Log packet.
Count packet.
Set packet metric.
Decrement packet TTL.
Change destination IP address.
第1题:
A. Set the next hop.
B. Discard packets.
C. Set loss priority.
D. Sample packet content.
第2题:
●We have already covered the topic of network addresses. The first(71) in a block (in classes A,B,and C) defines the network address. In classes A,B,and C,if the hostid is all ls, the address is called a direct broadcast address. It is used by a (72) to send a packet to all hosts in a specific network. All hosts will accept a packet having this type of destination address. Note that this address can be used only as a (73)address in an lP packet. Note also that this special address also reduces the number of available hostid for each netid in classes A,B,and C.
In classes A,B,and C,an address with all Is for the netid and hostid (32 bits) defines a( 74) address in the current network.A host that wants to send a message to every other host can use this address as a destination address in an IP packet. However,a router will block a packet having this type ofaddress to confine the broadcasting to the (75) network. Note that this address belongs to class E.
(71) A.datagram
B.function
C.address
D.service
(72) A.router
B.switch
C.hub
D.firewall
(73)A.source
B.destination
C.local
D.remote
(74) A.unicast
B.multicast
C.broadcast
D.anycast
(75) A.neighbor
B.next
C.remote
D.local
第3题:
If an edge Label Switch Router (LSR) is properly configured,which three combinations are possible?()
第4题:
Which two statements are true when source/destination filters are enabled? ()(Choose two.)
第5题:
A stateless firewall requires a technician to:()
第6题:
In JUNOS Software, which three packet elements can be inspected to determine if asession already exists?()
第7题:
Firewall filters can perform which two actions?()
第8题:
When an SRX series device receives an ESP packet, what happens?()
第9题:
reset the connection
forward the packet
check the packet against an ACL
drop the packet
第10题:
Set the next hop.
Discard packets.
Set loss priority.
Sample packet content.
第11题:
permit
accept
deny
discard
第12题:
Log packets.
Set packet metrics.
Count packets.
Decrement packet's TTL value.
第13题:
A. permit
B. accept
C. deny
D. discard
第14题:
第15题:
What are two possible actions an IOS IPS can take if a packet in a session matches a signature?()
第16题:
Which two firewall filter actions will terminate the processing and evaluation of a packet?()
第17题:
Which two packet attributes contribute to the identification of a session? ()(Choose two.)
第18题:
Firewall filter policers can perform which two actions?()
第19题:
Firewall filters can perform which two actions?()
第20题:
IP protocol
IP time-to-live
source and destination IP address
source and destination MAC address
source and destination TCP/UDP port
第21题:
protocol type
MAC address
TCP or UDP port
source and destination IP address
第22题:
Excluded traffic is not accelerated.
Excluded traffic is only compressed.
Source/destination filter applies to all traffic sent from LAN to WAN.
Source/destination filters work in packet interception mode using RIPv2.
第23题:
A received IP packet is forwarded based on the IP destination address and the packet is sent as an IP packet.
An IP destination exists in the IP forwarding table. A received labeled packet is dropped because the label is not found in the LFIB table.
There is an MPLS label-switched path toward the destination. A received IP packet is dropped because the destination is not found in the IP forwarding table.
A received IP packet is forwarded based on the IP destination address and the packet is sent as a labeled packet.
A received labeled IP packet is forwarded based upon both the label and the IP address.
A received labeled packet is forwarded based on the label. After the label is swapped,the newly labeled packet is sent.
第24题:
Log packet.
Count packet.
Set packet metric.
Decrement packet TTL.
Change destination IP address.