If an anchor windlass has been idle for some time, you should ______.
A.repack all valve stems
B.lubricate it prior to use
C.replace the foundation bolts
D.balance the warping heads
第1题:
if the anchor has been heaved out of the ground and clear of the bottom, what do you report?
第2题:
Why should you soak an anchor ________.
A.It can prevent the anchor from slipping during pretensioning
B.It will lubricate all the moving parts of a stock anchor
C.It will increase the maximum breaking strength of the anchor chain
D.It will make it easier to disassemble the anchor for repair
第3题:
How should you warm up a diesel engine that has not been run for some time?______.
A.Run it at minimum speed for a period of time
B.Run it at half speed for a period of time
C.Bring it to top speed immediately
D.Inject ether into the air intake
第4题:
When the order “Let go the anchor” is received ,you should ().
第5题:
Stop the engines
Escort the pilot to the accommodation ladder
Plot the vessel's position on the chart
Make a round of the weather decks
第6题:
open the steam line mot valve
drain the steam cylinder
close the steam cylinder drains
open the liquid cylinder drains
第7题:
release the brake
hoist the anchor ball
turn the windlass over slowly
A and B
第8题:
repack all valve stems
lubricate it prior to use
replace the foundation bolts
balance the warping heads
第9题:
Turn on FilterKeys, this will allow accessibility options to be turned on at will.
In accessibility options on the general tab, enable turn off accessibility features after idle for xx minutes.
From the Keyboard tab of the accessibility option applet, check the StickyKeys checkbox, this will save all accessibility options when you exit the control panel applet.
In accessibility options on the general tab, disable turn off accessibility features after idle for xx minutes.
第10题:
Bringing the anchor to short stay
Heaving in all the chain
Locking the windlass to prevent more chain from running out
Paying out more chain
第11题:
not drop the anchor until the lights are in line
ensure your ship will NOT block the channel or obstruct the range while at anchor
drop the anchor immediately as the range lights mark an area free of obstructions
drop the anchor immediately as a change in the position of the range lights will be an indication of dragging anchor
第12题:
Run it at minimum speed for a period of time
Run it at half speed for a period of time
Bring it to top speed immediately
Inject ether into the air intake
第13题:
You are planning to anchor in an area where several anchors have been lost due to fouling.As a precaution,you should ______.
A.anchor using both anchors
B.anchor with scope of 8 or more to 1
C.use a stern anchor
D.fit a crown strap and work wire to the anchor
第14题:
Before letting the anchor go, you should check that the ______.
A.chain is clear
B.anchor is clear of obstructions
C.wildcat is disengaged
D.All of the above
第15题:
The work()by the time you get there.
第16题:
You have configured accessibility options for Tom. Everything works fine. You want to configure that when Tom wants to use CTRL, ALT or Shift key simultaneously, he should has the option to press one key at a time? What should you do to provide this feature to Tom?()
第17题:
adding small amounts of oil to the system
the system has been overheated
the system has been drained and then filled with new oil
the system has been idle for a long period of time
第18题:
rack position should be adjusted
compensating needle valve should be opened fully compensating
needle valve should be adjusted to stabilize operation
speed limiting device should be adjusted
第19题:
stop the engines
turn off the running lights and turn on the anchor lights
take at least two bearings of prominent shore lights
lower the accommodation ladder and illuminate it
第20题:
adjusts the idle speed control
drain and flushes the governor and replace the oil
adjusts the compensating needle valve
第21题:
increase engine speed to insure adequate flow of oil to all parts of the engine
pay no attention unless there are unusual noises from the engine
check operating pressures and temperatures,and check for leaks
run the engine at idle until the temperature has increased
第22题:
increase the starting air pressure
use a higher than normal cranking speed
increase the fuel injection pressure
use a fuel having a lower ignition temperature
第23题:
anchor using both anchors
anchor with scope of 8 or more to 1
use a stern anchor
fit a crown strap and work wire to the anchor