单选题In a JSRP cluster with two J6350 routers, the interface ge-7/0/0 belongs to which device? （）A This interface is a system-created interface.B This interface belongs to NODE0 of the cluster.C This interface belongs to NODE1 of the cluster.D This interfac

第1题：

第2题：

第3题：

Which two of these are characteristics of an IDS sensor？（）

• A、passively listens to network traffic
• B、is an active device in the traffic path
• C、has a permissive interface that is used to monitor networks
• D、traffic arrives on one IDS interface and exits on another
• E、has a promiscuous interface that is used to monitor the network

第4题：

CIS .com recently acquired a smaller competitor. The acquired company is not currently using Cisco routers, so you have connected the two WANs via an authenticated PPP link. After configuration both routers, issuing the show interface s0/0 command on the Cisco Router shows the interface to be in the up/down state. Which two of these are possible causes? （）

• A、Bandwidth statements do not match
• B、MTUs do not match
• C、IP Addresses are not in the same subnet
• D、CHAP passwords do not match

第5题：

The en0 interface on Node1 of a two-node cluster has failed. This adapter is configured with a boot addressand under stable operations also has the service address of the cluster’s single resource group. The resourcegroup is configured with the fallback option. The HA network was configured for IPAT via aliasing and now theservice address is on the en1 interface in the cluster. The en0 interface has already been physically replacedand configured with the boot address. Which of the following will return the cluster to its original state andminimize cluster downtime？（）

• A、Run cluster synchronization.
• B、Restart cluster services on Node1.
• C、Perform a swap_adapter using C-SPOC
• D、Restart cluster services on both nodes

第6题：

Overlay Transport Virtualization （OTV） overlay interface is a logical multiaccess and multicast- capable interface that must be explicitly defined by the user and where the entire OTV configuration is applied. Which statements are true about OTV overlay interface？（）

• A、 When an OTV edge device receives a Layer 2 frame destined for a remote data center site， the frame is logically forwarded to the overlay interface.
• B、 The OTV edge device performs the dynamic OTV encapsulation on the Layer 2 packet and sends it to the join interface toward the routed domain.
• C、 When the OTV edge device receives a Layer 2 frame destined for a remote data center site， the frame is logically forwarded to the join interface.
• D、 The OTV edge device performs the dynamic OTV encapsulation on the Layer 2 packet and sends it to the overlay interface toward the routed domain.

第7题：

In a chassis cluster with two SRX 5800 devices, the interface ge-13/0/0 belongs to which device?（）

• A、This interface is a system-created interface.
• B、This interface belongs to node 0 of the cluster.
• C、This interface belongs to node 1 of the cluster.
• D、This interface will not exist because SRX 5800 devices have only 12 slots.

第8题：

You are at the top of the hierarchy and must configure OSPF on interface so-0/0/0 unit 100. Which two achieve this result?（）

• A、set protocols   setospf area 0   set interface so-0/0/0.100
• B、set protocols ospf area 0 interface so-0/0/0.100
• C、edit protocols ospf interface so-0/0/0.100
• D、edit protocols ospf area 0   set interface so-0/0/0.100

第9题：

第10题：

第11题：

第12题：

第13题：

第14题：

Which two of these are characteristics of an IPS device？（）

• A、 passively listens to network traffic
• B、 is an active device in the traffic path
• C、 has a permissive interface that is used to monitor networks
• D、 traffic arrives on one IPS interface and exits on another

第15题：

Refer to the exhibit. Which two statements are true about the partial configuration that is shown？（）

• A、Hosts connected to the FastEthernet0/1 interface will not receive DHCP replies from the router
• B、The first DHCP client to connect to the FastEthernet 0/1 interface will receive the IP address10.10.0.1
• C、The first DHCP client to connect to the FastEthernet 0/0 interface will receive the IP address10.0.0.1
• D、DHCP requests received on the FastEthernet 0/1 interface will be forwarded to 10.0.0.2
• E、The first DHCP client to connect to the FastEthernet 0/0 interface will receive the IP address10.0.0.6

第16题：

You are the top of hierarchy and must configure OSPF on inteface so-0/0/0 unit 100. Which two achieve this result?（）

• A、set protocols   set ospf area 0   set interface so-0/0/0.100
• B、set protocols ospf area 0 interface so-0/0/0.100
• C、edit protocols ospf interface so-0/0/0.100
• D、edit protocols ospf area 0   set interface so-0/0/0.100

第17题：

Your network administrator has asked you to view the real-time interface usage on ge-0/0/0, Which command whould be used?（）

• A、monitor interface ge0/0/0
• B、traceoptions interface ge-0/0/0
• C、debug interface ge0/0/0
• D、monitor usage ge-0/0/0

第18题：

A Host connected to an NPV switch is not able to see the storage connected to the core switch. Given the output of the show command below， what is the reason of this issue？（） switch# show npv status  npiv is enabled  External Interfaces：   ===============  InterfacE. fc1/1， VSAN： 1， FCID. 0x000000， StatE. Other   Number of External Interfaces： 4 

• A、 NPV is not enabled on the core switch？
• B、 The interface connected to the Core switch is in admin down state
• C、 The local host interface belongs to the wrong VSAN？
• D、 The local host interface is not able to login

第19题：

In a JSRP cluster with two J6350 routers, the interface ge-7/0/0 belongs to which device? （）

• A、This interface is a system-created interface.
• B、This interface belongs to NODE0 of the cluster.
• C、This interface belongs to NODE1 of the cluster.
• D、This interface will not exist because J6350 routers have only six slots.

第20题：

第21题：

第22题：

第23题：

第24题：