect to the FastEthernet 0/0 interface will receive the IP address10.0.0.6