更多“Which command helps a network administrator to manage memory by displaying flash memory andNVRAM utilization?() ”相关问题
  • 第1题:

    Which command helps a network administrator to manage memory by displaying flash memory and NVRAM utilization?()

    • A、show secure
    • B、show file systems
    • C、show flash
    • D、show version

    正确答案:B

  • 第2题:

    An administrator is adding additional memory into a server that registers 1GB of memory in the OS and notices that the system has 2GB of memory physically installed; however, the server only shows 1GB of memory during POST.  Which of the following is the MOST likely reason for this?()

    • A、 The OS does not support more than 1GB of memory.
    • B、 The system memory has different manufacture dates.
    • C、 Two of the memory sticks are defective.
    • D、 The server is using memory interleaving.

    正确答案:C

  • 第3题:

    The administrator has just installed a new memory module into the server. Now, the server is not showing the new memory. Which of the following should the administrator perform FIRST?()

    • A、System reboot
    • B、Reseat the memory
    • C、Install the latest firmware
    • D、Install the latest driver

    正确答案:B

  • 第4题:

    Memory utilization by the print spooler process is constantly climbing after users begin to print to acertain type of printer.  Which of the following is the MOST likely cause of the problem?()

    • A、 Corrupted print spooler software
    • B、 Memory leak in one of the print drivers
    • C、 The disk drive is out of free space
    • D、 Memory leak in the print spooler

    正确答案:B

  • 第5题:

    A customer has a Power 770 running an SAP ERP workload on AIX 7. It has a single partition with 12 cores and 48GB of memory and the CPU is underutilized at 46% with 1000 users. Memory utilization is at 80%. The number of users will increase to 1700, increasing memory utilization by 37%. Which of the following supports this requirement?()

    • A、Active Memory Server
    • B、Active Memory Sharing
    • C、Active Memory Pooling
    • D、Active Memory Expansion

    正确答案:D

  • 第6题:

    An administrator wants to test the performance of an application at different memory sizes.  What is the most effective way to perform the test and collect statistical information for each test?()  

    • A、Run DLPAR to change the LPAR memory for each test.
    • B、Run rmss command to simulate different memory for each test.
    • C、Run chdev command to limit the system memory size for each test.
    • D、Run chattr command to limit the system memory size for each test.

    正确答案:B

  • 第7题:

    Which system resources does WLM have the capability to control?()

    • A、 CPU, Memory and Network I/O 
    • B、 CPU, Memory and Disk I/O 
    • C、 CPU and Memory 
    • D、 CPU and Disk I/O

    正确答案:B

  • 第8题:

    单选题
    After running the vmstat command, which of the following would most likely cause the value in the blocked column to be unusually high?()
    A

     Kernel thread

    B

     Too many users

    C

     Memory shortage

    D

     Network contention


    正确答案: A
    解析: 暂无解析

  • 第9题:

    单选题
    An administrator is upgrading memory on the server. Once the server in turned back on, the administrator notices that the memory has not changed. The system board website says the board should accept the new amount of memory.  Which of the following should the administrator do FIRST?()
    A

     Replace memory chips with known good memory chips.

    B

     Reseat the memory chips.

    C

     Update the BIOS.

    D

     Upgrade the server OS.


    正确答案: D
    解析: 暂无解析

  • 第10题:

    单选题
    An administrator is adding memory to a server. Once the system boots up, the same amount of memory appears as before the upgrade. Which of the following is the MOST likely cause?()
    A

     The memory is not the correct CAS latency.

    B

     The memory is not installed in the correct slot.

    C

     The memory does not have the correct timing.

    D

     The memory is not the correct speed.


    正确答案: A
    解析: 暂无解析

  • 第11题:

    单选题
    An administrator is upgrading memory on the server. Once the server in turned back on, the administrator notices that the memory has not changed. The system board website says the board should accept the new amount of memory.Which of the following should the administrator do FIRST?()
    A

    Replace memory chips with known good memory chips.

    B

    Reseat the memory chips.

    C

    Update the BIOS.

    D

    Upgrade the server OS


    正确答案: B
    解析: 暂无解析

  • 第12题:

    单选题
    Memory utilization by the print spooler process is constantly climbing after users begin to print to acertain type of printer.  Which of the following is the MOST likely cause of the problem?()
    A

     Corrupted print spooler software

    B

     Memory leak in one of the print drivers

    C

     The disk drive is out of free space

    D

     Memory leak in the print spooler


    正确答案: C
    解析: 暂无解析

  • 第13题:

    Which BGP feature shou ld be used to avoid high memory utilization on a router?()

    • A、soft - reconfiguration
    • B、route refresh
    • C、BGP communities
    • D、full - mesh BGP peering

    正确答案:B

  • 第14题:

    An administrator is upgrading memory on the server. Once the server in turned back on, the administrator notices that the memory has not changed. The system board website says the board should accept the new amount of memory.  Which of the following should the administrator do FIRST?()

    • A、 Replace memory chips with known good memory chips.
    • B、 Reseat the memory chips.
    • C、 Update the BIOS.
    • D、 Upgrade the server OS.

    正确答案:B

  • 第15题:

    An administrator is adding memory to a server. Once the system boots up, the same amount of memory appears as before the upgrade. Which of the following is the MOST likely cause?()

    • A、The memory is not the correct CAS latency.
    • B、The memory is not installed in the correct slot.
    • C、The memory does not have the correct timing.
    • D、The memory is not the correct speed.

    正确答案:B

  • 第16题:

    After running the vmstat command, which of the following would most likely cause the value in the blocked column to be unusually high?()

    • A、 Kernel thread
    • B、 Too many users
    • C、 Memory shortage
    • D、 Network contention

    正确答案:A

  • 第17题:

    After completing an installation of new software, a system administrator notices the system is slow.  To troubleshoot the performance, which single AIX command could be used to provide a real-time display of CPU, memory and disk utilization()

    • A、topas
    • B、vmo
    • C、iostat
    • D、netstat

    正确答案:B

  • 第18题:

    Which are the two main uses of a VIO server?() 

    • A、Virtualize network and memory to LPARs.
    • B、Virtualize network and storage to LPARs.
    • C、Virtualize memory and processors to LPARs.
    • D、Virtualize storage and processors to LPARs.

    正确答案:B

  • 第19题:

    You work as a senior administrator at ABC.com. The ABC.com network consists of a single domain named ABC.com. All servers on the ABC.com network have Windows Server 2012 R2 installed.You are running a training exercise for junior administrators. You are currently discussing the use of Non-Uniform Memory Architecture (NUMA).Which of the following is TRUE with regards to Non-Uniform Memory Architecture (NUMA)?()

    • A、It is a computer architecture used in multiprocessor systems.
    • B、It is a computer architecture used in single processor systems.
    • C、It allows a processor to access local memory faster than it can access remote memory.
    • D、It allows a processor to access remote memory faster than it can access local memory.

    正确答案:A,C

  • 第20题:

    单选题
    A new computer is displaying the wrong amount of memory. Which of the following may be the cause?()
    A

    The module is installed backwards.

    B

    A USB device is using some memory.

    C

    An onboard video card is using some memory.

    D

    The CPU is using some memory.


    正确答案: A
    解析: 暂无解析

  • 第21题:

    单选题
    Which system resources does WLM have the capability to control?()
    A

     CPU, Memory and Network I/O 

    B

     CPU, Memory and Disk I/O 

    C

     CPU and Memory 

    D

     CPU and Disk I/O


    正确答案: C
    解析: 暂无解析

  • 第22题:

    单选题
    An administrator is adding memory to a server. Once the system boots up, the same amount of memory appears as before the upgrade. Which of the following is the MOST likely cause?()
    A

    The memory is not the correct CAS latency.

    B

    The memory is not installed in the correct slot.

    C

    The memory does not have the correct timing.

    D

    The memory is not the correct speed.


    正确答案: B
    解析: 暂无解析

  • 第23题:

    多选题
    You work as a senior administrator at ABC.com. The ABC.com network consists of a single domain named ABC.com. All servers on the ABC.com network have Windows Server 2012 R2 installed.You are running a training exercise for junior administrators. You are currently discussing the use of Non-Uniform Memory Architecture (NUMA).Which of the following is TRUE with regards to Non-Uniform Memory Architecture (NUMA)?()
    A

    It is a computer architecture used in multiprocessor systems.

    B

    It is a computer architecture used in single processor systems.

    C

    It allows a processor to access local memory faster than it can access remote memory.

    D

    It allows a processor to access remote memory faster than it can access local memory.


    正确答案: B,A
    解析: 暂无解析