A failed RAID controller
Two failed processors
Two failed sticks of memory
Two failed drives
第1题:
An administrator has set up three partitions using a shared processor pool with 2 processors and SMT turned on. The partitions are activated in the following sequence: Partition one: Min = 0.5, max = 3.0, desired = 1.0; Partition two: Min = 1.0, max = 3.0, desired = 1.5 Partition three: Min = 1, max = 0.5, desired = 2. What is the outcome?()
第2题:
A Windows server has rebooted by itself several times.There are several functioning non-Windows servers in the same rack that are connected to the same uninterruptible power supply(UPS).Which of the following is the MOST likely cause of the reboots?()
第3题:
Which of the following factors is the MOST important to consider when choosing an uninterruptible power supply (UPS) for a single server? ()
第4题:
A file server is setup in a RAID 5 configuration.Recently there was a power failure in the server room while a user was transferring a document from one drive on the server to another drive on the same server.Unfortunately their UPS was in repair during this outage, and the file is now corrupt.Which of the following can be done to prevent this situation in the future?()
第5题:
Which of the following can occur if the maximum rated load is exceeded on an uninterruptible power supply (UPS)?()
第6题:
A database administrator wants to design a multi-partition database that can take advantage of both intra-partition parallelism and inter-partition parallelism. Which configuration will allow the use of these types of parallelism while using the least number of hardware components (servers, processors)? ()
第7题:
The backplane has failed and needs to be replaced.
The array must be disbanded and recreated from a backup source to recognize the replacement drive.
There is a conflict with the optical drive on the server.
The server power supply is failing and not providing enough power for all the drives.
第8题:
Install a generator onsite.
Install a remote management card in the server.
Install an uninterruptible power supply (UPS) onsite.
Move the server to the main office.
第9题:
A failed RAID controller
Two failed processors
Two failed sticks of memory
Two failed drives
第10题:
The UPS is malfunctioning.
The user traffic to the server is too high.
A BSOD is occurring.
The non-Windows servers cannot be located on the same UPS as the Windows server.
第11题:
UPS form factor
Server form factor
Server power supplys wattage rating
Desired runtime
第12题:
There is a fire hazard potential if a power outage occurs.
The last system plugged into the UPS will not be provided any power.
The UPS will draw more power from the circuit to compensate.
The runtime of the UPS will be insufficient if a power outage occurs.
第13题:
A server has a single failed hard drive in an array that is accessed through a hot plug backplane to ease replacement of failed drives. After replacing the drive several times, each of the replacement drives failed to power up and rebuild as the failed drive. Which of the following is the MOST likely cause of the failures?()
第14题:
An administrator will replace five current servers. Which of the following is the MOST important to review before installing new servers?()
第15题:
There is a power outage and all servers are shut down properly by the uninterruptible power supply(UPS) software. When one of the servers starts up it displays a logical drive failed error. This server has two processors,16GB of memory, and a RAID 5 array with 10 drives. Which of the following is the MOST likely cause?()
第16题:
A datacenter has exceeded the load on the central uninterruptible power supply (UPS) for the roomand is causing power load problems. Additional power is available, but not using the central UPS. Which of the following is the BEST temporary solution for adding new servers until an upgrade of the central UPS can occur?()
第17题:
A technician is responsible for overseeing twelve remote offices. There was a report of a power outage at one of the remote offices the night before, and now one of the servers there has not rebootedeven though it was shut down gracefully. The technician was forced to travel two hours just to turn theserver on. Which of the following is the MOST cost effective way to prevent future travel?()
第18题:
Partition one starts and has 3.0 logical processors. Partition two does not start. Partition three has 1.0 logical processors.
Partition one starts and has 1.5 logical processors. Partition two has 1.0 logical processors. Partition three has 0.1 processors.
Partition one starts and has 2.0 logical processors. Partition two start and has 2.0 logical processors. Partition three does not start.
Partition one starts and has 2.0 logical processors. Partition two has 1.0 logical processors. Partition three has 0.1 logical processors.
第19题:
Continue plugging into the central UPS, but put the UPS on bypass to avoid load problems.
Plug the servers directly into the power that is not on the UPS.
Add stand alone UPSs for new servers not wired off the central UPS.
Continue plugging into the central UPS because the actual load supported is actually higher than stated
第20题:
Verify uninterruptible power supply (UPS) load
Verify if server consumes 220V
Verify CPU load
Verify if server consumes 110V
第21题:
Verify uninterruptible power supply (UPS) load
Verify if server consumes 220V
Verify CPU load
Verify if server consumes 110V
第22题:
Increase the memory on the server.
Reconfigure drives to a RAID 0+1.
Install a battery backed write cache module in the system.
Instruct the user to save to the local system instead of to the server.
第23题:
Continue plugging into the central UPS, but put the UPS on bypass to avoid load problems.
Plug the servers directly into the power that is not on the UPS.
Add stand alone UPSs for new servers not wired off the central UPS.
Continue plugging into the central UPS because the actual load supported is actually higher than stated.
第24题:
A failed RAID controller
Two failed processors
Two failed sticks of memory
Two failed drives