255.255.255.0
255.255.255.192
255.255.255.250
255.255.255.252
第1题:
A.The last default - network statement will always be preferred.
B.A route to the 140.140.0.0 network does not exist in the routing table.
C.Default - network selection will always prefer the statement with the lowest IP address.
D.A router will load balance across multiple default - networks; repeatedly issuing the show ip route command would show the gateway of last resort changing between the two networks.
第2题:
In which of the following scenarios would the "show cdp neighbors detail"command be an appropriate troubleshooting tool?()
第3题:
Which of the following protocols enables a group of routers to form a single virtual router, and then use the real IP address of a router as the gateway address, as defined in RFC 2338?()
第4题:
You are a systems administrator and you are about to assign static IP addresses to various servers on your network. For the network 192.168.20.24/29 the router is assigned to the first usable host address, while the last usable host address goes to your Sales server. Which one of the following commands would you enter into the IP properties box of the sales server?()
第5题:
The vPC peer-gateway capability allows a vPC switch to act as the active gateway for packets that are addressed to the router MAC address of the vPC peer. This feature enables local forwarding of such packets without the need to cross the vPC peer link. Which statements are true about the vPC peer-gateway? ()
第6题:
A customer reports they are unable to connect to any computers outside of the office and they are unable to connect to the Internet. When the technician runs ipconfig, the customer gets the following output: IP address169.254.2.4 Subnet Mask.255.255.0.0 Default Gateway. Which of the following could be causing the issue?()
第7题:
Your network contains a computer named Computer1. Computer1 is assigned an IP address of 39 / 84 192.168.1.112/26.Your companys corporate policy states that the first usable address in each subnet is allocated to the default gateway.You need to configure the default gateway for Computer1.Which address should you choose?()
第8题:
The address will always end in 255.
The address will always be the first interface’s IP address
The address will always be the network with a 1 as the final octet.
It is important to consult with the network administrator prior to making assumptions regarding the default gateway’s IP addres
第9题:
IP address:192.168.20.14 Subnet Mask:255.255.255.248 Default Gateway:192.168.20.9
IP address:192.168.20.254 Subnet Mask:255.255.255.0 Default Gateway:192.168.20.1
IP address:192.168.20.30 Subnet Mask:255.255.255.248 Default Gateway:192.168.20.25
IP address:192.168.20.30 Subnet Mask:255.255.255.240 Default Gateway:192.168.20.17
IP address:192.168.20.30 Subnet Mask:255.255.255.240 Default Gateway:192.168.20.25
第10题:
The vPC peer-gateway feature is enabled by default.
The vPC peer-gateway feature can be configured globally under the vPC domain submode.
Enabling the peer-gateway feature automatically disables IP redirects on all interface VLANs mapped over a vPC VLAN to avoid generation of IP redirect messages for packets switched through the peer gateway router.
The vPC peer-gateway feature only works with HSRP protocol.
第11题:
IP address:192.168.20.14 Subnet Mask:255.255.255.248 Default Gateway:192.168.20.9
IP address:192.168.20.254 Subnet Mask:255.255.255.0 Default Gateway:192.168.20.1
IP address:192.168.20.30 Subnet Mask:255.255.255.248 Default Gateway:192.168.20.25
IP address:192.168.20.30 Subnet Mask:255.255.255.240 Default Gateway:192.168.20.17
IP address:192.168.20.30 Subnet Mask:255.255.255.240 Default Gateway:192.168.20.25
第12题:
Proxy ARP
HSRP
IRDP
VRRP
GLBP
第13题:
A.255.255.255.0
B.255.255.255.192
C.255.255.255.250
D.255.255.255.252
第14题:
A network host is configured as follows: Host IP address: 192.168.16.183 Subnet mask: 255.255.255.224 Default gateway: 192.168.16.190 Which of the following statements describe the network to which this host is attached?()
第15题:
Which command will configure a default route on a router?()
第16题:
You need to configure two Company routers for high availability. Which protocol enables a group of routers to form a single virtual router and use the real IP address of a router as the gateway address? ()
第17题:
The router address 192.168.1.250 is the default gateway for both the Web Server 2 and Host 1. What is the correct subnet mask for this network()。
第18题:
Given a new implementation, which of the following procedures should be used to determine a default gateway’s IP address?()
第19题:
Your network contains a server named Server1. Server1 runs Windows Server 2008 R2 and has a single network connection. The connection is configured to use a default gateway address of 10.0.0.1.The default gateway has a metric value of 100.You configure a second default gateway that uses an address of 10.0.0.2.You need to ensure that 10.0.0.2 is only used as the default gateway if 10.0.0.1 is unreachable. What should you do?()
第20题:
ERX ATM IP address
DSL router IP address
DSL bridge IP address
ERX loopback address
第21题:
HSRP
IRDP
Proxy ARP
GLBP
VRRP
None of the other alternatives apply
第22题:
TestKSwitch(config)# ip route-default 192.168.1.115
TestKSwitch(config)# ip default-gateway 192.168.1.115
TestKSwitch(config)# ip route 192.168.1.115 0.0.0.0
TestKSwitch(config)# ip default-network 192.168.1.115
第23题:
255.255.255.0
255.255.255.192
255.255.255.250
255.255.255.252
第24题:
The default gateway is configured on a different subnet form this host.
The host is a member of the fifth usable subnet of the 192.168.16.0 network.
The subnetwork address for this host is 192.168.16.160/28.
The address of the next higher subnet is 192.168.16.192.
The address of the router interface that is attached to this subnetwork is 192.168.16.190.
There are 60 usable host addresses on this subnet.