Deploy all three groups with a QoS service policy, choosing the parameters for Traffic Shaping based on the average uplink speed across the three groups.
Teleworkers in Groups A and B should inquire with their DSL providers for subscriptions with higher uplink bandwidths.
Teleworkers in Group C should change their subscriptions to DSL for deployment consistency.
Teleworkers in Group A should upgrade their subscription to obtain static IP addresses
Teleworkers in Group A should inquire with their DSL providers for subscriptions with higher downlink bandwidths.
第1题:

A. show ip route
B. show policy - map
C. show access - lists
D. show route - map
第2题:

A. 10.10.10.16/28 only
B. 10.10.10.16/28 and 10.10.10.64/26
C. 10.10.10.16/28, 10.10.10 .64/26, and 172.16.10.0/24
D. 10.10.10.64/26 only
第3题:

A. R3 is an ABR.
B. R3 is not connec ted to the backbone.
C. R3 has four neighbors.
D. R3 is the DR for area 2.
第4题:

A.10.0.0.0/21
B.10.0.0.0/22
C.10.0.0.0/23
D.10.0.0.0/24
第5题:

A.10.0.0.0
B.10.0.0.254
C.192.223.129.0
D.192.223.129.254
第6题:
The customer is considering an IBM System Storage DS8000. Which of the following indicates a requirement for the Business Partner to perform a TDA?()
第7题:
A customer indicates that a system is experiencing printing problems. After checking the system, and successfully printing, no problem has been found. Which of the following procedures should be performed next to further clarify the problem?()
第8题:
It indicates that the radio of the client adapter is disabled
It indicates that the client adapter is not associated to an access point or another client
It indicates that the client adapter is associated to an access point or another client, but the user is not EAP authenticated
It indicates that the client adapter is associated to an access point or another client, that the user is authenticated if the client adapter is configured for EAP authentication, and that the signal strength is excellent or good
It indicates that the client adapter is associated to an access point or another client, that the user is authenticated if the client adapter is configured for EAP authentication, and that the signal strength is fair
It indicates that the client adapter is associated to an access point or another client, that the user is authenticated if the client adapter is configured for EAP authentication, and that the signal strength is poor
第9题:
enabling modular QoS over Frame Relay
enabling Real-Time Transport Protocol (RTP) header compression
enabling distributed compressed Transmission Control Protocol
enabling latency and jitter reduction for Transmission Control traffic
enabling TCP header compression
第10题:
capacity above 500 TB
first in customer location
a new model has been released
sold without implementation service
第11题:
Switch1
Switch2
Switch3
Switch4
第12题:
software voice applications
multipoint control unit (MCU)
gatekeeper
call agent
interactive voice response (IVR) systems
softphones
第13题:

A. 10.10.10.16/28 only
B. 10.10.10.16/28 and 10.10.10.64/26
C. 10.10.10.16/28, 10.10.10.64/26, and 172.16.10.0/24
D. 10.10.10.64/26 only
第14题:

A. router rip
B. router eigrp 10
C. redistribute eigrp 10
D. redistribute rip
E. default - metric 10000 100 255 1 1500
F. default - metric 5
第15题:

A. the serial 1/1 address
B. the serial 2/0 address
C. a randomly generated internal address
D. the configured router - id address
第16题:

A.255.255.255.0
B.255.255.254.0
C.255.255.252.0
D.255.255.248.0
第17题:
Refer to the exhibit. What are three of the basic components of a VoIP network?()
第18题:
Refer to the exhibit. What is the configuration an example of?()
第19题:
10.1.1.2
10.154.154.1
172.16.5.1
192.168.5.3
第20题:
Deployment of Business Ready Teleworker with VoIP is not recommended.
The customer’s existing PBX must first be replaced with Cisco IP Telephony solution.
Business Ready Teleworker and Cisco IP Telephony can be deployed in parallel to the existing PBX, integrating the two with trunking.
Deployment is recommended only for full-time Teleworkers who have no other corporate phone.
第21题:
It indicates that the radio of the client adapter is disabled.
It indicates that the client adapter is not associated to an access point or another client.
It indicates that the client adapter is associated to an access point or another client, but the user is not EAP authenticated.
It indicates that the client adapter is associated to an access point or another client, that the user is authenticated if the client adapter is configured for EAP authentication, and that the signal strength is excellent or good.
It indicates that the client adapter is associated to an access point or another client, that the user is authenticated if the client adapter is configured for EAP authentication, and that the signal strength is fair.
It indicates that the client adapter is associated to an access point or another client, that the user is authenticated if the client adapter is configured for EAP authentication, and that the signal strength is poor.
第22题:
All six routes will be installed in the routing table
Two routes will be installed in the routing table
Four routes will be installed in the routing table
All the routes were redistributed into BGP from an IGP
All the routes were originated by BGP with the network command
第23题:
Reboot the system.
Check the file system sizes.
Have the customer repeat the task to recreate the problem.
Inform the customer that no problems were found, and to call back if the problem reoccurs.
第24题:
Deploy all three groups with a QoS service policy, choosing the parameters for Traffic Shaping based on the average uplink speed across the three groups.
Teleworkers in Groups A and B should inquire with their DSL providers for subscriptions with higher uplink bandwidths.
Teleworkers in Group C should change their subscriptions to DSL for deployment consistency.
Teleworkers in Group A should upgrade their subscription to obtain static IP addresses
Teleworkers in Group A should inquire with their DSL providers for subscriptions with higher downlink bandwidths.