What is true about a Bypass Tunnel in MPLS Fast Reroute?()
第1题:
A. mpls fast reroute
B. mpls fast-reroute
C. enable mpls fast-reroute
D. tunnel mpls fast-reroute
第2题:
Which three statements about the Cisco MPLS TE Fast Reroute (FRR) process are true?()
第3题:
The DAI feature has been implemented in the Company switched LAN. Which three statements are true about the dynamic ARP inspection (DAI) feature? ()
第4题:
With MPLS Fast Reroute, what is the "point of local repair"?()
第5题:
Which two statements about the use of SCREEN options are correct? ()(Choose two.)
第6题:
You need to configure port security on switch R1. Which two statements are true about this technology? ()
第7题:
What is the term "ordered control" mean regarding how MPLS LSPs are established?()
第8题:
Where is the IS-IS Network Entity Title configured?()
第9题:
DAI can be performed on ingress ports only.
DAI can be performed on both ingress and egress ports.
DAI is supported on access ports, trunk ports, EtherChannel ports, and private VLAN ports.
DAI should be enabled on the root switch for particular VLANs only in order to secure the ARP caches of hosts in the domain.
DAI should be configured on all access switch ports as untrusted and on all switch ports connected to other switches as trusted.
DAI is supported on access and trunk ports only.
第10题:
Only configured on the egress router
Only configured on the ingress router
Is pre-signalled to reduce packet loss
Must intersect the primary LSP at two locations
第11题:
It requires a next-hop backup tunnel.
The backup tunnel terminates on the same tail-end router as the primary tunnel.
The point of local repair (PLR) swaps the label and pushes the backup label.
The restoration time is expected to be under 50 ms.
The backup tunnel can have associated bandwidth capacity
第12题:
mpls fast reroute
mpls fast-reroute
enable mpls fast-reroute
tunnel mpls fast-reroute
第13题:
The router SIS-R has been configured in a CIS network. As a network administrator, you were required to enable MPLS on that router.Which of the following description is making sense on the basis of the output information?()
A. CEF switching is only needed to forward labeled packets.
B. CEF switching is needed on both ingress and egress interfaces on which MPLS is enabled.
C. Interface-level CEF switching is needed only on egress interfaces that are sending IP packets on which the egress LSR performs the label imposition process.
D. Interface-level CEF switching is needed only on ingress interfaces that are receiving IP packets on which the ingress LSR performs the label imposition process.
第14题:
What is true about IP Source Guard with port security?()
第15题:
Which CLI command is used to enable MPLS Fast Reroute on a ingress router?()
第16题:
Which statement about MPLS TE Fast Reroute (FRR) link protection operation is not true?()
第17题:
Which statement about MPLS traffic engineering policy-based tunnel selection (PBTS) is not true?()
第18题:
What two statistics appear in show frame-relay map output?()
第19题:
Which two statements are true about L2TP tunnel switching?()
第20题:
Which two statements are true about L2TP tunnel switching?()
第21题:
egress router
ingress router
start of the bypass tunnel
all routers in the bypass tunnel
第22题:
Port security can be configured for ports supporting VoIP.
With port security configured, four MAC addresses are allowed by default.
The network administrator must manually enter the MAC address for each device in order for the switch to allow connectivity.
Withsecurity configured, only one MAC addresses is allowed by default.
Port security cannot be configured for ports supporting VoIP.
第23题:
The tunnel that is not configured with the policy-class command acts as the default
EXP selection is between multiple tunnels to the same destination
There is no requirement for IGP extensions
Tunnels are configured using the policy-class command and carry multiple EXP values
It supports VRF traffic, IP-to-MPLS switching, and MPLS-to-MPLS switching