protocol type
MAC address
TCP or UDP port
source and destination IP address
第1题:
A.protocol
B.VLAN number
C.TCP or UDP port numbers
D.source switch port number
E.source IP address and destination IP address
F.source MAC address and destination MAC address
第2题:
第3题:
You work as a network technician at Company. Your boss, Mrs., is interested in LWAPP (Lightweight Access Point Protocol). What should you tell her regarding this technology? ()
第4题:
What three pieces of information can be used in an extended access list to filter traffic (Choose three.)()。
第5题:
What is the effect of the following access list condition access-list 101 permit ip 10.25.30.0 0.0.0.255 any()。
第6题:
Firewall filters can perform which two actions?()
第7题:
A layer 3 switch can move packets between subnets based on which of the following criteria?()
第8题:
permit all packets matching the first three octets of the source address to all destinations
permit all packets matching the last octet of the destination address and accept all source addresses
permit all packets from the third subnet of the network address to all destinations
permit all packets matching the host bits in the source address to all destinations
permit all packets to destinations matching the first three octets in the destination address
第9题:
LWAPP is a proprietary protocol, and because of its very high overhead it is not widely adopted.
Control traffic is encapsulated in UDP packets with a source port of 1024 and a destination port of 12223.
Layer 3 LWAPP is a UDP/IP Frame that requires a Cisco Aironet AP to obtain an IP address using DHCP.
Data traffic is encapsulated in UDP packets with a source port of 1024 and a destination port of 12223.
Control traffic is encapsulated in TCP packets with a source port of 1024 and a destination port of 12223.
Data traffic is encapsulated in TCP packets with a source port of 1024 and a destination port of 12223.
第10题:
Packets are distributed across the ports in the channel based on both the source and destination MAC addresses.
Packets are distributed across the ports in the channel based on both the source and destination IP addresses.
Packets are balanced across the ports in the channel based first on the source MAC address, then on the destination MAC address, then on the IP address.
Packets are distributed across the access ports in the channel based first on the source IP address and then the destination IP addresses.
第11题:
it is not a valid NetFlow command
it is an SNMP command that exports 1500-byte packets to IP address 192.168.1.50
it is a NetFlov/ command that v/ill export 1500-byte packets to IP address 192.168.1.50
it is a NetFlov/ command that allows IP address 192.168.1.50 to send traffic to port 1500
It is a NetFlov/ command that v/ill specify that the NetFlov/ collector’s IP address is192.168.1.50 over UDP port 1500
It is an SNMP command that exports flows to destination address 1Q2.168.1.50 for packets upto an MTU of 1500
第12题:
Log packets.
Set packet metrics.
Count packets.
Decrement packet's TTL value.
第13题:
A.permit all packets matching the first three octets of the source address to all destinations
B.permit all packets matching the last octet of the destination address and accept all source addresses
C.permit all packets from the third subnet of the network address to all destinations
D.permit all packets matching the host bits in the source address to all destinations
E.permit all packets to destinations matching the first three octets in the destination address
第14题:
What is the result of entering the command port-channel load-balance src-dst-ip on an EtherChannel link? ()
第15题:
What is the result of issuing the frame-relay map ip 192.168.1.2 202 broadcast command?()
第16题:
Which of the following best describes the following command: ip flow-export destination192.168.1.50 1500?()
第17题:
Firewall filters can be used to accept, discard, or reject packets based on ()
第18题:
When an SRX series device receives an ESP packet, what happens?()
第19题:
Protocol and IP source only
IP Source, IP Destination and ports
IP Source Only
IP Destination Only
第20题:
protocol
VLAN number
TCP or UDP port numbers
source switch port number
source IP address and destination IP address
source MAC address and destination MAC address
第21题:
protocol type
MAC address
TCP or UDP port
source and destination IP address
第22题:
Firewall filters are stateless.
Firewall filters are used to control routing information that is exchanged between devices.
Firewall filters are used to control traffic passing through the device.
Firewall filters can only be applied to traffic entering the device.
第23题:
DAI intercept all ARP packets on untrusted ports
DAI determines the validity of an ARP packet based on the valid MAC address-to-IP address bindings stored in the DHCP Snooping database.
DAI is used to prevent against a DHCP Snooping attack.
DAI forwards all ARP packets received on a trusted interface without any checks.
DAI forwards all ARP packets on untrusted ports.
DAI determines the validity of an ARP packet based on the valid MAC address-to-IP address bindings stored in the CAM table.
第24题:
Log packet.
Count packet.
Set packet metric.
Decrement packet TTL.
Change destination IP address.