policies
route origins
route targets
route distinguishers
第1题:
A. Do not use or internally advertise a route until the route is lear ned from a source other than BGP.
B. Do not use or advertise a route until the route is learned from a BGP peer.
C. Do not use or advertise routes marked PARTIAL.
D. Wait until a CONFIRM message is received before using routes from BGP neighbors.
第2题:
A router learns about a remote network from EIGRP, OSPF, and a static route. Assuming all routing protocols are using their default administrative distance, which route will the router use to forward data to the remote network()。
A.The router will use the static route.
B.The router will use the OSPF route.
C.The router will use the EIGRP route.
D.The router will load balance and use all three routes.
第3题:
Which of the following commands would you use, to configure a default route to any destination NOT found in the routing table?()
第4题:
Which two commands would you use to view OSPF routes?()
第5题:
Which three attributes are advertised to the remote PE and BGP-based VPNs?()
第6题:
Which interface tunnel parameter allows an LSP to use a specified explicit route?()
第7题:
Which two mechanisms control route distribution between PE routers in a 2547bis VPN?()
第8题:
It is used to determine which route should become active.
It is used to select which routing table to use for forwarding.
It is used to determine what routes to accept into the routing table.
It is used to select the best route between multiple equal cost paths.
第9题:
The router will use the static route.
The router will use the OSPF route.
The router will use the EIGRP route.
The router will load balance and use all three routes.
第10题:
ip route 172.16.1.0 255.255.255.0 0.0.0.0
ip route 172.16.1.0 255.255.255.0 172.16.2.1
ip route 0.0.0.0 255.255.255.0 172.16.2.1
ip route 0.0.0.0 0.0.0.0 172.16.2.1
第11题:
Router(config)# ip default-route 0.0.0.0 255.255.255.255 s0
Router(config)# ip route 0.0.0.0 255.255.255.255 s0
Router(config)# ip default-route 0.0.0.0 0.0.0.0 s0
Router(config)# ip route 0.0.0.0 0.0.0.0 s0
Router(config)# ip route any any e0
第12题:
Traffic matching the default route will use 10.1.1.1 as the next hop.
Traffic matching the default route will use 10.1.1.254 as the next hop.
Traffic matching the default route will be load-balanced per packet across both next hops.
Traffic matching the default route will be load-balanced per flow across both next hops.
第13题:
A router leams about a remote network from EIGRP.OSPF. and a static route. Assuming all routing protocols are using their default administrative distance, which route will the router use to forward data to the remote network?()
A. The router will use the static route.
B. The router will use the OSPF route.
C. The route will use the EIGRP route.
D. The router will load balance and use all three routes.
第14题:
A router learns about a remote network from EIGRP, OSPF, and a static route. Assuming all routing protocols are using their default administrative distance, which route will the router use to forward data to the remote network()。
第15题:
Which of the following commands should be used to make permanent static route entries that will persist across reboots?()
第16题:
Which mechanism accommodates the use of overlapping addresses in 2547bis VPNs?()
第17题:
A network is composed of several VRFs. It is required that VRF users VRF_A and VRF_B be able to route to and from VRF_C,which hosts shared services. However,traffic must not be allowed to flow between VRF_A and VRF_B. How can this be accomplished?()
第18题:
What is the role of route preference?()
第19题:
Which attribute allows a VRF to accept VPN routes from another VRF?()
第20题:
Avoid interface bandwidth saturation.
Drop BGP routes when the routing-table becomes full.
Remove unnecessary route attributes when not in use.
Limit the effects of a flaping interface on route removal and readvertisement.
第21题:
The router will use the static route.
The router will use the OSPF route.
The route will use the EIGRP route.
The router will load balance and use all three routes.
第22题:
Do not use or internally advertise a route until the route is lear ned from a source other than BGP.
Do not use or advertise a route until the route is learned from a BGP peer.
Do not use or advertise routes marked PARTIAL.
Wait until a CONFIRM message is received before using routes from BGP neighbors.
第23题:
path-option
route-option
explicit-path-option
explicit-route-option