hydraulic fluid contamination
excessive fluid friction
turbulent fluid flow
fluid pressure surges
第1题:
Among the basic categories of equipment, which of the following is used to convert hydraulic energy into continuous rotary motion?
A.hydraulic pumps
B.valves
C.hydraulic cylinders
D.hydraulic motors
第2题:
Hydraulic machinery failures are commonly caused by contamination of the hydraulic fluid and ______.
A.fluid friction
B.fluid turbulence
C.component misalignment
D.pressure surges
第3题:
第4题:
Are you testing the()(液压舱盖)?
第5题:
lobe type
screw type
axial piston type
volute type
第6题:
air being warmed above the dew point
saturation of cold air by rain
a rapid cooling of the air near the surface of the Earth at night
warm moist air being blown over a colder surface
第7题:
after the point is reached at which the failures begin to increase rapidly
before the point is reached at which the failures begin to increase rapidly
before the point is reached at which the failures begin to increase slowly
after the point is reached at which the failures begin to increase slowly
第8题:
Bulbs
Bulks
Flyweights
Flywheels
第9题:
unusual vibration
excessive worn parts
abnormal pressure
any of the above
第10题:
It produces a warning for new failures before advising for CRITICAL and HIGH failures.
It ignores new failures and considers the failures listed in the last LIST FAILURE command only.
It produces an error with recommendation to run the LIST FAILURE command before the ADVISE FAILURE command.
It produces advice only for new failures and the failures listed in the last LIST FAILURE command are ignored.
第11题:
the temperature of the hydraulic fluid
the flow rate of the hydraulic fluid
the temperature of the cooling water
all of the above
第12题:
inside;associated
inside;not associated
outside;associated
outside;not associated
第13题:
Leakage of hydraulic fluid from around the shaft of a hydraulic motor may be caused by ______.
A.permanent loss of pump suction
B.worn shaft seals
C.high level in the oil sump
D.low motor RPM
第14题:
Advection fog is most commonly caused by ______.
A.air being warmed above the dew point
B.saturation of cold air by rain
C.a rapid cooling of the air near the surface of the Earth at night
D.warm moist air being blown over a colder surface
第15题:
Loop guard and UniDirectional Link Detection both protect against Layer 2 STP loops. In which two ways does loop guard differ from UDLD in loop detection and prevention?()
第16题:
Which two kinds of failures make the Data Recovery Advisor (DRA)generate a manual checklist? ()
第17题:
protect the pump from fine soluble contaminants
prevent solid particles from entering the pump
prevent solid particles from entering the filter
protect the directional control valves
第18题:
Loop guard can be used with root guard simultaneously on the same port on the same VLAN while UDLD cannot
UDLD protects against STP failures caused by cabling problems that create one-way links.
Loop guard detects and protects against duplicate packets being received and transmitted on different ports
UDLD protects against unidirectional cabling problems on copper and fiber media.
Loop guard protects against STP failures caused by problems that result in the loss of BPDUs from a designated switch port.
第19题:
penetration of moisture
accumulation of dirt
overheating
All of the above
第20题:
permanent loss of pump suction
worn shaft seals
high level in the oil sump
low motor RPM
第21题:
the four-way control valve failing to shift
the bleeder valve sticking in the open position
cold hydraulic fluid
a clogged air vent falter on the oil reservoir
第22题:
fluid friction
fluid turbulence
component misalignment
pressure surges
第23题:
steam plants, electric motors and compressed air
diesel engine, hydraulic machinery and compressed air
steam plants, electric motors and hydraulic machinery
diesel engines, steam plants and hydraulic machinery