Which of the following usually causes a tree to grow unhealthy?
A. Giving a tree a special shape and a definite height.
B. Removing small side branches and making a tree look less thick.
C. Allowing too many branches to grow in the middle.
D. Having a tree surrounded by many other trees.
第1题:
A. Learning
B. Spanning
C. Listening
D. Forwarding
E. Initializing
F. Filtering
G. Permitting
第2题:
A. spanning-tree backbonefast
B. spanning-tree uplinkfast
C. spanning-tree portfast
D. spanning-tree cost512
第3题:
Passage Three
Trees should only be pruned (修剪) when there is a good reason for doing so. Many gardeners believe that more damage results from doing it unnecessarily than from leaving the tree to grow in its own way.
First, pruning may be done to make sure that trees have a desired shape. The object may be to get a tree of the right height, and to help the growth of small side branches which will thicken its appearance or give it a special shape. Secondly, pruning may be done to make the tree healthier. You may cut out diseased or dead wood, or branches that are rubbing against each other and thus causing wounds. A tree may grow healthier by removing the branches that are locking up the centre and so preventing the free movement of air.
One result of pruning is that an open wound is left on the tree and this provides an easy entry (进入) for diseases, but it is a wound that will heal. Often there is a race between the healing and the disease as to whether the tree will live or die. Pruning is usually clone in winter, for then you can see the shape of the tree clearly without the interference from the leaves.
41. According to the article, which of the following statement is NOT true?
A. Pruning is necessary when there are unwanted branches.
B. Damage is done to a tree if it is left to grow in its own way.
C. Diseased or dead branches should be cut away if they are found to rub against each other.
D. Growing side branches often prevent air from moving freely.
41.答案为B 根据第一段最后一句可知该陈述是错误的,修剪只是在有必要的时候才进行。
第4题:
第5题:
Which of the following are spanning tree port states?()
第6题:
For the following ports, which port is on every bridge in a Spanning Tree Protocol IEEE 802.1w network except the root bridge?()
第7题:
Which of the following are shared distribution tree characteristics? (Choose all that apply.)()
第8题:
In which of the following topologies could the failure of one machine cause the entire network tostop functioning?()
第9题:
Designated port
Nonswitch port
Switch port
Nonroot port
Nondesignated port
Root port
第10题:
Switch(config-if)#spanning-tree guard root
Switch(config-if)#spanning-tree portfast
Switch(config-if)#switchport mode trunk
Switch(config-if)#switchport mode access
第11题:
Spanning Tree Protocol
Cabling
Frame forwarding
Packet forwarding
EtherChannel
Routing protocols
第12题:
Learning
Spanning
Listening
Forwarding
Initializing
Filtering
Permitting
第13题:
A.Memory requirements are higher for shared distribution tree than for source distributiontree.
B.Creates a tree from a central RP to all last-hoprouters.
C.Uses a rendezvous point.
D.An optimal path is created between each source router and each last-hoprouter.
E.Place(S,G)entry in each router’smulticast routing table.
F.Place(*,G)entry in a router’smulticast routing to table.
第14题:
A. spanning-tree mode rapid-pvst
B. spanning-tree uplinkfast
C. spanning-tree backbonefast
D. spanning-tree mode mst
第15题:
第16题:
第17题:
Which of the following troubleshooting targets is considered to be a Layer 2 issue?(Choose allthat apply.)()
第18题:
Which command enables RSTP on a switch?()
第19题:
Which command enhances the 802.1D convergence time on ports that are connected to hosts?()
第20题:
Which of the following features should an administrator configure to allow an IDS to watch thetraffic on a switch?()
第21题:
spanning-tree guard root
spanning-tree portfast bpduguard default
spanning-tree bpduguard enable
spanning-tree bpdufilter enable
spanning-tree portfast bpdufilter default
第22题:
spanning-tree mode rapid-pvst
spanning-tree uplinkfast
spanning-tree backbonefast
spanning-tree mode mst
第23题:
multipart-to-multipoint EVC (E-LAN)
hub spoke EVC (E-Tree)
point to point EVC (E-Line)
rooted multipoint EVC (E-Tree)
point-to-multipoint EVC (E-Tree)