10.20.14.130
10.18.1.1
10.20.14.131
10.20.106.10
第1题:
A.No dynamic interior routing protocol can summarize as shown
B.Unless configured otherwise, EIGRP would automatically summa rize the prefixes as shown in the exhibit
C.With this IP addressing scheme, EIGRP can be manually configured to summarize prefixes at the specified summarization points
D.The IP address design lends itself to OSPF Each summarizing router would be an ABR, summarizing to the next area in the address hierarchy
第2题:
A. defines the source IP address that i s used in all broadcast packets on DLCI 202
B. defines the DLCI that is used for all packets that are sent to the 192.168.1.2 IP address
C. defines the destination IP address that is used in all broadcast packets on DLCI 202
D. defines the DLCI on which packets from the 192.168.1.2 IP address are received
第3题:
A.the IP address of Switch 1
B.the MAC address of Switch 1
C.the IP address of Host C
D.the MAC address of Host C
E.the IP address of the router‘s E0 interface
F.the MAC address of the router‘s E0 interface
第4题:
Your boss is learning a CCNA training course,refer to the exhibit.The access list has been configured on the S0/0 interface of router RTB in the outbound direction.Which two packets,if routed to the interface,will be denied?()access-list 101 denytcp192.168.15.320.0.0.15any eq telnetaccess-list 101 permitip any any
A.source ip address:192.168.15.5;destination port: 21
B.source ip address:,192.168.15.37 destination port: 21
C.source ip address:,192.168.15.41 destination port: 21
D.source ip address:,192.168.15.36 destination port: 23
E.source ip address:192.168.15.46;destination port: 23
F.source ip address:,192.168.15.49 destination port: 23
第5题:
Which of the following descriptions about IP spoofing is correct?()
第6题:
What is the purpose of a network mask?()
第7题:
Which destination addresses will be used by Host A to send data to Host C?()
第8题:
You are creating a destination NAT rule-set. Which two are valid for use with the from clause?()
第9题:
defines the source IP address that is used in all broadcast packets on DLCI 202
defines the DLCI that is used for all packets that are sent to the 192.168.1.2 IP address
defines the destination IP address that is used in all broadcast packets on DLCI 202
defines the DLCI on which packets from the 192.168.1.2 IP address are received
第10题:
It is used to identify the maximum hop count of a subnetwork
It is used to identify an IP address as either private or public
It is used to identify the network to which an IP address belongs
It is used to identify the total number of bits present in an IP address
第11题:
If the destination address of the outer IP header of the ESP packet matches the IP address of the ingress interface, it will
If the destination IP address in the outer IP header of ESP does not match the IP address of the ingress interface, it will
If the destination address of the outer IP header of the ESP packet matches the IP address of the ingress interface, based packet.
If the destination address of the outer IP header of the ESP packet matches the IP address of the ingress interface, based of inner header, it will decrypt the packet.
第12题:
77.0.5.5
40.40.0.254
66.40.90.121
72.40.91.1
第13题:
A. source port
B. output interface
C. next-hop IP address
D. source MAC address
E. destination IP address
F. next-hop MAC address
第14题:
A.The address is removed from the pool until the conflict is resolved.
B.The address remains in the pool until the conflict is resolved.
C.Only the IP detected by Gratuitous ARP is removed from the pool.
D.Only the IP detected by Ping is removed from the pool.
E.The IP will be shown, even after the conflict is resolved.
第15题:
A.Router1 will strip off the source MAC address and replace it with the MAC address 0000.0c36.6965.
B.Router1 will strip off the source IP address and replace it with the IP address 192.168.40.1.
C.Router1 will strip off the destination MAC address and replace it with the MAC address 0000.0c07.4320.
D. Router1 will strip off the destination IP address and replace it with the IP address of 192.168.40.1.
E.Router1 will forward the data packet out interface FastEthernet0/1.
F.Router1 will forward the data packet out interface FastEthernet0/2.
第16题:
第17题:
Which two of these key fields are used to identify a flow in a traditional NetFlow implementation?()
第18题:
What is the result of issuing the frame-relay map ip 192.168.1.2 202 broadcast command?()
第19题:
Given a new implementation, which of the following procedures should be used to determine a default gateway’s IP address?()
第20题:
When an SRX series device receives an ESP packet, what happens?()
第21题:
defines the source IP address that i s used in all broadcast packets on DLCI 202
defines the DLCI that is used for all packets that are sent to the 192.168.1.2 IP address
defines the destination IP address that is used in all broadcast packets on DLCI 202
defines the DLCI on which packets from the 192.168.1.2 IP address are received
第22题:
10.20.106.10
10.20.14.131
10.18.1.1
10.20.14.130
第23题:
The address is removed from the pool until the conflict is resolved.
The address remains in the pool until the conflict is resolved.
Only the IP detected by Gratuitous ARP is removed from the pool.
Only the IP detected by Ping is removed from the pool.
The IP will be shown, even after the conflict is resolved.