Which two statements describe the criteria bandwidth detection uses to dynamically alter bandwidth allocation?()(Choose two.)
第1题:
What is the effect of turning on all available downstream carrier tones in a DMT DSL transmissionsystems?()
第2题:
Which two queuing methods will allow a percentage of the available bandwidth to be allocated to each queue?()
第3题:
In a collapsed core design, which two benefits are provided by a second-generation Cisco MDS director? ()
第4题:
Which two scenarios would benefit the most from TCP Acceleration? ()(Choose two.)
第5题:
SDM creates a low latency queuing (LLQ) service policy with its associated classes. What are the two types of low latency queuing available using the SDM QoS wizard?()
第6题:
Which two of these statements best describe fast secure roaming? (Choose two.)()
第7题:
Which function enforces logical data throughput rates that are below the actual physical line rate of a port?()
第8题:
Throughput is raised as latency decreases.
Throughput is based on available bandwidth.
Throughput is lowered as latency decreases.
Latency is measured by SYNs returned for each metapacket
第9题:
Throughput is raised as latency decreases.
Throughput is based on available bandwidth.
Throughput is lowered as latency decreases.
Latency is measured by SYNs returned for each metapacket.
第10题:
a higher fan-out ratio
fully redundant switches
100 percent port efficiency
all ISLs contained within a single chassis
higher latency and throughput than a core-edge design switch
第11题:
Throughput results are valid as a value from the Teleworker's home to the corporate site, regardless of the location of the public test server.
Throughput results may not be valid due to the public server's location on the Internet and fluctuations based on the use of the public server.
Throughput values are not affected by the choice of split tunneling or Internet access through the VPN.
Throughput results are unrelated to the Teleworker PC configuration or current PC use.
第12题:
first-in, first-out queuing (FIFO)
priority queuing (PQ)
custom queuing (CQ)
weighted fair queuing (WFQ)
class-based WFQ (CBWFQ)
low latency queuing (LLQ)
第13题:
What is the effect of changing DMT interleaved delay from 3 milliseconds to 15 milliseconds?()
第14题:
Which two statements about FCIP and iSCSI are correct?()
第15题:
What happens when you enable QoS bandwidth detection? ()(Choose two.)
第16题:
Which two statements describe the criteria bandwidth detection uses to dynamically alter bandwidth allocation?()(Choose two.)
第17题:
Which factor is least likely to affect the scalability of a VPN design?()
第18题:
What happens when you enable QoS bandwidth detection? ()(Choose two.)
第19题:
Downstream RS error correction effectiveness is reduced
The downstream line rate and throughput remains unchanged, but FEC efficiency is reduced
The upstream DSL bandwidth is reduced, since less carriers become available for upstream traffic
The downstream DSL bandwidth is increased
第20题:
Circuit speed is reduced by 2% for overhead.
WAN speed can be configured to the LAN speed.
Bandwidth is adjusted based on minimum and maximum settings.
WAN bandwidth is detected based on acknowledgement of metapackets.
第21题:
It is compatible with all wireless clients.
It reduces roaming latency through reduced client RF channel scanning enhancements.
It reduces roaming latency to targeted times of less than 75ms.
Roaming occurs without reauthentication through a centralized RADIUS server.
It is enabled through WLSE deployment.
第22题:
Circuit speed is reduced by 2% for overhead.
WAN speed can be configured to the LAN speed.
Bandwidth is adjusted based on minimum and maximum settings
WAN bandwidth is detected based on acknowledgement of metapackets.
第23题:
number of branch offices
number of IGP routing peers
remote Office and home worker throughput bandwidth requirements
high availability requirements
Supported applications