Which setup procedure begins on the Cisco CRS server immediately after Cisco CRS 4.5 is completely installed?（）A、Cisco Unified CallManager cluster setup  B、SQL 2K server setup  C、Cisco CRS server setup  D、Cisco CRS cluster setup

题目

Which setup procedure begins on the Cisco CRS server immediately after Cisco CRS 4.5 is completely installed?（）

  • A、Cisco Unified CallManager cluster setup  
  • B、SQL 2K server setup  
  • C、Cisco CRS server setup  
  • D、Cisco CRS cluster setup
相似考题

1.An administrator is troubleshooting a communication issue between two computers on the sameLayer 2 switch.Which of the following is the BEST way to determine if the switch is causing the issue?()A. Setup an ACL that allows and logs all IP traffic between the two computersB. Configure a spanning tree to check for a loopC. Setup a span port on the switch to watch for CRC errorsD. Connect both computers using a crossover cable

2.Which statement about the Link Control Protocol （LCP） is true？（）A、LCP is used for basic PPP link setup and operation.B、LCP is used for PPP CHAP authentication.C、LCP is used for PPP over ATM （PPPoA） setup.D、LCP is used for PPP over Ethernet （PPPoE） setup.E、LCP is used for PPP over Frame Relay （PPPoFR） setup

3.Which of the following are functions that are often provided by an ITSP but are not typically  provided by the PSTN？（）A、 QoSB、 call setup and teardownC、 call routingD、 call supervisionE、 audio signal compression

4.You need to perform an automated installation of an Exchange Server 2010 server. Which command should you include in your script（）？A、setup.exeB、setup.comC、msiexec.exeD、lpsetupui.exe

参考答案和解析
正确答案:D
更多“Which setup procedur”相关问题

  • 第1题：

    An administrator is configuring one server to monitor hardware level information on a second Windows server.Which of the following should be setup on the Windows server to allow the monitoring server to access this information?（）

    • A、WMI
    • B、RIS
    • C、DNS
    • D、SNMP
    • E、SMTP

    正确答案:A,D

  • 第2题：

    Which of the following should be done during a Windows server OS installation to install third party drivers for a storage array controller？（）

    • A、 Use recovery console from Windows setup.
    • B、 Have the manufacturer’s driver disk in the floppy drive and Windows will install it automatically.
    • C、 Press F6 when prompted during the setup utility.
    • D、 Run setup using the appropriate installation wizard.

    正确答案:C

  • 第3题：

    Which two commands are used to migrate IBM Tivoli Workload Scheduler  to version 8.5 on a UNIX system？（）

    • A、 launch.sh
    • B、 wdinstspb
    • C、 SETUP.bin
    • D、 twsinst -migrate
    • E、 SETUP.bin -silent

    正确答案:C,E

  • 第4题：

    Which three can be specified within an RSVP session attribute object?（） (Choose three.)

    • A、hold priority
    • B、setup priority
    • C、FEC IP address
    • D、resource availability
    • E、local protection option

    正确答案:A,B,E

  • 第5题：

    The company has a Windows 2008 Active Directory-based network.The network contains an Exchange Server 2003 organization.The management instructs you to deploy Exchange Server 2010 in your network.You decide to prepare the schema and domain first.Which of the following commands should you run prior to performing the normal schema and domain preparation？（）

    • A、Setup /PrepareSchema
    • B、Setup /PrepareLegacyExchangePermissions
    • C、Setup /PrepareAD
    • D、Setup /PrepareLegacyExchangePermissions：child.Xxx

    正确答案:B

  • 第6题：

    单选题
    After upgrading a server motherboard to the latest firmware revision， configuring LAN access in the SSU （System Setup Utility） fails. Which action should be taken FIRST to correct this problem？（）
    A

     replace the NIC

    B

     install the latest SSU （System Setup Utility） version

    C

     upgrade the firmware on the NIC

    D

     assign the NIC a static IRQ in the SSU （System Setup Utility）


    正确答案： C
    解析： 暂无解析

  • 第7题：

    单选题
    Which command is used to initialize and configure a NIM master？（）
    A

    /usr/sbin/nim_init

    B

    /usr/bin/installnim

    C

    /usr/sbin/nimconfig

    D

    /usr/sbin/setup_server


    正确答案： A
    解析： 暂无解析

  • 第8题：

    单选题
    In MPLS traffic engineering， which one of the following protocols is used for Path Setup？（）
    A

    BGP

    B

    OSPF

    C

    ISIS

    D

    RSVP


    正确答案： C
    解析： 暂无解析

  • 第9题：

    单选题
    Which statement is true about the distributed call control in a VoIP network？（）
    A

    the VoIP endpoints have the intelligence to set up and control calls

    B

    Call setup and control functionality is centralized in one call agent or cluster

    C

    Call setup and control resides in call agents that are distributed throughout the network

    D

    Each VoIP device has separate call control， voice packetization， and transport mechanisms


    正确答案： A
    解析： 暂无解析

  • 第10题：

    单选题
    Which setup procedure begins on the Cisco CRS server immediately after Cisco CRS 4.5 is completely installed?（）
    A

    Cisco Unified CallManager cluster setup  

    B

    SQL 2K server setup  

    C

    Cisco CRS server setup  

    D

    Cisco CRS cluster setup


    正确答案： A
    解析： 暂无解析

  • 第11题：

    多选题
    Which three statements about NetFlow are true？ （）
    A

    LCP is used for PPP over ATM （PPPoA） setup.

    B

    LCP is used for PPP over Ethernet （PPPoE） setup.

    C

    LCP is used for PPP over Ethernet （PPPoPR） setup.

    D

    LCP is used for PPP CHAP authentication.

    E

    LCP is used for basic PPP link setup and operation.


    正确答案： D,C
    解析： 暂无解析

  • 第12题：

    After upgrading a server motherboard to the latest firmware revision， configuring LAN access in the SSU （System Setup Utility） fails. Which action should be taken FIRST to correct this problem？（）

    • A、 replace the NIC
    • B、 install the latest SSU （System Setup Utility） version
    • C、 upgrade the firmware on the NIC
    • D、 assign the NIC a static IRQ in the SSU （System Setup Utility）

    正确答案:C

  • 第13题：

    Which command is used to initialize and configure a NIM master？（）

    • A、/usr/sbin/nim_init
    • B、/usr/bin/installnim
    • C、/usr/sbin/nimconfig
    • D、/usr/sbin/setup_server

    正确答案:C

  • 第14题：

    Which command is used to execute a macro called setup.mac ？ （）

    • A、 macro setup
    • B、 macro setup.mac
    • C、 run macro setup
    • D、 run macro setup.mac

    正确答案:B

  • 第15题：

    You work as an Exchange Administrator for TechWorld Inc.The company has a Windows 2008 Active Directory-based contains an Exchange Server 2003 organization.The management instructs you to deploy Exchange Server 2010 ii to prepare the schema and domain first.Which of the following commands should you run prior to performing then preparation？（）

    • A、Setup /PrepareAD
    • B、Setup /PrepareSchema
    • C、Setup/PrepareLegacyExchangePermissions：child.techworld.com
    • D、Setup /PrepareLegacyExchangePermissions

    正确答案:D

  • 第16题：

    单选题
    Which command is used to execute a macro called setup.mac ？ （）
    A

     macro setup

    B

     macro setup.mac

    C

     run macro setup

    D

     run macro setup.mac


    正确答案： A
    解析： 暂无解析

  • 第17题：

    单选题
    Which statement about the Link Control Protocol （LCP） is true？（）
    A

    LCP is used for basic PPP link setup and operation.

    B

    LCP is used for PPP CHAP authentication.

    C

    LCP is used for PPP over ATM （PPPoA） setup.

    D

    LCP is used for PPP over Ethernet （PPPoE） setup.

    E

    LCP is used for PPP over Frame Relay （PPPoFR） setup


    正确答案： A
    解析： 暂无解析

  • 第18题：

    多选题
    An administrator is configuring one server to monitor hardware level information on a second Windows server.Which of the following should be setup on the Windows server to allow the monitoring server to access this information?（）
    A

    WMI

    B

    RIS

    C

    DNS

    D

    SNMP

    E

    SMTP


    正确答案： A,E
    解析： 暂无解析

  • 第19题：

    多选题
    Which of the following are functions that are often provided by an ITSP but are not typically  provided by the PSTN？（）
    A

    QoS

    B

    call setup and teardown

    C

    call routing

    D

    call supervision

    E

    audio signal compression


    正确答案： D,E
    解析： 暂无解析

  • 第20题：

    单选题
    Which of the following should be done during a Windows server OS installation to install third party drivers for a storage array controller？（）
    A

     Use recovery console from Windows setup.

    B

     Have the manufacturer’s driver disk in the floppy drive and Windows will install it automatically.

    C

     Press F6 when prompted during the setup utility.

    D

     Run setup using the appropriate installation wizard.


    正确答案： B
    解析： 暂无解析

  • 第21题：

    单选题
    Which of the following computer types would benefit MOST from the installation of a water cooling setup?（）
    A

    Gaming PC

    B

    Home theater PC

    C

    Thick client

    D

    Thin client


    正确答案： C
    解析： 暂无解析

  • 第22题：

    多选题
    Which three locations in WebView allow you to confirm that the endpoints are configured properly? （）(Choose three.)
    A

    Monitor > Endpoints

    B

    Acceleration > Endpoints

    C

    Device Setup > Endpoints

    D

    Compression > Endpoints

    E

    Admin > Maintenance > Display Configuration


    正确答案： B,A
    解析： 暂无解析

相关内容