While troubleshooting a network connectivity problem, a technician observes steady link lights on both the workstation NIC and the switch port to which the workstation is connected. However, when the ping command is issued from the workstation, the output

题目

While troubleshooting a network connectivity problem, a technician observes steady link lights on both the workstation NIC and the switch port to which the workstation is connected. However, when the ping command is issued from the workstation, the output message "Request timed out." is displayed. At which layer of the OSI model does the problem most likely exist（）。

A.the session layer

B.the protocol layer

C.the data link layer

D.the access layer

E.the network layer

F.the application layer

相似考题

1.While troubleshooting a connectivity problem on the network, you issue the ping command from your PC command prompt, but the output shows "request times out."At which OSI layer is this problem associated with?A．The data link layerB．The application layerC．The access layerD．The session layerE．The network layer

2.The network technician is troubleshooting a network issue by implementing a new security device.After installing and configuring the device, which of the following steps should the technician takeNEXT?（）A. Verity full system functionalityB. Identify the main problem and question the userC. Document their findings, actions, and outcomesD. Escalate the issue to upper management

3.A technician is troubleshooting a network connectivity issue. Given the following abbreviated traceroute output:Which of the following is MOST likely occurring?()A. Switching loopB. Broadcast stormC. IP conflictD. Routing loop

4.While troubleshooting a network connectivity problem, a Ezonexam technician observes steady link lights on both the workstation NIC and the switch port to which the workstation is connected. However, when the ping command is issued from the workstation, the output message "Request timed out." is displayed. At which layer of the 7-layer OSI model does the problem most likely exist?A. The data link layerB. The application layerC. The protocol layerD. The access layerE. The session layerF. The network layerG. None of the above

更多“While troubleshooting a network connectivity problem, a technician observes steady link li ”相关问题

  • 第1题：

    A technician is troubleshooting a network connectivity issue with a user‘s desktop configured touse a static IP address. The technician notes the following configuration:Which of the following changes will allow the desktop to communicate properly with remote networks?（）

    A. Changing the DNS to 172.16.1.100

    B. Changing the WINS server to 172.174.136

    C. Changing the netmask to 255.255.255.0

    D. Changing the default gateway to 172.16.3.1


    参考答案：D

  • 第2题：

    A TestKing.com technician is troubleshooting connectivity problems between two routers that are directly connected through the serial line. The technician notices that the serial line is up but cannot see any neighbors displayed in the output of the show cdp neighbors command.In which OSI layer is the problem most likely occurring?（）

    A. Physical

    B. Data link

    C. Network layer

    D. Transport layer

    E. Application layer


    参考答案：B

  • 第3题：

    A technician is troubleshooting a network connectivity issue on a MFD and would like to eliminate the possibility of another device on the network having the same IP address. The technician should：（）

    • A、disconnect the MFD and ping the IP address.
    • B、disconnect the MFD and ping the subnet mask.
    • C、disconnect the MFD and ping the loopback address.
    • D、run the ipconfig command from the command prompt.

    正确答案:A

  • 第4题：

    While troubleshooting a connectivity problem, a network administrator notices that a port status LED on a Cisco Catalyst series switch is alternating green and amber. Which condition could this indicate?（）

    • A、The port is experiencing errors.
    • B、The port is administratively disabled.
    • C、The port is blocked by spanning tree.
    • D、The port has an active link with normal traffic activity.

    正确答案:A

  • 第5题：

    While troubleshooting a network problem,a technician discovers that the current copy of the Cisco IOS is outdated and needs to be updated.Which of the following commands would the technician issue to replace the Cisco router IOS with the newer version?（）

    • A、Router#copy tftp flash
    • B、Router(config)#restore flash
    • C、Router(config)#repair flash
    • D、Router#copy flash run
    • E、Router>copy start flash
    • F、Router#copy start flash

    正确答案:A

  • 第6题：

    A technician is troubleshooting a host connectivity problem. The host is unable to ping a server connected to Switch_A. Based on the results of the testing, what could be the problem（）。

    • A、A remote physical layer problem exists.
    • B、The host NIC is not functioning.
    • C、TCP/IP has not been correctly installed on the host.
    • D、A local physical layer problem exists.

    正确答案:D

  • 第7题：

    While troubleshooting a network connectivity problem, a technician observes steady link lights on both the workstation NIC and the switch port to which the workstation is connected. However, when the ping command is issued from the workstation, the output message "Request timed out." is displayed. At which layer of the OSI model does the problem most likely exist（）。

    • A、the session layer
    • B、the protocol layer
    • C、the data link layer
    • D、the access layer
    • E、the network layer
    • F、the application layer

    正确答案:E

  • 第8题：

    单选题
    While troubleshooting a network connectivity issue, you suspect that a router may be missing a route, or may be receiving bad routing information to a destination. What command should you issue to view the route that the router will use to reach a given destination?（）
    A

    ping

    B

    trace

    C

    show ip route

    D

    show interface

    E

    show cdp neighbors


    正确答案： D
    解析： 暂无解析

  • 第9题：

    单选题
    A technician is troubleshooting a host connectivity problem. The host is unable to ping a server connected to Switch_A. Based on the results of the testing, what could be the problem（）。
    A

    A remote physical layer problem exists.

    B

    The host NIC is not functioning.

    C

    TCP/IP has not been correctly installed on the host.

    D

    A local physical layer problem exists.


    正确答案： D
    解析： 暂无解析

  • 第10题：

    单选题
    While troubleshooting a connectivity problem, a network administrator notices that a port status LED on a Cisco Catalyst series switch is alternating green and amber. Which condition could this indicate?（）
    A

    The port is experiencing errors.

    B

    The port is administratively disabled.

    C

    The port is blocked by spanning tree.

    D

    The port has an active link with normal traffic activity.


    正确答案： A
    解析： 暂无解析

  • 第11题：

    单选题
    While troubleshooting a network problem,a technician discovers that the current copy of the Cisco IOS is outdated and needs to be updated.Which of the following commands would the technician issue to replace the Cisco router IOS with the newer version?（）
    A

    Router#copy tftp flash

    B

    Router(config)#restore flash

    C

    Router(config)#repair flash

    D

    Router#copy flash run

    E

    Router>copy start flash

    F

    Router#copy start flash


    正确答案： D
    解析： 暂无解析

  • 第12题：

    多选题
    While troubleshooting some connectivity issues， you issue the "show ip ospf database" in order toexamine the link state database. Which three of the statements below are true regarding theOSPF link state database？（）
    A

    Each router has an identical link state database

    B

    External routes are imported into a separate link state database

    C

    Synchronization of link state databases is maintained via flooding of LSAs

    D

    Information in the link state database is used to build a routing table by calculating a shortest-path tree

    E

    By default， link state databases are refreshed every 10 minutes in the absence of topologychanges


    正确答案： E,D
    解析： 暂无解析

  • 第13题：

    A Ezonexam technician is troubleshooting connectivity problems between two routers that are directly connected through the serial line. The technician notices that the serial line is up but cannot see any neighbors displayed in the output of the show cdp neighbors command.

    In which OSI layer is the problem most likely occurring?

    A．Physical

    B．Data link

    C．Network layer

    D．Transport layer

    E．Application layer


    正确答案：B
    解析：Explanation:Asthequestionstatesthatseriallineisup,itmeanstheproblemisnotontheNetworklayer.Theadministratorcannotseeanyoutputbyissuingtheshowcdpneighborscommand.ItmeansthatCDPisdisabledandCDPisaprotocolthatrunsoverLayer2(thedatalinklayer)onallCiscorouters,bridges,accessservers,andswitches.

  • 第14题：

    While troubleshooting a network problem,a technician discovers that the current copy of the Cisco IOS is outdated and needs to be updated.Which of the following commands would the technician issue to replace the Cisco router IOS with the newer version?（）

    A. Router#copy tftp flash

    B. Router(config)#restore flash

    C. Router(config)#repair flash

    D. Router#copy flash run

    E. Router>copy start flash

    F. Router#copy start flash


    参考答案：A

  • 第15题：

    A TestKing.com technician is troubleshooting connectivity problems between two routers that are directly connected through the serial line. The technician notices that the serial line is up but cannot see any neighbors displayed in the output of the show cdp neighbors command. In which OSI layer is the problem most likely occurring?（）

    • A、Physical
    • B、Data link
    • C、Network layer
    • D、Transport layer
    • E、Application layer

    正确答案:B

  • 第16题：

    While troubleshooting a connectivity problem, a network administrator notices that a port status LED on a Cisco Catalyst series switch is alternating green and amber. Which condition could this indicate（）。

    • A、The port is experiencing errors
    • B、The port is administratively disabled
    • C、The port is blocked by spanning tree
    • D、The port has an active link with normal traffic activity

    正确答案:A

  • 第17题：

    The network technician is troubleshooting a network issue by implementing a new security device.After installing and configuring the device, which of the following steps should the technician takeNEXT?（）

    • A、Verity full system functionality
    • B、Identify the main problem and question the user
    • C、Document their findings, actions, and outcomes
    • D、Escalate the issue to upper management

    正确答案:A

  • 第18题：

    While troubleshooting a connectivity problem on the network, you issue the ping command from your PC command prompt, but the output shows "request times out."At which OSI layer is this problem associated with?（）

    • A、The data link layer
    • B、The application layer
    • C、The access layer
    • D、The session layer
    • E、The network layer

    正确答案:E

  • 第19题：

    A technician is troubleshooting a lack of Internet connectivity affecting their entire office. The technician suspects the issue is with their Internet Service Provider failing to provide service.Which of the following command line tools should the technician use to BEST test this theory？（）

    • A、tracert
    • B、ipconfig
    • C、netstat
    • D、nslookup

    正确答案:A

  • 第20题：

    单选题
    A TestKing.com technician is troubleshooting connectivity problems between two routers that are directly connected through the serial line. The technician notices that the serial line is up but cannot see any neighbors displayed in the output of the show cdp neighbors command. In which OSI layer is the problem most likely occurring?（）
    A

    Physical

    B

    Data link

    C

    Network layer

    D

    Transport layer

    E

    Application layer


    正确答案： D
    解析： 暂无解析

  • 第21题：

    单选题
    Which of the following should a technician do FIRST to troubleshoot a users network connectivity problem？（）
    A

    Run TRACERT from the users workstation.

    B

    Start with the Last Known Good Configuration and reboot the computer.

    C

    Replace the network interface card （NIC）.

    D

    PING the users workstation.


    正确答案： D
    解析： 暂无解析

  • 第22题：

    单选题
    A new building has been added to the enterprise campus network， providing client access for desktop PCs， laptops， and IP phones for employees and guests. During verification， only a few laptops using  wireless are reported to have problems， while other desktops， IP phones， and most other wireless laptops are fully operational. Additional information received about the problem indicates that， while the problematic wireless laptops cannot reach internal corporate websites， they can reach the Internet.  Where should troubleshooting about this connectivity issue be focused？（）
    A

    client network configuration

    B

    VLAN mapping

    C

    routing protocols

    D

    first-hop redundancy protocol


    正确答案： B
    解析： 暂无解析

  • 第23题：

    单选题
    While troubleshooting a network connectivity problem, a technician observes steady link lights on both the workstation NIC and the switch port to which the workstation is connected. However, when the ping command is issued from the workstation, the output message "Request timed out." is displayed. At which layer of the OSI model does the problem most likely exist?（）
    A

    the session layer

    B

    the protocol layer

    C

    the data link layer

    D

    the access layer

    E

    the network layer

    F

    the application layer


    正确答案： A
    解析： 暂无解析

  • 第24题：

    单选题
    While troubleshooting a connectivity problem, a network administrator notices that a port status LED on a Cisco Catalyst series switch is alternating green and amber. Which condition could this indicate（）。
    A

    The port is experiencing errors

    B

    The port is administratively disabled

    C

    The port is blocked by spanning tree

    D

    The port has an active link with normal traffic activity


    正确答案： C
    解析： 暂无解析

相关内容