更多“解释 BATTERY CIRCUIT OPEN FAULT(电池开路•报警)。”相关问题
  • 第1题:

    程序和系统变量存储在主板上的SRAM中,由一节位于主板上的锂电池进行供电以保存数据,当这节电池的电压不足时,会在TP上显示报警(SYST-035 Low or No Battery Power in PSU)。


    正确答案:正确

  • 第2题:

    IOP+、IOP-、OOP是指()。

    • A、输入高限报警、输入低限报警、输入开路报警
    • B、输入高限报警、输入低限报警、输出开路报警
    • C、输出高限报警、输出低限报警、输出开路报警

    正确答案:B

  • 第3题:

    在数铣CRT(液晶屏幕)上显示“BATTERY”,表示()

    • A、系统未准备好
    • B、报警状态
    • C、电池需更换
    • D、编辑状态

    正确答案:C

  • 第4题:

    说明FSC报警点TRANSMIT-FAULT的含义。


    正确答案:变送器报警。

  • 第5题:

    为什么采用集电极开路门(OC-Open-Collecto)要采用上拉电阻?


    正确答案:OC门电路的输出级是一个集电极开路的晶体三极管,如图实线部分所示。三极管T2集电极什么都不接,所以叫做集电极开路(左边的三极管为反相之用,使输入为“0”时,输出也为“0”)。当输入端为“0”时,三极管T1截止(即集电极C跟发射极E之间相当于断开),所以5V电源通过1K电阻加到三极管T2上,三极管T2导通(相当于一个开关闭合);当输入端为“1”时,三极管T1导通,三极管T2截止(相当于开关断开)。很明显,当T2导通时,输出直接接地,所以输出电平为0。而当T2截止时,则输出端悬空了,即高阻态。这时电平状态未知,如果后面一个电阻负载(即使很轻的负载)到地,那么输出端的电平就被这个负载拉到低电平了,所以这个电路是不能输出高电平的。所以组成电路时,OC门输出端必须外加一个接至正电源的上拉电阻(如图虚线所示)才能正常工作。

  • 第6题:

    Battery的中文含义是()。

    • A、蓄电池
    • B、分电器
    • C、发火线圈
    • D、电阻

    正确答案:A

  • 第7题:

    Hall sensor-G40 open/short Circuit to positive的中文含义是()。


    正确答案:霍尔传感器G40对正极开路/短路

  • 第8题:

    battery compatment cap是()。

    • A、敏感性调节按钮
    • B、电池盒盖
    • C、有声报警器
    • D、敏感探测区域

    正确答案:B

  • 第9题:

    蓄电池的开路电压指电池在开路状态下的端电压。铅酸蓄电池的开路电压为()。

    • A、2.1V
    • B、2.16-2.18V
    • C、1.25V
    • D、1.5V

    正确答案:A

  • 第10题:

    单选题
    Which of the following is the BEST case scenario for power fault tolerance within a server?()
    A

     Redundant power supplies with one power supply connected and one power supply as a hot spare.

    B

     Redundant power supplies with each connected to a separate power circuit.

    C

     Redundant power supplies connected via a Y-cable.

    D

     Redundant power supplies with each connected to the same power circuit.


    正确答案: A
    解析: 暂无解析

  • 第11题:

    单选题
    Main engine room control console alarms are to be of the self monitoring type, meaning that an open circuit to a particular alarm circuit will ()
    A

    cause an alarm condition

    B

    secure power to the indicator

    C

    secure power to the monitored device

    D

    automatically recluse within 10 seconds


    正确答案: B
    解析: 暂无解析

  • 第12题:

    名词解释题
    英译汉:battery

    正确答案: 电池
    解析: 暂无解析

  • 第13题:

    电池的开路电压取决于电池的结构和尺寸大小。


    正确答案:错误

  • 第14题:

    解释UPS FAULT(UPS 故障)。


    正确答案:此为UPS之综合性警报,任何一个UPS内部警报都会导致本警报之产生;当此报警出现时,伴随有8位16进制代码,可具体查找到报警的信息。可通过报警复位对其进行恢复。

  • 第15题:

    什么是电池的开路电压?


    正确答案: 电池在开路状态下的端电压称开路电压。

  • 第16题:

    电池的开路电压就是电池的浮充电压。


    正确答案:错误

  • 第17题:

    Which of the following is the BEST case scenario for power fault tolerance within a server?()

    • A、 Redundant power supplies with one power supply connected and one power supply as a hot spare.
    • B、 Redundant power supplies with each connected to a separate power circuit.
    • C、 Redundant power supplies connected via a Y-cable.
    • D、 Redundant power supplies with each connected to the same power circuit.

    正确答案:B

  • 第18题:

    Open in Cylinder Identification Sensor circuit的中文意思是()


    正确答案:判缸传感器开路

  • 第19题:

    Open in TRC brake main relay circuit的中文意思是()。


    正确答案:牵引力控制制动主继电器电路开路

  • 第20题:

    CMOS逻辑门电路中O表示开路(Open)。


    正确答案:错误

  • 第21题:

    单选题
    In a simple series circuit, the entire source voltage will drop across ()
    A

    the resistor next to the negative terminal

    B

    a short circuit

    C

    the resistor next to the positive terminal

    D

    an open circuit


    正确答案: C
    解析: 暂无解析

  • 第22题:

    单选题
    A circuit breaker and a fuse have a basic similarity in that they both ().
    A

    can be reset to energize the circuit

    B

    should open the circuit when overloaded

    C

    will burn out when an over current flow develops

    D

    All of the above


    正确答案: A
    解析: 暂无解析

  • 第23题:

    单选题
    Before any work on electrical or electronic equipment is performed, which of the following precautions should be carried out ()
    A

    De-energize the applicable switchboard bus

    B

    Bypass the interlocks

    C

    Secure and tag the supply circuit breaker in the open position

    D

    Station a man at the circuit supply switch


    正确答案: D
    解析: 暂无解析